Mckennarubin2717

Fiat 500 Replacement Key Fob

It's possible to change the battery if your 500 remote key fob is not working. If you replace the battery, but it doesn't work it could be the issue somewhere else.

United Locksmith specializes in the production of new keys for classic automobiles. We have the tools and spare parts needed for this service.

Dead Coin Battery

A dead battery is the most common reason for your Fiat 500 keyfob not locking or unlocking the doors. The coin cell battery in the key fob can be depleted quickly in the event that you don't use it often enough. If your remote began to show signs of weakening like a loss of range, and then stopped working completely, the battery is probably dead.

The battery in the key fob is held in place by steel clips for retaining. If the clips are loose, they can cause contact issues, which could prevent your remote from receiving power. Make use of a flathead screwdriver to pry open the retaining clip and then remove the old battery. Make sure to select an identical replacement battery type of voltage, size and specifications as the original battery.

The key fob may also become corroded or damaged by exposure to water. Even a small bath in soapy, warm water can damage the chip. Make sure your key fob is dry.

Water Damage

If your key fob doesn't work properly, it may be caused by water damage. Key fobs have rubber seals that prevent them from being damaged by rain or splashes of water, but it is vital to keep your car keys safe from the pool, ocean, and the washing machine!

The key fob has an electronic chip inside it that sends a signal to your car's immobilizer system. The chip is what allows the 500 to lock and start. If it gets wet it will not work.

If you want to check if your key fob is functioning it is possible to clean the internal electronics with isopropyl or electronic cleaner. However, it is probably better to purchase a new one from a dealership instead of trying to repair the key fob which was submerged in salt water.

While a replacement fob can cost a bit of money, it is a lot cheaper than paying for your Fiat 500 to be towed to the dealer for repair! Plus, you can make it yourself in just a few easy steps. Be sure to have the correct battery type before attempting to open your key fob. You can find step-by-step instructions for any car keyfob on the internet.

Faulty Chip

The chip inside the key fob communicates with the car's immobiliser unit to ensure the vehicle is able to start when the correct key is inserted. If the chip is damaged or damaged, your car won't start no matter what you do.

Damage to the water or a dead battery are the two most common causes of an unreliable chip. It is recommended to leave the task to a professional locksmith who can replace the chip in a short time and at a an affordable cost.

If your key fob ceases to function after exposure to clean water from the tap or rain, take off the battery and clean the electronic component with a paper towel to ensure it's dry before putting it back in. If the key fob still isn't working it's most likely an issue with the chip and is required to be replaced.

Some people will visit their dealer if they require a new Fiat fob. However, this can be costly. United Locksmith is the best place to go if you need your Fiat keyfob fixed at a reasonable price. We have all the tools and expertise to fix your Fiat fob quickly and professionally. way.

Faulty Receiver Module





Fiat key fobs send a signal up to 50 feet to the vehicle, which will open and close the doors (and start the vehicle for vehicles with automatic transmissions). There are many reasons why the fob could not function. This includes a dead coin battery or water damage buttons, worn out buttons as well as a receiver module problem or signal interference, or an electronic chip that is malfunctioning.

If the fob is in the pocket of someone who has suffered extreme trauma (such as being dropped on the floor, or washed in the washing machine) the fob might not be in a position to connect with the Body Control Module (BCM) of the vehicle. This is because the BCM is secured and will only accept a signal from a genuine original key and not another.

If this is the case, then you have to replace your fob. A professional locksmith will handle the entire process of replacing keys including programming a brand new key for your 500. stuck can even provide you with an identical fob that functions exactly like the original (and costs only less than the price).