Meyersbrix9435

Ultraviolet (UV) irradiation is an abiotic pathway for the transformation of complex phosphorus (P) components into inorganic P in ecosystems. To explore the effect of UV irradiation on organic P (OP) bioavailability in the water level fluctuation zone (WLFZ) soil, we collected representative soil samples from WLFZ of the Pengxi River, a tributary of the TGR, China. We determined the contents of different forms of OP in the WLFZ soil through sequential extraction. The bioavailability of different forms of OP and the effect of UV light were characterised using a combination of enzymatic hydrolysis and UV irradiation. The OP contents of the different extracts (Po) were ranked as NaOH-Po > NaHCO3-Po > H2O-Po, whereas those of enzymatically hydrolysable organic P (EHP) were ranked as NaOH-EHP > NaHCO3-EHP > H2O-EHP. UV irradiation was found to improve OP bioavailability, as demonstrated by increased levels of UV-sensitive P (UV-P) and EHP in the extracts after irradiation. The total contents of bioavailable Po in extracts were 5.6-35.3% higher after UV irradiation than before irradiation. Thus, the effect of UV irradiation on the OP bioavailability and release activity cannot be neglected in TGR WLFZ soil.The novelty of this study is to explore the effect of temperature varied biochar on the properties of biochar/polymers composites. Rice husk biochar (RB) samples were prepared at different pyrolysis temperatures and injection molding was used to prepare RB/high-density polyethylene (HDPE) composites. Additionally, ultimate analysis, X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), scanning electron microscope (SEM), pore structure characteristics, differential scanning calorimetry (DSC), thermogravimetric analysis (TGA), tensile properties, and dynamic mechanical analysis (DMA) were used to characterize these RB and RB/HDPE composites samples. The results validated that RB obtained at 600 °C showed the highest carbon content, the most complete pore structure, and the largest specific surface area. Moreover, the thermal studies revealed that the addition of RB improved the thermal stability of HDPE. The best tensile strength (26.25 MPa) and Young's modulus (1.87 GPa) were obtained in 500 °C RB/HDPE composites and 600 °C RB/HDPE composites due to their good physical/mechanical interlocking structures shown in SEM. DMA revealed that the stiffness, elasticity, creep resistance and stress relaxation of the composites were improved by the addition of RB. The utilization of temperature varied biochars in biocomposites is important to manage wastes and optimize the properties of biocomposites in terms of reducing production cost and ensuring environmental safety.In the present study, electrochemical oxidation of sulfamethoxazole (SMX) with Boron-doped Diamond (BDD) anode and Stainless Steel (SS) cathode was investigated systematically. The effects of current density, initial pH, supporting electrolyte and natural organic matter (NOM) on SMX degradation were explored. Under the conditions of current density 30 mA cm-2, 0.1 M Na2SO4 used as supporting electrolyte, pH of 7 and without NOM affect, SMX was completely removed after 3 h electrolysis. this website COD removal efficiency, current efficiency and energy consumption were 65.6%, 40.1%, 72 kWh kg COD-1, respectively. Degradation mechanism was analyzed based on the active sites of SMX identified by density functional theory (DFT) calculation and intermediates analysis by HPLC-Q-TOF-MS/MS. Three possible degradation pathways were proposed, with the replacement of -NH2 at aromatic ring by -OH, the oxidation of -NH2 to -NO2 and the addition of -OH on isoxazole ring observed. The active sites detected in reaction matched the DFT calculation results exactly. The toxicity of intermediates produced during electrolysis process was evaluated by Escherichia coli experiment. Results showed that, after 2 h electrolysis, the inhibition ratio was decreased from the initial value of 22.8% to 10%, which has already achieved the safety boundary. After 4 h electrolysis, the toxicity was almost zero even with still 60% COD remained in the solution. This phenomenon demonstrated that the toxicity of SMX and its intermediate products was reduced significantly during electrolysis process.Dichloroacetamide safeners are commonly included in herbicide formulations to protect crops from unintended herbicide toxicity, but knowledge of their environmental fate is scarce. Hydrogen sulfide, a naturally-occurring nucleophile and reductant, often coexists with black carbon (e.g., biochar, soot) in subsurface environments and could influence the fate of these safeners. In this study, we demonstrated that graphite powder, a model black carbon, significantly accelerated the transformation of three dichloroacetamide safeners (AD-67, benoxacor, and dichlormid) and two chloroacetamide herbicides (metolachlor and acetochlor) by hydrogen sulfide. Chloride was formed together with an array of sulfur-substituted products, suggesting a nucleophilic substitution pathway. Our results suggest that the electron-accepting capacity of black carbon can oxidize hydrogen sulfide species to elemental sulfur, which can further react with bisulfide to form polysulfide, likely accounting for the observed accelerated transformation of (di)chloroacetamides in systems containing black carbon and hydrogen sulfide. Moreover, our product analyses indicate that dimerization and/or trimerization of (di)chloroacetamides is possible in the presence of hydrogen sulfide and graphite, which is anticipated to decrease the mobility of these products in aquatic environments relative to the parent compounds. Herein, we also discuss how the structure and concentration of (di)chloroacetamides can influence their reactivity in the presence of black carbon and reduced sulfur species.Rivers are regarded as sinks and pathways of plastic pollutants from terrestrial environments to various other aquatic systems such as lakes and oceans. Although extensive research has been conducted in recent years on microplastic pollution in river sediments, knowledge on the relationships between potential influential factors such as catchment characteristics and sediment properties, and microplastics occurrence in river sediments, is still considered an under-researched area. This study evaluated the influence of land use, population, and sediment particle size on the presence of microplastics abundance and types. Based on a Bayesian Network modelling approach to characterise the correlations between influencing factors and microplastics occurrence, it was evident that microplastics type had a positive correlation with different land use types and population. Catchment characteristics were found to play a more important role in influencing microplastics type than microplastics concentration. A statistically significant positive relationship was observed between microplastics concentration and clay particles which suggested that the occurrence of microplastics in sediments can be impacted by the presence of clay particles.