Holmanmclaughlin2377

Further, hydrogenotrophic methanogens, including Methanobacterium and Methanolinea, produced methane via H2.MIL-53(Fe) was successfully prepared and deposited on the surface carboxylated polyester (PET) fiber by an optimized conventional solvothermal or industrialized high temperature pressure exhaustion (HTPE) process to develop a PET fiber supported MIL-53(Fe) photocatalyst (MIL-Fe@PET) for the degradation of polyvinyl alcohol (PVA) in water under light emitting diode (LED) visible irradiation. On the basis of several characterizations, MIL-Fe@PET was tested for the photocalytic ability and degradation mechanism. It was found that temperature elevation significantly enhanced the formation and deposition of MIL-53(Fe) with better photocatalytic activity. However, higher temperature than 130°C was not in favor of its photocatalytic activity. Increasing the number of surface carboxyl groups of the modified PET fiber could cause a liner improvement in MIL-53(Fe) loading content and photocatalytic ability. High visible irradiation intensity also dramatically increased photocatalytic ability and PVA degradation efficiency of MIL-Fe@PET. Na2S2O8 was used to replace H2O2 as electron acceptor for further promoting PVA degradation in this system. MIL-Fe@PET prepared by HTPE process showed higher MIL-53(Fe) loading content and slightly lower PVA degradation efficiency than that prepared by solvothermal process at the same conditions. These findings provided a practical strategy for the large-scale production of the supported MIL-53(Fe) as a photocatalyst in the future.Landfill leachate is a complex effluent and it is difficult to deal with. Electrochemical methods have been considered as a promising alternative technology for treatment of landfill leachate with refractory organic contaminants and heavy metals. Peroxi-coagulation (PC) process with iron anode and modified graphite felt cathode was developed for efficient landfill leachate concentrate treatment. Compared to electro-Fenton (EF) and electrocoagulation (EC) processes, the PC process was more cost-effective due to the combined action of •OH oxidation and iron hydroxides coagulation. A maximal TOC removal of 77.2% ± 1.4% was obtained after 360 min at initial pH = 5.0 and current density of 10 mA/cm2. After the PC process, concentrations of all seven heavy metals in the final effluents were below the allowable emission limits given by the present regulatory standards. The method preference for heavy metal removal was PC > EC > EF. Based on the three-dimensional fluorescence spectroscopy coupled with regional integration analysis during the PC treatment, the florescence peaks of both humic acids and fulvic acids disappeared after treatment for 360 min. Decreasing trends were observed in the fluorescent regional standard volumes for aromatic protein I (31.4%), aromatic protein II (63.7%), fulvic acid-like (69.5%), soluble microbial by-product-like (75%) and humic acid-like regions (76.3%). The results indicate that comparing to the EF and EC process, the PC process provide a promising and more cost-effective alternative for the treatment of landfill leachate concentrate.Hexafluoropropylene oxide trimer acid (HFPO-TA), an emerging replacement of perfluorooctanoic acid (PFOA), has recently been reported to be a potential environmental contaminant. Due to the similar structure to PFOA, HFPO-TA may cause comparable adverse effects on human health. Therefore, evaluating the toxic profiles of HFPO-TA has become an urgent task. In this study, we investigated the cytotoxicity and hepatoxicity of HFPO-TA using human embryonic stem cell (hESC)-based assays. Results showed that HFPO-TA reduced hESCs' viability in a dose dependent manner, and the calculated IC50 for 24, 48 and 72 hr were 222.8, 167.4, and 80.6 μmol/L, respectively. Significant intracellular ROS accumulation and mitochondrion membrane potential reduction were detected with HFPO-TA exposure, and increased apoptotic/necrotic cells were also observed in high dose of HFPO-TA treated group. Moreover, HFPO-TA at noncytotoxic concentrations also significantly impaired the functions of induced hepatocytes by diminishing cell glycogen storage ability and deregulating specific functional genes. Transcriptome sequencing analysis identified a set of hepatic associated biological processes responding to HFPO-TA exposure. PPAR was the most significantly enriched pathway. Genes including FGA, FGB, FGG, AHSG, HRG, ITIH2, ALB were characterized as hub genes by cytoHubba plug-in. These data indicated that HFPO-TA is a potential hepatotoxicant, and may not be a safe replacement for PFOA.The reaction of Cl atoms with two C5 aldehydes (3-methyl-2-butenal and 3-methylbutanal) were investigated by proton-transfer-reaction mass spectrum (PTR-MS) using smog chamber at 298 ± 1 K and 760 Torr. A relative rate method was used to determine the rate constants of the title reactions with m-xylene and trans-2-butene as reference compounds (3.04 ± 0.18)  ×  10-10 and (2.07 ± 0.14)  ×  10-10 cm3/(molecule⋅sec) for 3-methyl-2-butenal and 3-methylbutanal, respectively. Additionally, the gas-phase products were also identified by PTR-MS, and the possible reaction mechanisms were proposed basing on the identified products. The detected gas-phase products are similar for two C5 aldehydes reactions, mainly including small molecules of aldehydes, ketones and chlorinated aldehyde compounds. The atmospheric lifetimes (τ) calculated for 3-methyl-2-butenal (τ = 7.0 hr, marine boundary layer (MBL)) and 3-methylbutanal (τ = 10.3 hr, MBL) according to the obtained rate constants. The results indicate that Cl atoms at MBL are competitive with OH radicals for the degradation contribution of C5 aldehyde compounds.The characteristics of dissolved organic matter (DOM) can significantly affect the degradation of target compounds by the advanced oxidation processes. In this study, the effects of the different hydrophobicity/hydrophilicity fractions, molecular weight (MW) fractions, fluorescence components and molecular components of DOM extracted from municipal wastewater on the degradation of 4 pharmaceutically active compounds (PhACs), including carbamazepine, clofibric acid, atenolol and erythromycin by the UV/H2O2 process were investigated. The results showed that the degradation rate constants of 4 PhACs decreased dramatically in the presence of DOM. Axitinib VEGFR inhibitor The linear regressions of 4 PhACs degradation as a function of specific fluorescence intensity (SFI) are exhibited during the degradation of 4 PhACs and the SFI may be used to evaluate effect of DOM on target compounds in wastewater. The hydrophobic acid (HPO-A) exhibited the strongest inhibitory effect on degradation of 4 PhACs during oxidation process. The small MW fractions of DOM significantly inhibited the degradation of 4 PhACs during oxidation process. Among three fluorescence components, hydrophobic humic-like substances may significantly inhibit the degradation of 4 PhACs during oxidation process. At the molecular level, the formulas may be derived from terrestrial sources. CHO compound may significantly inhibit the degradation of 4 PhACs during oxidation process on formula classes. The unsaturated hydrocarbons, carbohydrates and tannins compounds may significantly inhibit the effectiveness of the UV/H2O2 process on compound classes.Catalytic combustion is thought as an efficient and economic pathway to remove volatile organic compounds, and its critical issue is the development of high-performance catalytic materials. In this work, we used the in situ synthesis method to prepare the silicalite-1 (S-1)-supported Pd nanoparticles (NPs). It is found that the as-prepared catalysts displayed a hexagonal prism morphology and a surface area of 390-440 m2/g. The sample (0.28Pd/S-1-H) derived after reduction at 500°C in 10 vol% H2 showed the best catalytic activity for toluene combustion (T50% = 180°C and T90% = 189°C at a space velocity of 40,000 mL/(g·hr), turnover frequency (TOFPd) at 160°C = 3.46 × 10-3 sec-1, and specific reaction rate at 160°C = 63.8 µmol/(gPd·sec)), with the apparent activation energy (41 kJ/mol) obtained over the best-performing 0.28Pd/S-1-H sample being much lower than those (51-70 kJ/mol) obtained over the other samples (0.28Pd/S-1-A derived from calcination at 500°C in air, 0.26Pd/S-1-im derived from the impregnation route, and 0.27Pd/ZSM-5-H prepared after reduction at 500°C in 10 vol% H2). Furthermore, the 0.28Pd/S-1-H sample possessed good thermal stability and its partial deactivation due to CO2 or H2O introduction was reversible, but SO2 addition resulted in an irreversible deactivation. The possible pathways of toluene oxidation over 0.28Pd/S-1-H was toluene → p-methylbenzoquinone → maleic anhydride, benzoic acid, benzaldehyde → carbon dioxide and water. We conclude that the good dispersion of Pd NPs, high adsorption oxygen species concentration, large toluene adsorption capacity, strong acidity, and more Pd0 species were responsible for the good catalytic performance of 0.28Pd/S-1-H.Soil formation and ecological rehabilitation is the most promising strategy to eliminate environmental risks of bauxite residue disposal areas. Its poor physical structure is nevertheless a major limitation to plant growth. Organic materials were demonstrated as effective ameliorants to improve the physical conditions of bauxite residue. In this study, three different organic materials including straw (5% W/W), humic acid (5% W/W), and humic acid-acrylamide polymer (0.2% and 0.4%, W/W) were selected to evaluate their effects on physical conditions of bauxite residue pretreated by phosphogypsum following a 120-day incubation experiment. The proportion of 2-1 mm macro-aggregates, mean weight diameter (MWD) and geometric mean diameter (GWD) increased following organic materials addition, which indicated that organic materials could enhance aggregate stability. Compared with straw, and humic acid, humic acid-acrylamide polymer application had improved effects on the formation of water-stable aggregates in the residues. Furthermore, organic materials increased the total porosity, total pore volume and average pore diameter, and reduced the micropore content according to nitrogen gas adsorption (NA) and mercury intrusion porosimetry (MIP) analysis, whilst enhancing water retention of the residues based on water characteristic curves. Compared with traditional organic wastes, humic acid-acrylamide polymer could be regarded as a candidate according to the comprehensive consideration of the additive amount and the effects on physical conditions of bauxite residue. These findings could provide a novel application to both Ca-contained acid solid waste and high-molecular polymers on ecological rehabilitation at disposal areas.Freshwater reservoirs are regarded as an important anthropogenic source of methane (CH4) emissions. The temporal and spatial variability of CH4 emissions from different reservoirs results in uncertainty in the estimation of the global CH4 budget. In this study, surface water CH4 concentrations were measured and diffusive CH4 fluxes were estimated via a thin boundary layer model in a temperate river-reservoir system in North China, using spatial (33 sites) and temporal (four seasons) monitoring; the system has experienced intensive aquaculture disturbance. Our results indicated that the dissolved CH4 concentration in the reservoir ranged from 0.07 to 0.58 µmol/L, with an annual average of 0.13 ± 0.10 µmol/L, and the diffusive CH4 flux across the water-air interface ranged from 0.66 to 3.61 μmol/(m2•hr), with an annual average of 1.67 ± 0.75 μmol/(m2•hr). During the study period, the dissolved CH4 concentration was supersaturated and was a net source of atmospheric CH4. Notably, CH4 concentration and diffusive flux portrayed large temporal and spatial heterogeneity.