Frasermclean8387

2D topological insulator edge states are considered within the Volkov-Pankratov Hamiltonian. A smooth transition between a topological and ordinary insulator is assumed. The edge states are formed in the total gap of homogeneous 2D material. DOTAP chloride chemical We found the energy spectrum, wave functions, together with the matrix elements of the impurity potential, and the velocity operator between these states. A pair of states have linear dispersion (the Weyl states), others have gapped Dirac spectra. Optical selection rules are found. It is stated that the Weyl states do not experience the backscattering, while the elastic scattering is permitted between the Dirac states or between the Weyl and Dirac states.Methylene blue (MB) is one of the most dangerous dyes found in numerous industries' wastewaters. Thus, the effect of suspended Pt nanoparticles (NPs) on the adsorption capability of TiO2NPs towards MB was investigated in this research. Factors affecting (adsorbate initial concentration, agitation time, solution pH, and temperature) the adsorption capacity of MB on the modified TiO2NPs were also studied. It was found that the first two factors have a positive effect, the temperature has an adverse impact, and the maximum uptake was observed when pH is 11. Isotherm parameters of Langmuir, Freundlich, and Timken models were determined. Langmuir's model was found to be the best one for analyzing the experimental data. The adsorption capacities obtained were 100.61, 90.66, and 80.26 mg g-1at 25 °C, 40 °C, and 55 °C, respectively. 1storder, 2ndorder, and intra-particle diffusion kinetic models were utilized to analyze experimental data. It found that these data were explained well by the 2ndorder model, indicating that this adsorption is chemisorption. Thermodynamic parameters were also determined, and the results obtained suggest that this adsorption is an exothermic and spontaneous process. The findings show that TiO2NPs modified by suspended Pt NPs will get a strong attraction in the treatment of fluids and wastewaters.Purpose.Electronic portal image devices (EPIDs) have been investigated previously for beams-eye view (BEV) applications such as tumor tracking but are limited by low contrast-to-noise ratio and detective quantum efficiency. A novel multilayer imager (MLI), consisting of four stacked flat-panels was used to measure improvements in fiducial tracking during liver stereotactic body radiation therapy (SBRT) procedures compared to a single layer EPID.Methods.The prototype MLI was installed on a clinical TrueBeam linac in place of the conventional DMI single-layer EPID. The panel was extended during volumetric modulated arc therapy SBRT treatments in order to passively acquire data during therapy. Images were acquired for six patients receiving SBRT to liver metastases over two fractions each, one with the MLI using all 4 layers and one with the MLI using the top layer only, representing a standard EPID. The acquired frames were processed by a previously published tracking algorithm modified to identify implanted radiopaque fiducials. Truth data was determined using respiratory traces combined with partial manual tracking. Results for 4- and 1-layer mode were compared against truth data for tracking accuracy and efficiency. Tracking and noise improvements as a function of gantry angle were determined.Results. Tracking efficiency with 4-layers improved to 82.8% versus 58.4% for the 1-layer mode, a relative improvement of 41.7%. Fiducial tracking with 1-layer returned a root mean square error (RMSE) of 2.1 mm compared to 4-layer RMSE of 1.5 mm, a statistically significant (p less then 0.001) improvement of 0.6 mm. The reduction in noise correlated with an increase in successfully tracked frames (r = 0.913) and with increased tracking accuracy (0.927).Conclusion. Increases in MV photon detection efficiency by utilization of a MLI results in improved fiducial tracking for liver SBRT treatments. Future clinical applications utilizing BEV imaging may be enhanced by including similar noise reduction strategies.A new two-dimensional carbon-based material consisting of pentagonal and hexagonal elements is identified by numerical experiments, which is called phgraphene and possesses not only a tunable semimetallic feature but also a direction-dependent even sign-changed Poisson's ratio. The structural stability of such a new material is first checked systematically. It is found that phgraphene has a similar energy as theγ-graphyne, a thermally stable structure from the room temperature to 1500 K, and elastic constants satisfying the Born-Huang criterion. Both the band structure and density of states are further verified with different techniques, which demonstrate a Dirac semimetallic characteristic of phgraphene. A more interesting finding is that the band structure can be easily tuned by an external loading, resulting in the transition from semimetal to semiconductor or from type I to type III. As a new material that may be applied in the future, the mechanical property of phgraphene is further evaluated. It shows that phgraphene is a typically anisotropic material, which has not only direction-dependent Young's moduli but also direction-dependent even sign-changed Poisson's ratios. The microscopic mechanisms of both the electrical and mechanical properties are revealed. Such a versatile material with tunable band structure and auxetic effect should have promising applications in the advanced nano-electronic field in the future.Photocatalytic production of H2O2from water and atmospheric oxygen has been recognized as a green and sustainable chemical process, due to the abundance of raw materials and sustainable solar energy. Herein, flower-like hierarchical ZnO microspheres were prepared by hydrothermal method followed by calcination at different temperatures, and their photocatalytic performance in H2O2production was examined under simulated sunlight irradiation. The calcination temperature plays a vital role in the structure, morphology, and surface area of the final ZnO products as well as their optical and electrochemical properties, which are determining factors in their photocatalytic activity. The ZnO calcined at 300 °C (Zn-300) exhibits the highest activity and optimal stability, showing productivity of 2793μmol l-1within 60 min of irradiation, which was 6.5 times higher than that of uncalcined ZnO precursor. The remarkable photocatalytic activity is attributed to enhanced light utilization, large surface area, abundant exposed active sites, improved separation efficiency, and prolonged carrier lifespan.