Ortizbay4925

Binding of Nile Blue (NB) with calf thymus DNA has been studied using molecular modeling, spectroscopic, and thermodynamic techniques. Our study revealed that NB binds to the DNA helix by two types of modes (groove binding and intercalation) simultaneously. The thermodynamic study showed that the overall binding free energy is a combination of several negative and positive free energy changes. The binding was favored by negative enthalpy and positive entropy changes (due to the release of water from the DNA helix). The docking study validated all experimental evidence and showed that NB binds to a DNA minor groove at low concentrations and switches to intercalation mode at higher concentrations.In this work, we report the facile, environmentally friendly, room-temperature (RT) synthesis of porous CuO nanosheets and their application as a photocatalyst to degrade an organic pollutant/food dye using NaBH4 as the reducing agent in an aqueous medium. Ultrahigh-resolution field effect scanning electron microscopy images of CuO displayed a broken nanosheet-like (a length of ∼160 nm, a width of ∼65 nm) morphology, and the lattice strain was estimated to be ∼1.24 × 10-3 using the Williamson-Hall analysis of X-ray diffraction plots. Owing to the strong quantum size confinement effect, CuO nanosheets resulted in an optical energy band gap of ∼1.92 eV, measured using Tauc plots of the ultraviolet-visible (UV-vis) spectrum, resulting in excellent photocatalytic efficiency. The RT synthesized CuO catalyst showed a high Brunauer-Emmet-Teller surface area of 30.88 ± 0.2313 m2/g (a correlation coefficient of 0.99972) with an average Barrett-Joyner-Halenda pore size of ∼20.385 nm. The obtained porous CuO nanosheets exhibited a high crystallinity of 73.5% with a crystallite size of ∼12 nm and was applied as an efficient photocatalyst for degradation of the organic pollutant/food dye, Allura Red AC (AR) dye, as monitored by UV-vis spectrophotometric analysis and evidenced by a color change from red to colorless. From UV-vis spectra, CuO nanosheets exhibited an efficient and ultrafast photocatalytic degradation efficiency of ∼96.99% for the AR dye in an aqueous medium within 6 min at RT. According to the Langmuir-Hinshelwood model, photodegradation reaction kinetics followed a pseudo-first-order reaction with a rate constant of k = 0.524 min-1 and a half-life (t1/2) of 2.5 min for AR dye degradation in the aqueous medium. The CuO nanosheets showed an outstanding recycling ability for AR degradation and would be highly favorable and an efficient catalyst due to the synergistic effect of high adsorption capability and photodegradation of the food dye.The stimulated reservoir volume fracturing development in tight oil reservoirs is characterized by multiscale flow of the reservoir matrix, fracture network, and hydraulic fracture. Therefore, the flow field structure is extremely complex. Multiscale flow characteristics have been revealed through the systematical experiments including the threshold pressure gradient and the stress sensitivity. Based on the theory of elliptical flow, a comprehensive and practical mathematical model of multiregion coupling flow is established to characterize the multiscale flow, and the pressure distribution equation is derived. The calculation method of moving boundary is established to simulate the dynamic supply boundary and the dynamic pressure distribution by using the steady-state sequential replacement method. The characteristics of multiscale flow, multistage development state, and stress sensitivity are considered, especially the different stress sensitivity characteristics in different regions. Finally, the pressure propagation in tight reservoirs is clarified and the influence of matrix permeability, stress sensitivity characteristics, and drawdown pressure on the distance at the dynamic supply boundary are revealed. The research results provide theoretical basis for the development effect evaluation.An alternative to traditional binder-based construction materials using "cold sintering", a hydrothermal mechanism that involves subjecting the sample to simultaneous pressure and comparatively low temperatures, was explored. Ground and precipitate calcium carbonates (GCC and PCC) were used as the primary starting materials. Ordinary portland cement (OPC) and zinc oxide were studied for comparison. Compressive strength tests showed promising results from the OPC mortars with the cement mostly replaced by GCC. Scanning electron microscopy showed sintering of calcium carbonate and zinc oxide with the selection of suitable solutions. Porosity of sintered samples measured by nitrogen adsorption-desorption improved considerably. These data support the feasibility of cold sintering as an alternative method for production of conventional precast construction materials.Nitrogen (NO X ) and sulfur (SO X ) oxides, the major gaseous pollutants emitted from fossil fuel combustion, have significant health and environmental concerns. Environmental regulations limit these pollutant emissions to tolerable levels. Currently, these pollutants are treated by flue gas desulfurization (SO X removal) and selective catalytic reduction (NO X removal) processes. selleck chemicals llc However, these technologies require large footprints, use expensive catalysts, and operate under high working temperatures. A new catalyst is reported herein, based on sulfur-enriched oil emulsified with water, where the active catalytic species are sulfur-based oxides. The catalyst has been developed using O2 as the oxidation reagent in a low-temperature wet scrubber rather than H2O2 or O3 that are presently used. The catalytically oxidized pollutants are converted to produce ammonium fertilizers by NH4OH addition. As a result of treatment with this novel catalyst, we observed reductions in emissions of SO X and NO X of >85% and 23%, respectively. The catalyst production and the wet scrubbing process are discussed in detail.Based on the successful derivation of a hapten, we prepared and optimized a murine monoclonal antibody against imidocarb, with an IC50 of 2.22 ng/mL and a limit of detection (LOD) of 0.45 ng/mL. Cross-experiment results showed that the cross-over rate for 4,4'-dinitrocarbanilide was 18.12%, and the cross-reactivity with other analogues when using the ic ELISA was less than 0.1%. We used the developed ic-ELISA to detect the addition and recovery of imidocarb in milk and beef samples, and values were 86.0-93.5 and 84.5-101.2%, respectively. The preparation of an immunochromatographic test strip based on gold nanoparticles was used for the rapid identification of imidocarb in milk and beef samples. When assessed by the naked eye, the visual LOD for imidocarb in milk and beef samples was 5 and 10 ng/mL, and the cut-off values were 20 and 50 ng/mL, respectively. Because of its high sensitivity, specificity, and simplicity, the test strip can be used for on-site testing and rapid screening of imidocarb in food samples.