Nymandhovmand0672

The component profiles of apricot, grape, and black currant pomace extracts have been analyzed using HPLC coupled to diode-array detection and tandem mass spectrometry (HPLC-DAD-MS). The predominant components in grape, apricot, and black currant pomace extracts were phenolic acids and flavonols. The redox behavior of apricot, black currant, and grape pomace water extracts was evaluated by means of cyclic voltammetry. Also, individual substances mainly present in the extracts were analyzed. The results of electrochemical testing were compared to traditional chemical techniques of potassium ferricyanide reduction (FRAP) and phosphomolybdenum assay, and fair agreement was established. The 2,2-diphenyl-1-picrylhydrazyl (DPPH) radical scavenging assay and 2,2'-azino-bis(3-ethylbenzothiazoline-6-sulphonic acid) (ABTS) radical scavenging assays were applied in order to estimate antioxidant activity. The reducing power of the grape extract was found to be higher than that of the apricot and black currant extracts in both potassium ferricyanide reduction (FRAP) and phosphomolybdenum methods.Because of logistics and cost constraints, monitoring of the compliance to antimalarial chemoprophylaxis by the quantitation of drugs in biological samples is not a simple operation on the field. Indeed, analytical devices are fragile to transport and must be used in a perfectly controlled environment. This is also the case for reagents and supplies, and the waste management is constraining. Thus, samples should be repatriated. They should be frozen after collection and transported with no rupture in the cold chain. This is crucial to generate available and interpretable data but often without any difficulties. Hence, to propose an alternative solution easier to implement, a quantitation method of determining doxycycline in urine has been validated using a volumetric absorptive microsampling (VAMS®) device. As blotting paper, the device is dried after collection and transferred at room temperature, but contrarily to dried spot, the collection volume is perfectly repeatable. Analysis of VAMS® was performed with a high-performance liquid chromatography coupled to a mass spectrometer. The chromatographic separation was achieved on a core-shell C18 column. The mean extraction recovery was 109% (mean RSD, 5.4%, n = 6) for doxycycline and 102% (mean RSD, 7.0%) for the internal standard. No matrix effect has been shown. Within-run as within-day precision and accuracy were, respectively, below 14% and ranged from 96 to 106%. The signal/concentration ratio was studied in the 0.25-50 µg/mL range, and recoveries from back-calculated concentrations were in the 96-105% range (RSD  less then  11.0%). The RSD on slope was 10%. To achieve the validation, this new quantitation method was applied to real samples. In parallel, samples were analyzed directly after a simple dilution. No statistical difference was observed, confirming that the use of VAMS® is an excellent alternative device to monitor the doxycycline compliance.The objective of the present study is to investigate removal of cationic dye, rhodamine B (RhB), in water environment using a high-performance absorbent based on metal oxide nanomaterials toward green chemistry. The adsorption of sodium dodecyl sulfate (SDS) onto synthesized alpha alumina (α-Al2O3) material (M0) at different ionic strengths under low pH was studied to fabricate a new adsorbent as SDS-modified α-Al2O3 material (M1). The RhB removal using M1 was much higher than M0 under the same experimental conditions. The optimal conditions for RhB removal using M1 were found to be contact time 30 min, pH 4, and adsorbent dosage 5 mg/mL. The maximum RhB removal using M1 achieved 100%, and adsorption amount reached 52.0 mg/g. Adsorption isotherms of RhB onto M1 were well fitted by the two-step adsorption model. The electrostatic attraction between positive RhB molecules and negatively charged M1 surface controlled the adsorption that was evaluated by the surface charge change with zeta potential and adsorption isotherms. Very high RhB removal of greater than 98% after four regenerations of M1 and the maximum removal for all actual textile wastewater samples demonstrate that SDS-modified nano α-Al2O3 is a high-performance and reusable material for RhB removal from wastewater.In this work, the polyamide (PA) membrane surface has been modified by coating of nanomaterials including graphene oxide (GO) and titanium dioxide (TiO2) to enhance membrane separation and antifouling properties. The influence of surface modification conditions on membrane characteristics has been investigated and compared with a base membrane. selleck compound Membrane surface properties were determined through scanning electron microscope (SEM) images and Fourier transform infrared-attenuated total reflectance (FTIR-ATR) spectroscopy. Membrane separation performance was determined through the possibility for the removal of methylene blue (MB) in water. Membrane antifouling property was evaluated by the maintained flux ratios (%) after 120 minutes of filtration. The experimental results showed that the appearance of hydrophilic groups after coating of GO and TiO2 nanocomposite materials with or without UV irradiation onto membrane surface made an improvement in the separation property of the coated membranes. The membrane flux increased from 28% to 61%; meanwhile, the antifouling property of the coated membranes was improved clearly, especially for UV-irradiated PA/GO-TiO2 membrane.This work investigated the removal of antibiotic tetracycline (TC) from wastewater using nanocomposite material based on laterite modified with polyanion, polystyrene sulfonate (PSS). The effective factors influenced on the TC removal using nanocomposite PSS-modified laterite (NCPML) were optimized and found to be pH 4, solid-liquid ratio 5 mg/mL, and contact time 180 min. The highest removal of TC reached about 88% under the optimum adsorption conditions. The adsorption isotherm and kinetics of TC adsorption onto NCPML were in good agreement with the Langmuir and pseudo-second-order models, respectively. The characteristics of the NCPML material before and after TC adsorption were examined by zeta (ζ) potential measurements, Brunauer-Emmett-Teller (BET) method, and Fourier transform infrared spectroscopy (FT-IR). The TC adsorption onto NCPML was induced by electrostatic interaction, hydrogen bonding, and diffusion interaction. The TC removal from wastewater was approximately 94% while efficiency still reached 66% after five regenerations.