Huffmanvinding4889

Objectives The present study aimed to investigate osteocalcin levels in saliva of healthy and periodontitis patients and correlate these levels with periodontitis severity. Materials and methods This cross-sectional study was conducted in a hospital setup. A total of 95 individuals participated in the study with 46 subjects in group I (healthy individuals) and 49 subjects in group II (mild, moderate, and severe chronic periodontitis patients). A detailed assessment of clinical periodontal parameters and alveolar bone loss was made. click here Unstimulated saliva samples were collected from all study subjects and osteocalcin levels were quantitatively analyzed by sandwich enzyme-linked immunosorbent essay technique. Statistical analysis One-way analysis of variance, Spearman's correlation test, and Pearson's chi-squared test were applied at a significance level of 95%. p-Values less than 0.05 were considered statistically significant. Results The results showed a significant association of qualification with group II (p less then 0.02). Bone loss scores were also significantly associated with periodontitis severity (p less then 0.01). However, no statistically significant difference was observed between group I and group II in terms of mean salivary osteocalcin levels (p = 0.68). Also, an insignificant correlation was also observed between osteocalcin levels and periodontitis severity (p = 0.13). Conclusion The overall study results showed that there was no significant difference between saliva osteocalcin levels of healthy and periodontitis patients. Also, there was a nonsignificant correlation between osteocalcin levels and periodontitis severity. The findings of the present study support the hypothesis that low osteocalcin levels in saliva might be considered as a poor indicator of periodontal disease progression and severity.Objectives Reciprocating endodontic one-file systems are a comparatively new method for root canal shaping. Even though the mechanical properties are comparable to modern rotating mechanical systems, data about subjective assessment and application quality are scarce. This study evaluates the reciprocating one-file system in undergraduate education. Materials and methods A total of 42 undergraduate students without experience regarding reciprocating file systems filled in a questionnaire in four different points in time (t 1-t 4) anonymously. The questionnaire was based on a numerical rating scale ranging from 0 to 10. Statistical analysis A least significant difference post-hoc analysis comparing the group average values was performed. The adjusted level of significance was p less then 0.004 after Bonferroni correction. Results All rating scores increased after the first theoretical instruction. After the first practical training in artificial root canals in resin blocks and extracted teeth (t 2), the estimation of "time efficiency" (p = 0.002), "handling" (p less then 0.001), and "overall impression" (p less then 0.001) improved significantly. The "overall impression" remained constant and showed no significant changes after the first practical training. Conclusions Reciprocating systems seem to show a good acceptance among first time users. Initial concerns about "work safety" decrease during every step of the educational process. Reciprocating one-file systems are a safe and well-accepted method in undergraduate teaching.Objectives This study aimed at assessing the effect of the addition of silver nanoparticles (SNPs) to a silicone soft liner on its tensile bond strength to denture base resin. Materials and methods SNPs were added to Mucopren cold cure soft liner in 0 (control), 0.5, 1, 2, and 3 wt% concentrations and bonded in 120 stainless steel molds with processed heat cure acrylic resin blocks. Liner/resin combination samples were divided into two groups. The first half was stored for 2 days in distilled water at 37°C and then subjected to tensile bond strength, while the other half were thermocycled 3000 times before testing. Mean bond strength, expressed in mega pascals (MPa), was determined in the tensile test with the use of a universal testing machine at a crosshead speed of 5 mm/min. Statistical analysis Data were analyzed using SPSS via one-way analysis of variance test, t-test, and Tukey's posthoc, at a 95% confidence level (p less then 0.05). Results Addition of SNPs and thermocycling both caused a significant reduction in the tensile bond strength of Mucopren to acrylic resin; however, in the thermocycled group, the bond strength increased with the increase in the concentration of SNPs (p less then 0.001). Conclusion Addition of SNPs to Mucopren soft silicone liner reduces its tensile bond strength to denture acrylic resin.Objective The purpose of this study was to evaluate and compare the axial inclination of the mandibular first molars and their respective bone morphology among individuals with different facial patterns. Materials and methods The sample comprised the cone beam computed tomographies (CBCTs) of 58 subjects divided into three groups according to the facial patterns 18 brachyfacial (Group 1), with a mean age of 21.58 years; 23 mesofacial (Group 2), with a mean age of 19.14 years; and 17 dolichofacial subjects (Group 3), with a mean age of 19.09 years. Eight variables were evaluated on CBCT scans of each subject buccal and lingual mandibular height, cervical and middle mandibular width, inclination of mandibular body, inclination of the mandibular molar buccal surface, molar width, molar angulation and tooth/bone angle. Intergroup comparisons were performed with one-way analysis of variance followed by Tukey tests. Results Buccal mandibular height presented statistically significant difference in the three facial patterns. Lingual mandibular height and mandibular inclination showed to be statistically and significantly smaller in brachyfacial subjects than in the other two groups. Mandibular width presented a statistically significant difference between brachyfacial and mesofacial groups. Negative correlations could be observed between the facial pattern and the buccal and lingual mandibular heights and inclination of the mandibular body. Conclusion Buccal mandibular height was significantly and progressively larger in brachyfacial, mesofacial, and dolichofacial subjects. Lingual mandibular height was significantly smaller in brachyfacial than in mesofacial and dolichofacial subjects. Mandibular width was significantly thicker in brachyfacial than in mesofacial subjects. Brachyfacial subjects had smaller mandibular inclination than mesofacial and dolichofacial subjects.