Lorentzenvoss2243

Low-frequency noise is a key performance-limiting factor in almost all electronic systems. Thanks to its excellent characteristics such as exceptionally high electron mobility, graphene has high potential for future low-noise electronic applications. Here, we present an experimental analysis of low-frequency noise in dual-gate graphene transistors based on chemical vapor-deposited Bernal-stacked bilayer graphene. The fabricated dual-gate bilayer graphene transistors adopt atomic layer-deposited Al2O3 and HfSiO as top-gate and back-gate dielectric, respectively. Our results reveal an obvious M-shape gate-dependent noise behavior which can be well described by a quantitative charge-noise model. The minimal area normalized noise spectral density at 10 Hz reaches as low as about 3 × 10-10 μm2·Hz-1 at room temperature, much lower than the best results reported previously for graphene devices. In addition, the observed noise level further decreases by more than 10 times at temperature of 20 K. Meanwhile, the noise spectral density amplitude can be tuned by more than 2 orders of magnitude at 20 K by dual-gate voltages.According to their materials and operating parameters, metal oxide (MOX) sensors respond to target gases only by a change in sensor resistance with a lack in selectivity. By the use of infrared spectroscopy, highly discriminatory information from samples at a molecular level can be obtained and the selectivity can be enhanced. A low-volume gas cell was developed for a commercially available semiconducting MOX methane gas sensor and coupled directly to a mid-infrared gas sensor based on substrate-integrated hollow waveguide (iHWG) technology combined with a Fourier transform infrared spectrometer. This study demonstrates a sensing process with combined orthogonal sensors for fast, time-resolved, and synergic detection of methane and carbon dioxide in gas samples.Microplastics (MPs) are ubiquitous contaminants of the marine environment, and the deep seafloor is their ultimate sink compartment. Manipulative and field experiments provided evidence of the ingestion of MPs by deep-sea fauna, but knowledge of MPs' fate once ingested still remains scant. We provide evidence of MP partial retention and fragmentation mediated by digestion activity of a Norwegian langoustine, a good bioindicator for MP contamination of the deep sea. We report here that MPs in the intestines were more abundant and significantly smaller (up to 1 order of magnitude in surface) than those in the stomachs. Our results show that the stomach can act as a size-bottleneck for ingested MPs, enhancing the retention of larger particles within the stomach and promoting fragmentation into smaller plastic debris, which is then released in the intestine. Our results provide evidence that the langoustine is responsible for the fragmentation of MPs already accumulated in sediments through its scavenging activity and digestion. These findings highlight the existence of a new peculiar kind of "secondary" MPs, introduced in the environment by biological activities, which could represent a significant pathway of plastic degradation in a secluded and stable environment such as the deep sea.Selenium is highly elevated in Appalachian streams and stream organisms that receive alkaline mine drainage from mountaintop removal coal mining compared to unimpacted streams in the region. Adult aquatic insects can be important vectors of waterborne contaminants to riparian food webs, yet pathways of Se transport and exposure of riparian organisms are poorly characterized. check details We investigated Se concentrations in stream and riparian organisms to determine whether mining extent increased Se uptake in stream biofilms and insects and if these insects were effective Se biovectors to riparian spiders. Biofilm Se concentration increased (p = 0.006) with mining extent, reaching a maximum value of 16.5 μg/g of dw. Insect and spider Se increased with biofilm Se (p = 0.004, p = 0.003), reaching 95 and 26 μg/g of dw, respectively, in mining-impacted streams. Adult insect biomass was not related to mining extent or Se concentrations in biofilm. Even though Se concentrations in aquatic insects were significantly and positively related to mining extent, aquatic insect Se flux was not associated with mining extent because the mass of emerging insects did not change appreciably over the mining gradient. Insect and spider Se concentrations were among the highest reported in the literature, regularly exceeding the bird Se dietary risk threshold of 5 μg/g of dw. Risks of Se exposure and toxicity related to mining are thus not constrained to aquatic systems but extend to terrestrial habitats and food webs.Elevated PM2.5 concentrations frequently cause severe air pollution events in Delhi. Till recently, the effect of crop residue burning on the air quality in Delhi has not been fully quantified and the approaches to control the impact of fire emissions have not been effective. In this study, for the first time, we quantified the statewise contribution of post-monsoon crop residue burning in the northwestern states of India to surface PM2.5 concentrations in Delhi using several sensitivity experiments with the Weather Research and Forecasting model coupled with Chemistry (WRF-Chem) and FINNv1.5 fire emission inventory. Results were evaluated with ground-based observations in Delhi (21 stations), Punjab, and Haryana (14 stations). On average, ∼20% of PM2.5 concentration in Delhi during the post-monsoon season (October-November) was found to be contributed by nonlocal fire emissions. However, on typical air pollution events, fire emissions contributed as high as 50-75% (80-120 μg/m3) to PM2.5 in Delhi, highlighting the importance of both external transport and local emissions to PM2.5 pollution in Delhi.Interactions among antiwear additives (AWs), friction modifiers (FMs), and dispersant in a lubricating oil are critical for tribological performance. This study investigates compatibilities of three oil-soluble ionic liquids (ILs, candidate AWs) with an FM, molybdenum dithiocarbamate (MoDTC), and a dispersant, polyisobutene succinimide (PIBSI) under boundary lubrication. Either synergistic or antagonistic effects were observed depending on the IL's chemistry. Adding an aprotic phosphonium-alkylphosphate or phosphonium-alkylphosphinate IL into the oil containing MoDTC and PIBSI had detrimental impact on the friction and wear behavior. PIBSI was found to preferably interact/react with the aprotic IL to lose its ability of suspending MoDTC and to partially consume or even deplete the IL. In contrast, a protic ammonium-alkylphosphate IL seemed to be able to coexist with PIBSI and work synergistically with MoDTC, yielding a sustainable, ultralow boundary friction. A three-stage tribochemical process is proposed to explain how this IL + MoDTC pair interacts with the contact surface to form a chemically reacted, wear-protective tribofilm supporting a physically adsorbed, friction-reducing film on top.