Northhsu4414

A palladium-catalyzed Barbier allylation/translactonization cascade reaction was established for the rapid construction of β,γ-disubstituted α-exo-methylene-γ-butyrolactone, an important motif in sesquiterpenes. Dimethyl zinc played significant roles in both steps for the umpolung of π-allylpalladium as a nucleophile and promoting a Lewis acid-mediated translactonization. This sequence showed a broad substrate scope and was further harnessed for the synthesis of two paraconic acids as well as the first protecting-group-free total synthesis of two 1,10-seco-guaianolides.This work reports on the development of borate- and methacrylate-polymer-coated zinc oxide nanoparticles (ZnOBM) via a plasma polymerization technique to replace the harmful conventional antiwear additive zinc dialkyl dithiophosphate (ZDDP) in automotive lubricants. Here, the tribochemistry across the interfaces formed between sliding ferrous surfaces and coated and uncoated ZnO nanoparticles is thoroughly studied from the perspective of elucidating the tribofilm formation, wear, and friction performance of a novel ZnOBM-based nanolubricant. Tribological tests conducted under a boundary lubrication regime revealed that oil formulations containing only ZnOBM nanoadditives and a mixture of ZnOBM with a low amount of ZDDP (350 ppm of P) significantly improve wear performance (up to 95%) compared to the base oil. read more Electrical contact resistance results acquired in situ during tribological tests demonstrated that lubricants containing ZnOBM nanoparticles at sliding interfaces undergo tribochemical reactions to form stable tribofilms that reduce friction and wear. Atomic force microscopy (AFM), X-ray absorption near-edge spectroscopy (XANES), and X-ray photoelectron spectroscopy (XPS) analysis revealed that ZnOBM nanoparticles, by themselves, form patchy interfacial tribofilms containing iron borate, boron oxide, and zinc oxide and lead to superior tribological performance. Interestingly, ZnOBM nanoparticles interact synergistically with ZDDP to form a hierarchical interface of boron-doped tribofilms, with zinc-iron polyphosphates at the surface and iron oxide, zinc and iron sulfides in the bulk. These encouraging results suggest the potential effective use of the ZnOBM nanoparticles to significantly reduce harmful levels of ZDDP (350 ppm) in the engine oil without compromising the antifriction and antiwear performance and to develop eco-friendly high-performance lubricant additives.Near-infrared photoimmunotherapy (NIR-PIT) is a newly developed cancer treatment that uses antibody-IRDye700DX (IR700) conjugates and was recently approved in Japan for patients with inoperable head and neck cancer. Exposure of the tumor with NIR light at a wavelength of 690 nm leads to physicochemical changes in the antibody-IR700 conjugate-cell receptor complex, resulting in increased hydrophobicity and damage to the integrity of the cell membrane. However, it is important that the tumor be completely exposed to light during NIR-PIT, and thus, a method to provide real-time information on tumor location would help clinicians direct light more accurately. IR700 is a fluorophore that emits at 702 nm; however, there is no clinically available device optimized for detecting this fluorescence. On the other hand, many indocyanine green (ICG) fluorescence imaging devices have been approved for clinical use in operating rooms. Therefore, we investigated whether LIGHTVISION, one of the clinically available ICG cameras, could be employed for NIR-PIT target tumor detection. Due to the limited benefits of adding IR700 molecules, the additional conjugation of IRDye800CW (IR800) or ICG-EG4-Sulfo-OSu (ICG-EG4), which has an overlapping spectrum with ICG, to trastuzumab-IR700 conjugates was performed. Conjugation of second NIR dyes did not interfere the efficacy of NIR-PIT. The dual conjugation of IR800 and IR700 to trastuzumab clearly visualized target tumors with LIGHTVISION by detecting emission light of IR800. We demonstrated that the conjugation of second NIR dyes enables us to provide a real-time feedback of tumor locations prior to NIR-PIT.Benzofuran-derived azadienes (BDAs) have been widely used as four-atom synthons in transition-metal-mediated cycloaddition reactions, while the exploitation of their reactivity as a two-atom unit to construct spirocycles is still underdeveloped. Herein, we reported the first palladium(0)-catalyzed diastereo- and enantioselective [3 + 2] annulation of vinylcyclopropanes (VCPs) and BDAs. This transformation is featured with a broad substrate scope (31 examples), allowing for facile access to a variety of enantioenriched spirocycles bearing a quaternary stereogenic center in good yields with excellent regio-, diastereo-, and enantioselectivities (up to 93% yield, >201 dr, and mostly >99% ee) under mild reaction conditions. Moreover, the spirocyclic products could be efficiently converted to structurally complex tricyclo[8.3.0.01,5]-azatridecane and tricyclo[7.3.0.01,5]-azadodecane skeletons.Silicon has several technologically promising allotropes that are formed via high-pressure synthesis. One of these phases (hd) has been predicted to have a direct band gap under tensile strain, whereas other (r8 and bc8) phases are predicted to have narrow band gaps and good absorption across the solar spectrum. Pure volumes of these phases cannot be made using conventional nanowire growth techniques. In this work, Si nanowires were compressed up to ∼20 GPa and then decompressed using a diamond anvil cell in the temperature range of 25-165 °C. It was found that at intermediate temperatures, near-phase-pure bc8-Si nanowires were produced, whereas amorphous Si (a-Si) dominated at lower temperatures, and a direct transformation to the diamond cubic phase (dc-Si) occurred at higher temperatures under compression. Thus this study has opened up a new pressure-temperature pathway for the synthesis of novel Si nanowires consisting of designed phase components with transformative properties.Single-photon emitters, the basic building blocks of quantum communication and information, have been developed using atomically thin transition metal dichalcogenides (TMDCs). Although the bandgap of TMDCs was spatially engineered in artificially created defects for single-photon emitters, it remains a challenge to precisely align the emitter's dipole moment to optical cavities for the Purcell enhancement. Here, we demonstrate position- and polarization-controlled single-photon emitters in monolayer WSe2. A tensile strain of ∼0.2% was applied to monolayer WSe2 by placing it onto a dielectric rod structure with a nanosized gap. Excitons were localized in the nanogap sites, resulting in the generation of linearly polarized single-photon emission with a g(2) of ∼0.1 at 4 K. Additionally, we measured the abrupt change in polarization of single photons with respect to the nanogap size. Our robust spatial and polarization control of emission provides an efficient way to demonstrate deterministic and scalable single-photon sources by integrating with nanocavities.