Schofieldconnolly4029

Consequently, calves from low DCAD dams had to be treated more frequently.This study analysed the effect of three alkalizing soil amendments (limestone, dolomite chalcedonite) on aided phytostabilization with Festuca rubra L. depending on the hexavalent chromium (Cr(VI)) level in contaminated soil. Four different levels of Cr(VI) were added to the soil (0, 50, 100 and 150 mg/kg). The Cr contents in the plant roots and above-ground parts and the soil (total and extracted Cr by 0.01 M CaCl2) were determined with flame atomic absorption spectrometry. The phytotoxicity of the soil was also determined. Soil amended with chalcedonite significantly increased F. rubra biomass. Chalcedonite and limestone favored a considerable accumulation of Cr in the roots. The application of dolomite and limestone to soil contaminated with Cr(VI) contributed to a significant increase in pH values and was found to be the most effective in reducing total Cr and CaCl2-extracted Cr contents from the soil. F. rubra in combination with a chalcedonite amendment appears to be a promising solution for phytostabilization of Cr(VI)-contaminated areas. The use of this model can contribute to reducing human exposure to Cr(VI) and its associated health risks.The rotating backward extrusion (RBE) process, as a new severe plastic deformation (SPD) process, is based on conventional backward extrusion and rotation, which meets the requirement of modern industrial development with its high performance and production efficiency. However, there is little research on the microstructure evolution and texture modification of the RBE process. Thus, in this study, the effect of different rotating revolutions, e.g., n = 5, n = 10, and n = 50, on the microstructure and texture development for the RBE process based on the AZ80 magnesium (Mg) alloy were investigated at 653 K. The results disclose that the rotating revolution is an influencing processing parameter on the deformation of the RBE process. The grain refining ability is enhanced with the increase of the rotating revolutions, and the minimum grain size of the cup bottom, shearing zone, and cup wall can reach to 16.7 μm, 15.6 μm, and 13.0 μm, respectively, under the condition of n = 50. Selleck MNU chemical Furthermore, with the increase in the rotating revolutions, the microstructure of the alloy becomes more uniform and the proportion of dynamic recrystallization (DRX) is also increased. The maximum DRX fractions of the sample for the cup bottom and cup wall are 95.4% and 86.8%, respectively, at n = 50. The DRX mechanism of the RBE process is determined by the continuous DRX and discontinuous DRX. In addition, the texture can be significant weakened during the RBE process, especially at the cup bottom, where the maximum pole intensity can be reduced from 17.6 at n = 10 to 6.5 at n = 50, which can be attributed to the higher proportion of new DRXed grains whose orientations are more random compared with the deformed grains.Feline leukemia virus (FeLV) and feline immunodeficiency virus (FIV), two of the most important pathogens of cats, produce chronic systemic diseases with progressive death of cells involved in the immune response, ultimately leading to death. Immunostimulants is one of the few alternatives to the symptomatic treatment. In this study, 27 naturally FeLV-infected (FeLV+) and 31 naturally FIV-infected (FIV+) cats were administered orally by their owners 60 IU/day of recombinant human interferon alpha (rHuIFN-α) for four months in alternate weeks. Clinical status was evaluated and blood samples collected at four different visits or months (M) pretreatment (M0), mid-treatment (M2), end of treatment (M4), and 4-8 months after end of treatment (M10). Most cats ostensibly improved their clinical status, and many became asymptomatic. rHuIFN-α treatment improved the anemic processes observed at M0 (at least in cats with mild or moderate anemia) and leukocyte counts, including a more favorable CD4+/CD8+ ratio. An increase in the serum gammaglobulin concentration was seen in 80% of the cats. Despite observing an obvious favorable progress in the clinical, biopathological, and CD4+/CD8+ values during treatment, almost invariably all the parameters analyzed worsened after treatment discontinuation (M10), which suggests that the interferon-α protocol should be either extended or include additional cycles for a long-lasting benefit in FeLV+ and FIV+ cats.Human strongyloidiasis is an important soil-transmitted helminthiasis that affects millions worldwide and can develop into fatal systemic strongyloidiasis in immunosuppressed patients. We have developed two new rapid and simple-to-use immunochromatographic test (ICT) kits for rapid serodiagnosis that support stool examination for clinical diagnosis. Strongyloides stercoralis recombinant IgG immunoreactive antigen (GenBank AAB97359.1; rSsIR-based ICT kit) was used for detection of IgG and IgG4 antibodies. The diagnostic efficacy of both kits was evaluated using human serum samples from strongyloidiasis patients, healthy individuals, and those with other parasitosis. At a prevalence of infection of 36.4%, the diagnostic sensitivity, specificity, positive predictive value, negative predictive value, and accuracy of the rSsIR-based IgG ICT kit were 91.7%, 83.8%, 76.4%, 94.6%, and 86.7%, respectively, and those of the rSsIR-based IgG4 ICT kit were 78.3%, 84.8%, 74.6%, 87.3%, and 82.4% respectively. The concordance between the two kits was 89.7%. The recombinant antigen can be produced to an unlimited extent and the kits can be used as point-of-care diagnostic tools and in large-scale surveys in endemic areas throughout tropical regions without necessitating additional facilities or ancillary supplies.Post-mortem characterisation is a pivotal tool to trace back to the origin of structural failures in modern engineering analyses. This work compared both the crack propagation and rupture roughness profiles based on areal parameters for total fracture area. Notched and smooth samples made of weather-resistant structural steel (10HNAP), popular S355J2 structural steel and aluminium alloy AW-2017A under bending, torsion and combined bending-torsion were investigated. After the fatigue tests, fatigue fractures were measured with an optical profilometer, and the relevant surface parameters were critically compared. The results showed a great impact of the loading scenario on both the local profiles and total fracture areas. Both approaches (local and total fracture zones) for specimens with different geometries were investigated. For all specimens, measured texture parameters decreased in the following order total area, rupture area and propagation area.With high fat and protein content, maize germ is easily infected with fungus and mycotoxins during its storage. The qualities and safety of germ and its processing products may be affected by the storage. link2 However, studies on the effect of storage on quality and polluted mycotoxin level of maize germ are limited. In this study, maize germ was stored with different initial moisture contents (5.03, 9.07, 11.82 and 17.97%) or at different relative humidity (75, 85 and 95%) for 30 days. The quality indices of germ (moisture content and crude fat content) and their produced germ oils (color, acid value and peroxide value) as well as the zearalenone (ZEN) and deoxynivalenol (DON) levels of germ, oils and meals were analyzed. link3 Results showed that maize germ with high initial moisture contents (11.82, 17.97%) or kept at high humidity (95%) became badly moldy at the end of storage. Meanwhile, the qualities of these germ and oils showed great changes. However, the ZEN and DON contents of this maize germ, oils and meals stayed at similar levels (p less then 0.05). Therefore, the storage could produce influence on the qualities of germ and oils, but showed limited effect on the DON and ZEN levels of germ and their processing products. According to this study, the storage condition of germ with no more than 9% moisture content and no higher than 75% humidity was recommended. This study would be benefit for the control of germ qualities and safety during its storage.Newcastle disease (ND) is one of the most challenging infectious diseases affecting poultry production in Africa, causing major economic losses. To date, Newcastle disease virus isolates from several African countries have been grouped into class II NDV genotypes I, IV, V, VI, VII, XI, XIII, XIV, XVII, XVIII and XXI. Although ND is endemic in many African countries, information on circulating genotypes is still scarce. In Tanzania, outbreaks with genotypes V and XIII have been reported. In West and Central Africa, genotypes XIV, XVII, and XVIII are the most predominant. To investigate other genotypes circulating in Tanzania and Ghana, we performed molecular genotyping on isolates from Tanzania and Ghana using the MinION, a third-generation portable sequencing device from Oxford Nanopore Technologies. Using the MinION, we successfully sequenced the NDV F gene hypervariable region of 24 isolates from Tanzania and four samples from Ghana. In Tanzania, genotypes V, VII and XIII were detected. All isolates from Ghana belonged to genotype XVIII. The data obtained in this study reflect the genetic diversity of NDV in Africa and highlight the importance of surveillance for monitoring the distribution of NDV genotypes and viral evolution.Theories on the aetiology of depression in humans are intimately linked to animal research on stressor controllability effects. However, explicit translations of established animal designs are lacking. In two consecutive studies, we developed a translational paradigm to study stressor controllability effects in humans. In the first study, we compared three groups of participants, one exposed to escapable stress, one yoked inescapable stress group, and a control group not exposed to stress. Although group differences indicated successful stress induction, the manipulation failed to differentiate groups according to controllability. In the second study, we employed an improved paradigm and contrasted only an escapable stress group to a yoked inescapable stress group. The final design successfully induced differential effects on self-reported perceived control, exhaustion, helplessness, and behavioural indices of adaptation to stress. The latter were examined in a new escape behaviour test which was modelled after the classic shuttle box animal paradigm. Contrary to the learned helplessness literature, exposure to uncontrollable stress led to more activity and exploration; however, these behaviours were ultimately not adaptive. We discuss the results and possible applications in light of the findings on learning and agency beliefs, inter-individual differences, and interventions aimed at improving resilience to stress-induced mental dysfunction.We used the COMPASS forcefield to perform molecular dynamics (MD) simulation of a mixture composed of three alkanes as the lubricant for the thin-film lubrication. The viscosity of the lubrication film in the non-working state, the final film thickness, and density distribution were investigated. The results reveal that the viscosity error among different initial film thicknesses in the non-working state is within 5%, which confirms the applicability of the model and the forcefield. The viscosity decreases oscillating as temperature increases. Whatever the initial film thickness is, the film thickness change rate with respect to pressure load is almost the same. When pressure increases, the density peaks increase. As the initial film thickness increases, the normalized thicknesses of adsorption and ordered layers decrease. In nanoscale, the density predicted by the MD simulation is higher than the prediction of the Tait equation, even if the adsorption layers is excluded.