Magnussongood7836

In this work, we investigate material design criteria for low-powered/self-powered and efficient organic electrochemical transistors (OECTs) to be operated in the faradaic mode (detection at the gate electrode occurs via electron transfer events). To rationalize device design principles, we adopt a Marcus-Gerischer perspective for electrochemical processes at both the gate and channel interfaces. This perspective considers density of states (DOS) for the semiconductor channel, the gate electrode, and the electrolyte. We complement our approach with energy band offsets of relevant electrochemical potentials that can be independently measured from transistor geometry using conventional electrochemical methods as well as an approach to measure electrolyte potential in an operating OECT. By systematically changing the relative redox property offsets between the redox-active electrolyte and semiconducting polymer channel, we demonstrate a first-order design principle that necessary gate voltage is minimized by good DOS overlap of the two redox processes at the gate and channel. Specifically, for p-type turn-on OECTs, the voltage-dependent, electrochemically active semiconductor DOS should overlap with the oxidant form of the electrolyte to minimize the onset voltage for transconductance. A special case where the electrolyte can be used to spontaneously dope the polymer via charge transfer is also considered. Collectively, our results provide material design pathways toward the development of simple, robust, power-saving, and high-throughput OECT biosensors.Ambient atmosphere is critical for the surface/interface chemistry of electrodes that governs the operation and failure in energy storage devices (ESDs). Here, taking an Al/graphite battery as an example, both the relaxation and failure processes in the working graphite electrodes have been dynamically monitored by multiple in situ surface and interface characterization methods within various well-controlled atmospheres. Relaxation effects are manifested by recoverable stage-structure change and electronic relaxation occurring in anhydrous inert atmospheres and O2, which are induced by the anion/cation redistribution within the neighboring graphene layers and have slight influence on the long-term cycling. In contrast, rapid and unrecoverable failure behaviors happen in hydrous atmospheres as shown by the stage-structure degradation and electronic decoupling between guest ions and host graphite, which are caused by the hydrolysis between newly intercalated H2O molecules and intercalants. Consistent with the characterization results, exposure to H2O can cause nearly 100% capacity loss. The methodology and concept adopted in this work to unravel the battery mechanism under ambient conditions are universal and significant to investigate many ESDs.Linothele fallax (Mello-Leitão) (L. fallax) spider web, a potentially attractive tissue engineering material, was investigated using quantitative peak force measurement atomic force microscopy and scanning electron microscopy with energy dispersive spectroscopy both in its natural state and after treatment with solvents of different protein affinities, namely, water, ethanol, and dimethyl sulfoxide (DMSO). Native L. fallax silk threads are densely covered by globular objects, which constitute their inseparable parts. Depending on the solvent, treating L. fallax modifies its appearance. In the case of water and ethanol, the changes are minor. In contrast, DMSO practically removes the globules and fuses the threads into dense bands. Moreover, the solvent treatment influences the chemistry of the threads' surface, changing their adhesive and, therefore, biocompatibility and cell adhesion properties. On the other hand, the solvent-treated web materials' contact effect on different types of biological matter differs considerably. Protein-rich matter controls humidity better when wrapped in spider silk treated with more hydrophobic solvents. NMS-873 cell line However, carbohydrate plant materials retain more moisture when wrapped in native spider silk. The extracts produced with the solvents were analyzed using nuclear magnetic resonance (NMR) and liquid chromatography-mass spectrometry techniques, revealing unsaturated fatty acids as representative adsorbed species, which may explain the mild antibacterial effect of the spider silk. The extracted metabolites were similar for the different solvents, meaning that the globules were not "dissolved" but "fused into" the threads themselves, being supposedly rolled-in knots of the protein chain.Diffusioosmosis (DO) results from ion transport near charged surfaces in the presence of electrolyte gradients and is critical in nanofluidic systems. However, DO has not yet been comprehensively studied because nanofabrication materials have limitations of low throughput and difficult quantification. Herein, we describe a self-assembled particle membrane (SAPM)-integrated microfluidic platform that can modulate the material properties (e.g., zeta-potential) and transport flux of nanopores. We quantify the effect of the zeta-potential on DO by measuring the electrical signals across three different nanopores/nanochannels of the SAPM. We then empirically quantify the effects of the temperature and ionic strength of the electrolytes on DO and reveal a nonlinear relationship with DO-driven ion transport; the ionic strengths govern the DO- or diffusion-effective ion transport phenomena. Finally, we demonstrate DO-driven electric power generation with enhanced performance as a potential application under optimized experimental conditions.We studied the diffusion properties of lipophilic vitamin E (VE) through bicontinuous microemulsions (BME) using both electrochemical and fluorescence correlation spectroscopy (FCS) measurements. We investigated the effect of different composition ratios of micro-water and micro-oil phases in BMEs (W/OBME). When we employed the BME with a lower W/OBME value of 40/60 (oil-rich BME) as an electrolyte solution, we obtained a larger current response from VE at a fluorinated nanocarbon film electrode. Further voltammetric studies revealed that a higher VE diffusion coefficient was observed in the oil-rich BME. The FCS results also exhibited faster diffusion through the oil-rich BME, which played a significant role in accelerating the VE diffusion probably due to the widening of the micro-oil phase pathway in the BME. Moreover, the effect of increasing the VE diffusion was pronounced at the interface between the electrode surface and the BME solution. These results indicate that controlling the conditions of the BME as the measurement electrolyte is very effective for achieving superior electrochemical measurements in a BME.The physical proximity of layered materials in their van der Waals heterostructures (vdWhs) aids interfacial phenomena such as charge transfer (CT) and energy transfer (ET). Besides providing fundamental insights, CT and ET also offer routes to engineer optoelectronic properties of vdWhs. For example, harnessing ET in vdWhs can help to overcome the limitations of optical absorption imposed by the ultra-thin nature of layered materials and thus provide an opportunity for in situ enhancement of quantum efficiency for light-harvesting and sensing applications. While several spectroscopic studies on vdWhs probed the dynamics of CT and ET, the possible contribution of ET in the photocurrent generation remains largely unexplored. In this work, we investigate the role of nonradiative energy transfer (NRET) in the photocurrent through a vertical vdWh of SnSe2/MoS2/TaSe2. We observe an unusual negative differential photoconductance (NDPC) arising from the existence of NRET across the SnSe2/MoS2 junction. Modulation of the NRET-driven NDPC characteristics with optical power results in a striking transition of the photocurrent's power law from a sublinear to a superlinear regime. Our observations reveal the nontrivial influence of ET on the photoresponse of vdWhs, which offer insights to harness ET in synergy with CT for vdWh based next-generation optoelectronics.The abuse of antibiotics in modern life and aquaculture has become a worldwide problem. Trace amounts of antibiotics discharged into natural water are increased in organisms through bioaccumulation and ultimately harm human health. Herein, we report a metal-tagged CRISPR/Cas12a bioassay and apply it to an ultrasensitive and highly selective evaluation of antibiotics bioaccumulation in wild fish samples. We integrated an element-tagging report probe and collateral cleavage activity of CRISPR/Cas12a. With the recognition and capture of target kanamycin by a "locked-activated" system, the activator strand was subsequently released to activate the collateral cleavage activity of Cas12a, followed by the cleavage of free Tm-Rep. After SA-MB capture, the biotin terminal was modified, and the uncleaved probe of Tm-Rep was removed. The acidized supernate containing the element tag fragment could be directly detected with 169Tm isotope monitoring by inductively coupled plasma mass spectrometry (ICPMS). With CRISPR/Cas12a biosensing and metal isotope detection by ICPMS, ultrasensitive and fast antibiotics analysis was realized with multiplex detection potential. Taking kanamycin as a modal analyte, a limit of detection as low as 4.06 pM was provided in a 30 min detection workflow. Besides, the bioaccumulation effect of kanamycin in a wild fish sample was also evaluated using the proposed strategy. We investigated the geographical distribution with Pseudorasbora parva samples collected in four different locations along a 600 km stretch of the Yangtze River. In addition, the bioaccumulation kinetics of antibiotics was evaluated in serum, muscle, and liver tissues of Pseudorasbora parva with 7 days of continuous feeding in a kanamycin-enriched environment.Sodium dodecyl sulfate (SDS) provides numerous benefits for proteome sample preparation. However, the surfactant can be detrimental to downstream mass spectrometry analysis. Although strategies are available to deplete SDS from proteins, each is plagued by unique deficiencies that challenge their utility for high-throughput proteomics. An optimal approach would rapidly and reproducibly achieve less than 10 ppm residual SDS while simultaneously maximizing analyte recovery. Here, we describe improvements to a simple electrokinetic device termed transmembrane electrophoresis, which we previously reported for automated, rapid SDS depletion of proteome samples. Voltage-driven transport of SDS across a molecular weight cutoff membrane is enhanced at higher electric fields, which is herein achieved by integrating an active cooling mechanism to mitigate the impacts of Joule heating. We report 99.9% reduction of SDS (final concentration 98%) and increasing the number of identifications by liquid chromatography-tandem mass spectrometry.An unusual case of suicide using an angle grinder is presented. A forensic examination of the corpse revealed an injury to the soft tissues of the neck with a complete transverse intersection of the neurovascular bundles, organs of the neck and cervical spine caused by a rotating disc of an angle grinder. This observation supplements the existing ideas about the possibility of using power tools for various purposes with suicidal purposes.