Hanssonshelton5940

Activating upconversion nanoparticle-based photoresponsive nanovectors (UCPNVs) by upconversion visible light at low-power near-infrared (NIR) excitation can realize deeper biotissue stimulation with a minimized overheating effect and photodamage. Here, we demonstrate a facile strategy to construct new surface-decorated UCPNVs based on Passerini three-component reaction (P-3CR) in highly convenient and effective manners. Such UCPNVs materials have a tailored deprotecting wavelength that overlaps upconversion blue light. By using 3-perylenecarboxaldehyde, Tm3+/Yb3+ ion-doped UCNP-containing isocyanides, and antitumor agent chlorambucil as the three components, the resulting monodisperse UCPNV exhibits an efficient release of caged chlorambucil under a very low 976 nm power. This approach expands the synthetic toolbox to enable quick development of UCPNVs for UCNP-assisted low-power NIR photochemistry.We demonstrated a facile yet effective strategy for self-assembly of polymer end-tethered gold nanorods (GNRs) into tunable two-dimensional (2D) arrays with the assistance of supramolecules of hydrogen bonded poly(4-vinyl pyridine) (P4VP) and 3-n-pentadecylphenol (PDP). Well-ordered 2D arrays with micrometer size were obtained by rupturing the assembled supramolecular matrix with a selective solvent. The formation of long-range ordered 2D arrays during a drying process was observed via small-angle X-ray scattering. Interestingly, the packing structure of the ordered arrays strongly depends on the molecular weight (Mw) of the polymer ligands and the size of the GNRs. By increasing Mw of the polymer ligands, tilted arrays can be obtained. The average angle between GNRs and the surface normal direction of the layered 2D arrays changes from 0 to 37° with the increase in Mw of the polymer ligands. A mechanism for assembly behavior of dumbbell shapes with a soft shell structure has been proposed. The resulting GNR arrays with different orientations showed anisotropic surface-enhanced Raman scattering (SERS) performance. We showed that the vertically ordered GNR arrays exhibited ∼3 times higher SERS signals than the tilt ordered arrays. The results prove that the polymer end-tethered GNRs can be used as a building block for preparing the tilted 2D arrays with tunable physicochemical properties, which could have a wide range of potential applications in photonics, electronics, plasmonics, etc.Communication between neurons relies on the release of diverse neurotransmitters, which represent a key-defining feature of a neuron's chemical and functional identity. Neurotransmitters are packaged into vesicles by specific vesicular transporters. However, tools for labeling and imaging synapses and synaptic vesicles based on their neurochemical identity remain limited. We developed a genetically encoded probe to identify glutamatergic synaptic vesicles at the levels of both light and electron microscopy (EM) by fusing the mini singlet oxygen generator (miniSOG) probe to an intralumenal loop of the vesicular glutamate transporter-2. We then used a 3D imaging method, serial block-face scanning EM, combined with a deep learning approach for automatic segmentation of labeled synaptic vesicles to assess the subcellular distribution of transporter-defined vesicles at nanometer scale. These tools represent a new resource for accessing the subcellular structure and molecular machinery of neurotransmission and for transmitter-defined tracing of neuronal connectivity.Ternary oxide nanoparticles have attracted much interest because of their intriguing properties, which are not exhibited by binary oxide nanoparticles. However, the synthesis of ternary oxide nanoparticles is not trivial and requires a fundamental understanding of the complicated precursor chemistry that governs the formation mechanism. Herein, we investigate the role of the chemical composition of precursors in the formation of ternary oxide nanoparticles via a combination of mass spectrometry, electron microscopy with elemental mapping, and thermogravimetric analysis. Mn2+, Co2+, and Ni2+ ions easily form bimetallic-oxo clusters with Fe3+ ions with a composition of MFe2O(oleate)6 (M = Mn, Co, Ni). The use of clusters as precursors leads to the successful synthesis of monodisperse metal ferrite nanoparticles (MFe2O4). On the contrary, zinc- or copper-containing complexes are formed independently from iron-oxo clusters in the precursor synthesis. The mixture of complexes without a bimetallic-oxo core yields a mixture of two different nanoparticles. This study reveals the importance of the precursor composition in the synthesis of ternary oxide nanoparticles.Affinity purification coupled to mass spectrometry (AP-MS) is a popular approach for deciphering the architecture of protein interaction networks. Protein lysates (100 μg) are typically required for multistep sample processing in large volumes, which often causes sample loss and reduces the MS analysis sensitivity. Herein, we reported a fully integrated spintip-based AP-MS technology, termed FISAP, for multiplexed and sensitive interactome profiling. The FISAP device can be easily employed for routine use by introducing AP beads into a C18 StageTip. Taking advantage of the switchable functionalization of the C18 matrix by sodium dodecyl sulfate, all the sample preparation steps encompassing peptide or antibody-based AP, reduction, alkylation, tryptic digestion, tandem mass tag (TMT) labeling, and desalting can be performed in a single tip with a benchtop centrifuge in 4 h. Using a biotinylated tyrosine phosphorylated (pTyr) peptide as an affinity ligand, we mapped the pTyr-dependent interactome of the pY191 mn biomedical research and chemical biology.With the explosive development of smart wearable devices, a serious situation that a large amount of energy waste and environmental pollution caused by electronic discarding needs to be solved urgently. Here, as a throwaway waste material, a chewed gum can be reused for the preparation of wearable iontronics simply. A new gum sensor was constructed by regularly stretching a chewed gum in 6 M NaCl aqueous or even a Chinese edible salt solution for increasing the ionic conductivity. This gum sensor can be shaped arbitrarily, and the preparation process is green, pollution-free, with low energy consumption, and repeatable. Herein, this gum sensor can be utilized for real-time human healthcare monitoring effectively (i.e., facial mood changes, finger flexion, long time walking, and continuous ankle movement) and shows a fast response time of 297 ms and a reliable cycling performance in monitoring body motions. Selleckchem A-1210477 Furthermore, the gum sensor (containing edible salt) can act as a signal transmitter for intelligent information encryption and transmission in the light of the international Morse code with excellent repeatability and stability. Hence, this work will greatly possess wide potential application prospects in wearable electronics and information encryption. This gum sensor also provides a ponderable option in the next generation of artificial intelligence devices, which can address the troubles of material selections in sensor preparation.We designed and synthesized several families of novel amphiphilic fluorescent phosphorus dendron-based micelles showing relevant antiproliferative activities for use in the field of theranostic nanomedicine. Based on straightforward synthesis pathways, 12 amphiphilic phosphorus dendrons bearing 10 protonated cyclic amino groups (generation one), or 20 protonated amino groups (generation two), and 1 hydrophobic chain carrying 1 fluorophore moiety were created. The amphiphilic dendron micelles had the capacity to aggregate in solution using hydrophilic/hydrophobic interactions, which promoted the formation of polymeric micelles. These dendron-based micelles showed moderate to high antiproliferative activities against a panel of tumor cell lines. This paper presents for the first time the synthesis and our first investigations of new phosphorus dendron-based micelles for cancer therapy applications.We report observations of a strong thickness dependence for charge transfer (CT) from MoSe2 to MoS2, as evidenced by transient absorption measurements. By time-resolving CT from MoSe2 monolayers (1Ls) to MoS2 flakes of varying thicknesses, including 1L, bilayer (2L), and trilayer (3L), we find that the CT time is several picoseconds in the 1L-MoSe2/3L-MoS2 heterostructure, which is much longer than that of 1L-MoSe2/1L-MoS2 and 1L-MoSe2/2L-MoS2 heterostructures. In addition, the recombination lifetime of the interlayer excitons in the 1L/3L heterostructure is several times longer than that of 1L/1L and 1L/2L heterostructures, reaching 800 ps. Furthermore, we show that a prepulse can reduce the CT time and enhance the interlayer exciton recombination in the 1L/3L heterostructure. These findings illustrate that layer thickness can be an important parameter to control the CT property of van der Waals heterostructures. These experimental results also provide important information for further refining the understanding of the physical mechanisms of CT in van der Waals heterostructures.Multisomes are multicompartmental structures formed by a lipid-stabilized network of aqueous droplets, which are contained by an outer oil phase. These biomimetic structures are emerging as a versatile platform for soft matter and synthetic biology applications. While several methods for producing multisomes have been described, including microfluidic techniques, approaches for generating biocompatible, monodisperse multisomes in a reproducible manner remain challenging to implement due to low throughput and complex device fabrication. Here, we report on a robust method for the dynamically controlled generation of multisomes with controllable sizes and high monodispersity from lipid-based double emulsions. The described microfluidic approach entails the use of three different phases forming a water/oil/water (W/O/W) double emulsion stabilized by lipid layers. We employ a gradient of glycerol concentration between the inner core and outer phase to drive the directed osmosis, allowing the swelling of lamellar lipid layers resulting in the formation of small aqueous daughter droplets at the interface of the inner aqueous core. By adding increasing concentrations of glycerol to the outer aqueous phase and subsequently varying the osmotic gradient, we show that key structural parameters, including the size of the internal droplets, can be specifically controlled. Finally, we show that this approach can be used to generate multisomes encapsulating small-molecule cargo, with potential applications in synthetic biology, drug delivery, and as carriers for active materials in the food and cosmetics industries.

Body mass reduction in overweight and obese people so as to reduce blood pressure, low‑density lipoprotein cholesterol level, and the risk of type 2 diabetes as well as to lower the risk of recurrent cardiovascular events is strongly recommended in current guidelines.

To evaluate changes in body mass index (BMI) and waist circumference in patients with established coronary artery disease over a 20‑year period (1997-2017).

Consecutive patients younger than 71 years of age and hospitalized for acute coronary syndrome or myocardial revascularization procedures were recruited and interviewed 6 to 18 months after their discharge from hospital. Weight, height, and waist circumference were measured in 1997 to 1998, 1999 to 2000, 2006 to 2007, 2011 to 2013, and 2016 to 2017. The same 5 hospitals took part in the surveys each time.

We examined 412 patients in 1997 to 1998 (survey 1), 427 in 1999 to 2000 (survey 2), 422 in 2006 to 2007 (survey 3), 462 in 2011 to 2013 (survey 4), and 272 in 2016 to 2017 (survey 5).