Starrchristoffersen3583

Tin sulfide promises very interesting properties such as a high optical absorption coefficient and a small band gap, while being less toxic compared to other metal chalcogenides. However, the limitations in growing atomically thin structures of tin sulfide hinder the experimental exploration of these properties. Due to the flexibility of the colloidal synthesis, it is possible to synthesize very thin and at the same time large nanosheets. Electrical transport measurements show that these nanosheets can function as field-effect transistors with an on/off ratio of more than 105 at low temperatures and p-type behavior. The temperature dependency of the charge transport reveals that defects in the crystal are responsible for the formation of holes as majority carriers. SW033291 During illumination with circularly polarized light, these crystals generate a helicity dependent photocurrent at zero-volt bias, since their symmetry is broken by asymmetric interfaces (substrate and vacuum). Further, the observed circular photogalvanic effect shows a pronounced in-plane anisotropy, with a higher photocurrent along the armchair direction, originating from the higher absorption coefficient in this direction. Our new insights show the potential of tin sulfide for new functionalities in electronics and optoelectronics, for instance as polarization sensors.Four bimetallic phases of the thiophosphate family have been synthesized by the cationic exchange reaction using a freshly prepared K0.5Cd0.75PS3 precursor phase and methanolic solutions of nitrates of the divalent cations ZnII, NiII, CoII, and MnII. All the materials were characterized by FTIR, PXRD, SEM-EDXS and (in the case of the diamagnetic compounds) by solid state NMR. For the K0.5Cd0.75PS3 precursor, the X-ray powder diffraction data suggest a modification of the structure, while solid state NMR results confirm that this phase possesses an ordered arrangement of Cd vacancies. The cationic exchange reaction achieves a complete removal of potassium ions (no potassium detected by SEM-EDXS) and re-occupation of the vacancies by divalent cations. Therefore, the obtained compounds have an average composition of M0.25Cd0.75PS3 (M = ZnII, NiII, CoII, MnII) and possess an ordered distribution of the substituent cations. Even with the paramagnetic substitution level of 25%, antiferromagnetic behaviour is present in the phases with MnII, CoII and NiII, as evidenced by dc susceptibility and in the case of the MnII substituted phase by EPR. The cooperative magnetic interactions confirm the conclusion that the paramagnetic ions adopt an ordered arrangement. The analysis by broad band impedance spectroscopy allows to attribute the conductivity in these materials to charge movements in the layers due to the difference in electronegativity of the metal ions. Zn0.25Cd0.75PS3 is the phase that shows the highest conductivity values. Finally, the band gap energies of the bimetallic phases tend to be lower than those of the single-metal phases, probably due to an overlap of the band structures.Factors that determine magnetophoretic transport of magnetic nanoparticles (MNPs) through hydrated polymer networks under the influence of an external magnetic field gradient were studied. Functionalised iron oxide cores (8.9 nm core diameter) were tracked in real-time as they moved through agarose gels under the influence of an inhomogeneous magnetic field. Terminal magnetophoretic velocities were observed in all cases, these were quantified and found to be highly reproducible and sensitive to the conditions. Increasing agarose content reduced magnetophoretic velocity, we attribute this to increasingly tortuous paths through the porous hydrated polymer network and propose a new factor to quantify the tortuosity. The impact of MNP surface functionalisation, charge, network fixed charge content, and ionic strength of the aqueous phase on velocity were studied to separate these effects. For MNPs functionalised with polyethylene glycol (PEG) increasing chain length reduced velocity but the tortuosity extracted, which is a function of the network, was unchanged; validating the approach. For charged citrate- and arginine-functionalised MNPs, magnetophoretic velocities were found to increase for particles with positive and decrease for particles with negative zeta potential. In both cases these effects could be moderated by reducing the number of agarose anionic residues and/or increasing the ionic strength of the aqueous phase; conditions under which tortuosity again becomes the critical factor. A model for MNP transport identifying the contributions from the tortuous pore network and from electrostatic effects associated with the pore constrictions is proposed.A novel method exploiting the in situ reactivation of a PdNi catalyst to enhance the electro-oxidation of alcohols is reported. The periodic regeneration of the catalyst surface leads to significant gains in terms of conversion rate, energy requirements and stability compared to the conventional potentiostatic method.The performance of solution-processed solar cells strongly depends on the geometrical structure and roughness of the photovoltaic layers formed during film drying. During the drying process, the interplay of crystallization and liquid-liquid demixing leads to structure formation on the nano- and microscale and to the final rough film. In order to better understand how the film structure can be improved by process engineering, we aim at theoretically investigating these systems by means of phase-field simulations. We introduce an evaporation model based on the Cahn-Hilliard equation for the evolution of the fluid concentrations coupled to the Allen-Cahn equation for the liquid-vapour phase transformation. We demonstrate its ability to match the experimentally measured drying kinetics and study the impact of the parameters of our model. Furthermore, the evaporation of solvent blends and solvent-vapour annealing are investigated. The dry film roughness emerges naturally from our set of equations, as illustrated through preliminary simulations of spinodal decomposition and film drying on structured substrates.