Mckenzielindberg6987

Black shale deposited in the transitional period from the Late Ordovician to Early Silurian is the most important source rock and shale gas reservoir in the Yangtze region of South China. However, the source of these sediments is still controversial. In this paper, the changes in total organic carbon (TOC), total sulfur (TS), organic carbon isotopes (δ13Corg), biomarkers, trace elements, and rare earth elements in the Ordovician-Silurian boundary strata of the XK-1 well in northern Guizhou Province, South China, have been systematically studied. The paleoenvironmental and paleoclimatic conditions of the Late Ordovician to Early Silurian and their relationship with organic matter enrichment in the Upper Yangtze Platform have been reconstructed. The distribution of biomarkers reflects that the Late Ordovician-Early Silurian shale was deposited in the marine environment and was highly contributed by marine plankton/algae and microorganisms. Paleoclimatic proxies (Sr/Cu, δ13Corg) show that the global climate systtze region during the Late Ordovician and Early Silurian intervals.A fully Integrated Micropillar Polydimethylsiloxane Accurate CRISPR deTection (IMPACT) system is developed for viral DNA detection. This powerful system is patterned with high-aspect-ratio micropillars to enhance reporter probe binding. After surface modification and probe immobilization, the CRISPR-Cas12a/crRNA complex is injected into the fully enclosed microchannel. With the presence of a double-stranded DNA target, the CRISPR enzyme is activated and denatures the single-stranded DNA reporters from the micropillars. This collateral cleavage releases fluorescence reporters into the assay, and the intensity is linearly proportional to the target DNA concentration ranging from 0.1 to 10 nM. Importantly, this system does not rely on the traditional dye-quencher-labeled probe, thus reducing the fluorescence background presented in the assay. Furthermore, our one-step detection protocol is performed on-chip at isothermal conditions (37 °C) without using complicated and time-consuming off-chip probe hybridization and denaturation. This miniaturized and fully packed IMPACT chip demonstrates sensitive and accurate DNA detection within 120 min and paves ways to the next-generation point-of-care diagnostics, responding to emerging and deadly pathogen outbreaks.Considering the severe impacts on the economic losses caused by oil spills, it is of great significance to develop an oil-absorbent material for removing the oil slick from the water surface effectively. As a new oil-absorbent material, magnetorheological fluid (MRF) has unsinkability, hydrophobicity, and lipophilicity, which could effectively remove the oil slick on the water surface while repelling water. Particularly, the prepared MRF shows a good response to external magnetic field. MRFs show high oil removal capacity in fresh water, deionized water, and salt water with efficiencies up to 94.39, 93.65, and 92.71%, respectively. Besides, Fe3O4/OA magnetic nanoparticles (MPs) could be reprepared into MRF by simple treatments. After the fifth cycle, the MRF prepared by the recovered Fe3O4/OA MPs still has high oil removal efficiency, and that means the Fe3O4/OA MPs has excellent reusability and stability. The method for preparing MRFs provided in this work is simple and effective, and the MRFs have a promising potential for cleaning oil slick.In conventional lime calcination processes, because of fuel combustion in the kiln, the carbon dioxide (CO2) from limestone decomposition is mixed with the flue gas, which results in energy requirement for gas separation in the carbon capture process. Here, a novel lime calcination system with carrier gas (CO2) heating and air cooling is proposed to avoid the mixing problem of the CO2 and the flue gas. This system consists of a new shaft kiln with four processing zones and a furnace system, where fuel combustion, limestone reaction, and lime cooling are carried out separately. Therefore, while obtaining qualified lime products, the CO2 from limestone decomposition can be captured without a gas separation process, which accounts for 70% of the total carbon emission in lime production. this website Furthermore, a thermal-mass balance model was developed for the new system. Based on the model calculation, the energy consumption level of the new system was clarified via a case study. Moreover, parametric analyses were performed to examine the influence of the coefficient of excess air, the coefficient of lost carrier gas, and the calorific value of coal gas on the system performance such as the energy consumption and the CO2 captured.Highly porous nickel-aluminum oxide aerogels were prepared according to a one-pot sol-gel process and dried under supercritical carbon dioxide conditions. Although the surface properties of these materials were very appealing for applications in catalysis, these aerogels were never applied in adsorption. The nickel effect on the structure and surface properties of the aerogels has been investigated via a broad range of structural, textural, and morphology characterization of the aerogels before and after heat treatment. The adsorption capacity of the as-synthesized and calcined aerogels for azo dyes was assessed under various experimental conditions. The presence of nickel in the aerogel boosts tremendously the surface reactivity and improves noticeably the adsorption capacity of the material. The adsorption capacities for the nickel-aluminum oxide aerogel with 40% nickel (qmax) are 900 mg g-1 for methyl orange, 1484 mg g-1 for orange II, and 1660 mg g-1 for Congo Red. The adsorption process is exothermic and follows pseudo-second-order kinetics.Information contained in the sequences of biological polymers such as DNA and protein is crucial to determining their function. Lipids are not generally thought of as information-containing molecules. However, from a supramolecular perspective, the number of possible combinations of lipids in a mixture is comparable to the complexity of DNA or proteins. Here, we test the idea that an organic composome can exhibit molecular recognition. We use water/octanol as a model two-phase system and investigate the effect of organic solutes in different combinations in the organic phase on selective partitioning of two water-soluble dyes (Brilliant Blue FCF and Allura Red AC) from the aqueous phase into the organic phase. We found that variation in the concentration of the surfactant cetyltrimethylamonium bromide (CTAB) in the octanol phase alone was sufficient to cause a switch in selectivity, with low CTAB concentrations being selective for the red dye and high CTAB concentrations being selective for the blue dye. Other organic components were added to the organic phase to introduce molecular diversity into the composome and directed evolution was used to optimize the relative concentrations of the solutes.