Kokengland2739

Methylene blue (MB) is one of the most dangerous dyes found in numerous industries' wastewaters. Thus, the effect of suspended Pt nanoparticles (NPs) on the adsorption capability of TiO2NPs towards MB was investigated in this research. Factors affecting (adsorbate initial concentration, agitation time, solution pH, and temperature) the adsorption capacity of MB on the modified TiO2NPs were also studied. It was found that the first two factors have a positive effect, the temperature has an adverse impact, and the maximum uptake was observed when pH is 11. Isotherm parameters of Langmuir, Freundlich, and Timken models were determined. Langmuir's model was found to be the best one for analyzing the experimental data. The adsorption capacities obtained were 100.61, 90.66, and 80.26 mg g-1at 25 °C, 40 °C, and 55 °C, respectively. 1storder, 2ndorder, and intra-particle diffusion kinetic models were utilized to analyze experimental data. It found that these data were explained well by the 2ndorder model, indicating that this adsorption is chemisorption. Thermodynamic parameters were also determined, and the results obtained suggest that this adsorption is an exothermic and spontaneous process. The findings show that TiO2NPs modified by suspended Pt NPs will get a strong attraction in the treatment of fluids and wastewaters.Purpose.Electronic portal image devices (EPIDs) have been investigated previously for beams-eye view (BEV) applications such as tumor tracking but are limited by low contrast-to-noise ratio and detective quantum efficiency. A novel multilayer imager (MLI), consisting of four stacked flat-panels was used to measure improvements in fiducial tracking during liver stereotactic body radiation therapy (SBRT) procedures compared to a single layer EPID.Methods.The prototype MLI was installed on a clinical TrueBeam linac in place of the conventional DMI single-layer EPID. The panel was extended during volumetric modulated arc therapy SBRT treatments in order to passively acquire data during therapy. Images were acquired for six patients receiving SBRT to liver metastases over two fractions each, one with the MLI using all 4 layers and one with the MLI using the top layer only, representing a standard EPID. The acquired frames were processed by a previously published tracking algorithm modified to identify implanted radiopaque fiducials. Truth data was determined using respiratory traces combined with partial manual tracking. Results for 4- and 1-layer mode were compared against truth data for tracking accuracy and efficiency. Tracking and noise improvements as a function of gantry angle were determined.Results. Tracking efficiency with 4-layers improved to 82.8% versus 58.4% for the 1-layer mode, a relative improvement of 41.7%. Fiducial tracking with 1-layer returned a root mean square error (RMSE) of 2.1 mm compared to 4-layer RMSE of 1.5 mm, a statistically significant (p less then 0.001) improvement of 0.6 mm. The reduction in noise correlated with an increase in successfully tracked frames (r = 0.913) and with increased tracking accuracy (0.927).Conclusion. Increases in MV photon detection efficiency by utilization of a MLI results in improved fiducial tracking for liver SBRT treatments. Future clinical applications utilizing BEV imaging may be enhanced by including similar noise reduction strategies.A new two-dimensional carbon-based material consisting of pentagonal and hexagonal elements is identified by numerical experiments, which is called phgraphene and possesses not only a tunable semimetallic feature but also a direction-dependent even sign-changed Poisson's ratio. The structural stability of such a new material is first checked systematically. It is found that phgraphene has a similar energy as theγ-graphyne, a thermally stable structure from the room temperature to 1500 K, and elastic constants satisfying the Born-Huang criterion. Both the band structure and density of states are further verified with different techniques, which demonstrate a Dirac semimetallic characteristic of phgraphene. A more interesting finding is that the band structure can be easily tuned by an external loading, resulting in the transition from semimetal to semiconductor or from type I to type III. As a new material that may be applied in the future, the mechanical property of phgraphene is further evaluated. It shows that phgraphene is a typically anisotropic material, which has not only direction-dependent Young's moduli but also direction-dependent even sign-changed Poisson's ratios. The microscopic mechanisms of both the electrical and mechanical properties are revealed. Such a versatile material with tunable band structure and auxetic effect should have promising applications in the advanced nano-electronic field in the future.Photocatalytic production of H2O2from water and atmospheric oxygen has been recognized as a green and sustainable chemical process, due to the abundance of raw materials and sustainable solar energy. Herein, flower-like hierarchical ZnO microspheres were prepared by hydrothermal method followed by calcination at different temperatures, and their photocatalytic performance in H2O2production was examined under simulated sunlight irradiation. The calcination temperature plays a vital role in the structure, morphology, and surface area of the final ZnO products as well as their optical and electrochemical properties, which are determining factors in their photocatalytic activity. The ZnO calcined at 300 °C (Zn-300) exhibits the highest activity and optimal stability, showing productivity of 2793μmol l-1within 60 min of irradiation, which was 6.5 times higher than that of uncalcined ZnO precursor. The remarkable photocatalytic activity is attributed to enhanced light utilization, large surface area, abundant exposed active sites, improved separation efficiency, and prolonged carrier lifespan. Moreover, the results from cycling experiments indicate the as-prepared ZnO samples exhibit good stability and long-time performance. This work provides useful information for the preparation of hierarchical ZnO photocatalysts.The antH. venatorcan engage in various labors using a pair of elongated mandibles with the ability to rotate about two orthogonal axes. This biaxial rotation enables the ant to gently handle their small, fragile eggs with enhanced contact area and smaller work space. However, how this biaxial rotation influences the ant's predation ability and how the ant responds to this influence remain elusive. We quantitatively investigate the tribological performance of the ant's mandibles during interactions with prey by taking morphology and kinematics into consideration. We find that each ant mandible features unique, double-rows of dorsal teeth (DT) and ventral teeth (VT), which are employed to firmly clamp prey over a wide range of sizes by biting their different body parts, demonstrating the ant's predation ability. We hypothesize the mechanism underlying such an ability may rely on the two, non-parallel rows of teeth which potentially eliminate effects of biaxial rotation. To test this hypothesis, we systematically change the distribution and orientation of teeth on bio-inspired robotic mandibles and investigate the mandible tribological performance of different teeth configurations. We find that the friction coefficient varies prominently between the DT and VT resulting from biaxial rotation, with the variations showing an inverse pattern. This explains the observed phenomenon that mandibles equipped with DT and VT provide the most stable friction coefficient when clamping objects of different sizes using different mandible regions. The specialized distribution of teeth facilitates enhanced tribological stability in capturing prey, and demonstrates an intrinsic link between the form, motion, and function in the insect appendages. Our research sheds lights on the current understanding of the predation behaviors of ants, and can inspire future design of multifunctional robotic grippers.Objective.Motor imagery is the mental simulation of movements. It is a common paradigm to design brain-computer interfaces (BCIs) that elicits the modulation of brain oscillatory activity similar to real, passive and induced movements. In this study, we used peripheral stimulation to provoke movements of one limb during the performance of motor imagery tasks. Unlike other works, in which induced movements are used to support the BCI operation, our goal was to test and improve the robustness of motor imagery based BCI systems to perturbations caused by artificially generated movements.Approach.We performed a BCI session with ten participants who carried out motor imagery of three limbs. In some of the trials, one of the arms was moved by neuromuscular stimulation. We analysed 2-class motor imagery classifications with and without movement perturbations. We investigated the performance decrease produced by these disturbances and designed different computational strategies to attenuate the observed classification accuracy drop.Main results.When the movement was induced in a limb not coincident with the motor imagery classes, extracting oscillatory sources of the movement imagination tasks resulted in BCI performance being similar to the control (undisturbed) condition; when the movement was induced in a limb also involved in the motor imagery tasks, the performance drop was significantly alleviated by spatially filtering out the neural noise caused by the stimulation. We also show that the loss of BCI accuracy was accompanied by weaker power of the sensorimotor rhythm. Importantly, this residual power could be used to predict whether a BCI user will perform with sufficient accuracy under the movement disturbances.Significance.We provide methods to ameliorate and even eliminate motor related afferent disturbances during the performance of motor imagery tasks. This can help improving the reliability of current motor imagery based BCI systems.Selective spatial isolation and manipulation of single chromosomes and the controlled formation of defined chromosome ensembles in a droplet-based microfluidic system is presented. The multifunctional microfluidic technology employs elastomer valves and membrane displacement traps to support deterministic manipulation of individual droplets. Picoliter droplets are formed in the 2D array of microscale traps by self-discretization of a nanoliter sample plug, with membranes positioned over each trap allowing controllable metering or full release of selected droplets. By combining discretization, optical interrogation, and selective droplet release for sequential delivery to a downstream merging zone, the system enables efficient manipulation of multiple chromosomes into a defined ensemble with single macromolecule resolution. Key design and operational parameters are explored, and co-compartmentalization of three chromosome pairs is demonstrated as a first step toward formation of precisely defined chromosome ensembles for applications in genetic engineering and synthetic biology.We consider an out-of-equilibrium one-dimensional model for two electrical double-layers. AMD3100 antagonist With a combination of exact calculations and Brownian dynamics simulations, we compute the relaxation time (τ) for an electroneutral salt-free suspension, made up of two fixed colloids, withNneutralizing mobile counterions. ForNodd, the two double-layers never decouple, irrespective of their separationL; this is the regime of like-charge attraction, whereτexhibits a diffusive scaling inL2for largeL. On the other hand, for evenN,Lno longer is the relevant length scale for setting the relaxation time; this role is played by the Bjerrum length. This leads to distinctly different dynamics forNeven, thermal effects are detrimental to relaxation, increasingτ, while they accelerate relaxation forNodd. Finally, we also show that the mean-field theory is recovered for largeNand moreover, that it remains an operational treatment down to relatively small values ofN(N> 3).