Hermanhatcher6337

Typical ranges of thermal expansion coefficients are established for organic molecular crystals in the Cambridge Structural Database. The CSD Python API is used to extract 6201 crystal structures determined close to room temperature and at least one lower temperature down to 90 K. The data set is dominated by structure families with only two temperature points and is subject to various sources of error, including incorrect temperature reporting and missing flags for variable-pressure studies. For structure families comprising four or more temperature points in the range 90-300 K, a linear relationship between unit-cell volume and temperature is shown to be a reasonable approximation. For a selected subset of 210 structures showing an optimal linear fit, the volumetric expansion coefficient at 298 K has mean 173 p.p.m. K-1 and standard deviation 47 p.p.m.  K-1. The full set of 6201 structures shows a similar distribution, which is fitted by a normal distribution with mean 161 p.p.m. K-1 and standard deviation 51 p.p.m. K-1, with excess population in the tails mainly comprising unreliable entries. The distribution of principal expansion coefficients, extracted under the assumption of a linear relationship between length and temperature, shows a positive skew and can be approximated by two half normal distributions centred on 33 p.p.m. K-1 with standard deviations 40 p.p.m. K-1 (lower side) and 56 p.p.m. K-1 (upper side). The distribution for the full structure set is comparable to that of the test subset, and the overall frequency of biaxial and uniaxial negative thermal expansion is estimated to be less then  5% and ∼30%, respectively. A measure of the expansion anisotropy shows a positively skewed distribution, similar to the principal expansion coefficients themselves, and ranges based on suggested half normal distributions are shown to highlight literature cases of exceptional thermal expansion.The structures of three iodochalcones, functionalized with fluorine or a nitro group, have been investigated to explore the impact of different molecular electrostatic distributions on the halogen bonding within each crystal structure. The strongly withdrawing nitro group presented a switch of the halogen bond from a lateral to a linear motif. Surprisingly, this appears to be influenced by a net positive shift in charge distribution around the lateral edges of the σ-hole, making the lateral I...I bonding motif less preferable. A channel of amphoteric I...I type II halogen bonds is observed for a chalcone molecule, which was not previously reported in chalcones, alongside an example of the common synthon involving extended linear chains of I...O2N donor-acceptor halogen bonds. This work shows that halogenated chalcones may be an interesting target for developing halogen bonding as a significant tool within crystal engineering, a thus far underexplored area for this common structural motif.The structures of polycrystalline Ca3RE2(BO3)4 (RE = La, Pr, Nd, Sm, Gd, Tb, Dy, Ho, Er, Y; space group Pnma) orthoborates were determined using powder X-ray diffraction. Trends in the unit-cell dimensions and yet unreported trends in other structural properties (interatomic distances and the fractional occupation of three Ca/RE sites) for these compounds are demonstrated as a function of RE ionic radius. The unit-cell volume and a unit-cell parameter present a linear dependence, while the b and c unit-cell parameters change in a nonlinear manner. For the whole series, the RE atoms are present at all three cationic sites (labelled as M1, M2 and M3), but the fractional occupancies depend on the RE ionic radius. The small rare-earth atoms tend to enter mainly the M3 site; for the larger rare earths, the occupancy of this site decreases sharply. The occupancy of the M1 site by RE atoms is around 0.5 and tends to increase with increasing RE ionic radius. The M2 site is the least preferentially occupied by RE ions, but the occupancy discernibly increases with rising radius as well. These findings are assembled with properties of isostructural strontium and barium borates, allowing prediction of occupancy schemes for not yet investigated compounds from the A3RE2(BO3)4 (A = Ca, Ba, Sr).The X-ray crystal structure of the d(CGCGCG)2/putrescine(2+)/K+ complex has been determined at 0.60 Å resolution. Selleckchem Colcemid Stereochemical restraints were used only for the putrescinium dication, and 23 bonds and 18 angles of the Z-DNA nucleotides with dual conformation. The N atoms of the putrescine(2+) dication form three direct hydrogen bonds with the N7_G atoms of three different Z-DNA molecules, plus three water-mediated hydrogen bonds with cytosine, guanine and phosphate acceptors. A unique potassium cation was also unambiguously identified in the structure, albeit at a ∼0.5 occupation site shared with a water molecule, providing the first example of such a complex with Z-DNA. The K+ cation has coordination number of eight and an irregular coordination sphere, formed by four water molecules and four O atoms from two phosphate groups of the Z-DNA, including ligands present at fractional occupancy. The structural disorder of the Z-DNA duplex is manifested by the presence of alternate conformations along the DNA backbone. Comparison of the position and interactions of putrescine(2+) in the present structure with other ultra-high-resolution structures of Z-DNA in complexes with Mn2+ and Zn2+ ions shows that the dicationic putrescinium moiety can effectively substitute these metal ions for stabilization of Z-type DNA duplexes. Furthermore, this comparison also suggests that the spermine(4+) tetracation has a higher affinity for Z-DNA than K+.(S)-(-)-1-Phenylethanaminium 4-(2,4,6-triisopropylbenzoyl)benzoate (S-PEATPBB) undergoes a photochemical reaction in its crystalline form upon UV irradiation and forms three different products the first product is the result of a Yang cyclization with the participation of the δ-H atom of o-isopropyl (product D) and the second and third products are obtained via a Norrish-Yang reaction with the involvement of the γ-H atom of 2-isopropyl (product P) and 6-isopropyl (product Z). These products are formed in different proportions (D > P >> Z). The path and kinetics of the reaction were monitored step-by-step using crystallographic methods, both under ambient and high-pressure conditions. The reactivity of S-PEATPBB depends strongly on the geometry of the reaction centre and the volume of the reaction cavity. Due to the geometrical preferences making the cyclization reaction easier to proceed, product D dominates over the other products, while the formation of product Z becomes difficult or almost impossible at high pressure.