Skinnerwillard2371

Next, the sample was divided according to the economic development level. The split sample analysis shows the regional heterogeneity of population factors and energy costs impacts on GHG emissions. Finally, the time-varying coefficient test indicates that during the study period, the negative impact of urbanization has decreased over time, while the positive impact of industrial production on greenhouse gas emissions has increased. We believe this article will contribute to the formulation of environmental policies and provide additional insights for environmentally sustainable development.A linear algebra theorem like Cramer's rule was used for the analysis of a system of equations obtained from UV spectroscopy, and results were compared against those obtained from HPLC analysis. This parametrization allowed to quantify the concentration of the main intermediate products detected along the photodegradation of phenol under UV-Vis irradiation of TiO2. UV spectroscopy data for phenol, hydroquinone, and benzoquinone were analyzed using the Cramer's rule. The overlapping interference of the intermediate products in the UV spectra was corrected. It can be concluded that the Cramer's rule can be used for the parametrization of the UV absorbance data of phenol and its main intermediate products. This methodology permitted to obtain the concentration of phenol and their intermediate products by UV-visible with a high precision in comparison of HPLC. The parametrization showed a correlation coefficient of ca. 0.9775 between the phenol concentration obtained by UV spectroscopy and values obtained from HPLC analysis. In this sense, results can be considered with good precision, and accordingly, it can be concluded that the methodology is reliable, and UV-visible spectroscopy can be selected instead of HPLC in much of the experiments concerning with aqueous-phase reactions.In this work, for the first time, Cordia trichotoma sawdust, a residue derived from noble wood processing, was applied as an alternative biosorbent for the removal of crystal violet by discontinuous and continuous biosorption processes. The optimum conditions for biosorption of crystal violet were 7.5 pH and a biosorbent dosage of 0.8 g L-1. The biosorption kinetics showed that the equilibrium was reached at 120 min, achieving a maximum biosorption capacity of 107 mg g-1 for initial dye concentration of 200 mg L-1. The Elovich model was the proper model for representing the biosorption kinetics. The isotherm assays showed that the rise of temperature causes an increase in the biosorption capacity of the crystal violet, with a maximum biosorption capacity of 129.77 mg g-1 at 328 K. #link# The Langmuir model was the most proper model for describing the behavior. The sign of ΔG0 indicates that the process was spontaneous and favorable, whereas the ΔH0 indicates an endothermic process. The treatment of the colored simulated effluent composed by dyes and salts resulted in 80% of color removal. The application of biosorbent in the fixed-bed system achieved a breakthrough time of 505 min, resulting in 83.35% of color removal. The Thomas and Yoon-Nelson models were able to describe the fixed-bed biosorption behavior. This collection of experimental evidence shows that the Cordia trichotoma sawdust can be applied for the removal of crystal violet and a mixture of other dyes that contain them.Narrow band gap of ferrites makes it a good photocatalyst, and it plays very prominent role in the level of degradation of organic dyes by photocatalysis. In the current study, bismuth ferrite (BFO) nanoparticles were synthesized by auto-combustion technique. The synthesized BFO particles have the average crystallite size of 33 nm and band gap energy of 1.9 eV. As revealed by microscopic images, uniform, distinct, and hexahedral shaped BFO nanoparticles of 42.7 nm are formed. The BFO nanoparticles exhibited visible and solar light-mediated photocatalytic activity in degrading Acid Yellow-17. The optimum pH and catalyst loading were found to be pH 5 and 0.2 g/L respectively. Around complete degradation under solar and 95% degradation under visible light could be achieved within 135 min of irradiation. Around 85% and 83% chemical oxygen demand (COD) removal could also be achieved under solar and visible light respectively. The degradation followed first-order kinetics in terms of COD removal. The BFO nanoparticles are promising as solar light active catalysts for wastewater treatment.Water pollution is a global environmental problem that affects the ecosystem severely. Treatment of oily wastewater and organic pollutants is a major challenge that waits to be solved as soon as possible. Adsorbing is one of the most effective strategies to deal with this problem. Three-dimensional (3D) porous adsorbents made of graphene or graphene-based nanomaterials skeletons had attracted more attention in wastewater treatment because of their large surface area, high porosity, low density, high chemical/thermal stability, and steady mechanical properties, which allow different pollutants to easily access and diffuse into 3D networks of adsorbents. This work presents an extensive summarization of recent progress in the synthesis methodologies and microstructures of 3D graphene foams and 3D graphene-based foams and highlights their adsorption performance for oils and organic solvents. Advantages and disadvantages of various preparation strategies are compared and the corresponded structures of these skeletons are studied in detail. Furthermore, the effects of the structures on oil-adsorption properties are analyzed and some data and parameters of the oil-adsorption properties are listed and studied for easier comparison. At last, the future research directions and technical challenges are prospected, which is hoped that the researchers will be inspired to develop the new graphene-based adsorbents.Recently, an outbreak of a novel human coronavirus which is referred to as severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) (COVID-19) by the World Health Organization (WHO) was identified in Wuhan, China. To help combat the pandemic, a systematic review (SR) was performed to collect all available studies concerning inactivation methods, environmental survival, and control and prevention strategies. A comprehensive literature survey yielded 42 eligible studies which included in the SR. The results confirmed that the WHO recommended two alcohol-based hand rub formulations (ethanol 70-95% and 2-propanol 70-100%) had an efficient virucidal activity in less than 60 s by more and equal 4 log10 (≥ 99.99) approximately and could be used for disinfection in public health and health-care facilities. link2 The findings indicated that SARS-CoV-1 and SARS-CoV-2 can survive under different environmental conditions between 4 and 72 h approximately. The results also demonstrate that temperature and relative humidity are important factors in the survival of SARS-CoV-2. The main strategies recommended by the WHO to avoid contracting SARS-CoV-2 are hand washing several times in the day and maintaining social distancing with others. It is important to note that the more studies require addressing, the more possible airborne transmission due to the survival of SARS-CoV-2 in aerosols for 3 h approximately. We hope that the results of the present SR can help researchers, health decision-makers, policy-makers, and people for understanding and taking the proper behavior to control and prevent further spread of SARS-CoV-2.Biochar has strong potential to improve nitrogen (N) use efficiency in both agricultural and horticultural systems. Biochar is usually co-applied with full rates of fertiliser. However, the extent to which N cycling can be affected after biochar application to meet plant N requirement remains uncertain. This study aimed to explore N cycling up to 2 years after biochar application. We applied pine woodchip biochar at 0, 10 and 30 t ha-1 (B0, B10, B30, respectively) in a macadamia orchard and evaluated the N isotope composition (δ15N) of soil, microbial biomass and macadamia leaves. Soil total N (TN) and inorganic N pools were also measured up to 2 years after biochar application. Biochar did not alter soil TN but soil NO3--N increased at months 12 and 24 after biochar application. Soil NO3--N concentrations were always over ideal levels of 15 μg g-1 in B30 throughout the study. Stepwise regression indicated that foliar δ15N decreases after biochar application were explained by increased NO3--N concentrations in B30. link3 Foliar TN and photosynthesis were not affected by biochar application. The soil in the high rate biochar plots had excess NO3--N concentrations (over 30 μg g-1) from month 20 onwards. Therefore, N fertiliser applications could be adjusted to prevent excessive N inputs and increase farm profitability.To better understand the cardiopulmonary alterations associated with personal exposed PM2.5-bound heavy meals, we conducted a cross-sectional study in 2018 on 54 general residents. For each subject, PM2.5 exposure filter was collected by a low-volume sampler for 24 h; blood and urine samples were collected subsequently. Heavy metals in PM2.5, blood, and urine samples were determined by inductively coupled plasma mass spectrometry method. PM2.5-bound Mn, Cd, Sb, Pb, and Ni levels were 20.5, 9.27, 9.59, 28.3, and 16.9 ng/m3, respectively. The distribution of these metals followed the order Pb (33.47%) > Mn (24.24%) > Ni (19.99%) > Sb (11.34%) > Cd (10.96%). EI1 cell line of heavy meals in PM2.5, blood, and urine differed from each other. PM2.5-bound Cd, Pb levels were positively correlated with blood Cd, Pb levels (r = 0.323, r = 0.334, p less then  0.05), respectively. PM2.5-bound Cd level was significantly higher in smoking group than non-smoking group (28.8 vs. 7.27 ng/m3, p less then  0.01), same as Sb level (12.0 vs. 9.34 ng/m3, p less then  0.01). Cd and Pb exposure might interact with cardiovascular function through autonomic regulation. No significant correlation was observed between metal exposure and pulmonary function. In conclusion, our data suggested that personal exposure to specific PM2.5-bound heavy metals might interact with profound cardiovascular alterations.Heavy metal exposure in humans and animals commonly occurs through the consumption of metal-contaminated drinking water and food. Although many studies have focused on the remediation of metals by purification of water using sorbents, limited therapeutic sorbent strategies have been developed to minimize human and animal exposures to contaminated water and food. To address this need, a medical grade activated carbon (MAC) and an acid processed montmorillonite clay (APM) were characterized for their ability to bind heavy metals and mixtures. Results of screening and adsorption/desorption isotherms showed that binding plots for arsenic, cadmium, and mercury sorption on surfaces of MAC (and lead on APM) fit the Langmuir model. The highest binding percentage, capacity, and affinity were shown in a simulated stomach model, and the lowest percentage desorption ( less then 18%) was shown in a simulated intestine model. The safety and protective ability of MAC and APM were confirmed in a living organism (Hydra vulgaris) where 0.