Davismaxwell1125

Careful land management and fertilizer use are necessary to avoid nitrate pollution in the karst agroecosystem, for example by timing fertilizer applications to allow for plant uptake of nitrate before rainfall can flush it from the soils into the karst and ultimately into catchment drainage.Antifouling paints are biocidal products applied to ship and boat hulls in order to prevent the growth and settlement of marine organisms, i.e. fouling. The release of biocides from the surface of the paint film act to repel or poison potential settling organisms. Currently, the most commonly used biocide in antifouling paints is cuprous oxide. In the EU, antifouling products are regulated under the Biocidal Products Regulation (BPR), which states that the recommended dose should be the minimum necessary to achieve the desired effect. For antifouling products, the dose is measured as the release rate of biocide(s) from coating. In this study, the release rates of copper and zinc from eight different coatings for leisure boats were determined through static exposure of coated panels in four different harbors located in Swedish waters along a salinity gradient ranging from 0 to 27 PSU. The results showed the release rate of copper to increase with increasing salinity. Paints with a higher content of cuprous oxide were also found to release larger amounts of copper. The coatings' ability to prevent biofouling was also evaluated and no significant difference in efficacy between the eight tested products was observed at the brackish and marine sites. Hence, the products with high release rates of copper were equally efficient as those with 4 - 6 times lower releases. These findings suggest that current antifouling paints on the market are leaching copper in excess of the effective dose in brackish and marine waters. Additionally, the results from the freshwater site showed no benefit in applying a copper-containing paint for the purpose of fouling prevention. This indicates that the use of biocidal paints in freshwater bodies potentially results in an unnecessary release of copper. By reducing the release rates of copper from antifouling paints in marine waters and restricting the use of biocidal paints in freshwater, the load of copper to the environment could be substantially reduced.Traditional bioenergy recovery in the form of short chain fatty acids (SCFAs) from waste activated sludge (WAS) is generally limited by economic unattractiveness and complexity of products separation. Herein, a novel biotechnology process of two-stage anaerobic fermentation for converting the WAS into high energy density, easy-separated medium chain fatty acids (MCFAs) and long-chain alcohols (LCAs) was evaluated. In this process, the WAS was first converted to WAS alkaline fermentation liquid (WASAFL), serving as electron acceptors (EAs) and inoculum, then adding ethanol as electron donor (ED) for chain elongation (CE). The co-production of MCFAs and LCAs during CE were studied under three different ED to EA ratios, i.e., 31, 41 and 51. Experimental results demonstrated that when the ratio of ED to EA increased from 31 to 51, the production of MCFA and LCAs respectively increased from 5.57 ± 0.17 and 2.58 ± 0.18 to7.67 ± 0.48 and 4.21 ± 0.19 g COD/L. A similar observation was made in the total product electron efficiency, increasing from 59.9% to 72.1%. However, the highest total product selectivity (i.e., 68.0%) and highest products production yield (i.e., 59.77%) were not achieved at the ED to EA ratio of 51 due to toxicity caused by higher accumulation of n-caproate. The kinetic analysis further confirmed that high ratio of ED to EA induced improvement in product maximum yield, production rate for both MCFAs and LCAs. Microbial community analysis indicated that Clostridium, Caproiciproducens, Acinetobacter, Exilispira, and Oscillibacter were clearly enriched in the CE reactor and had positive correlation with MCFAs and LCAs production.Ammonia-oxidizing bacteria (AOB) of the betaproteobacterial genera Nitrosomonas and Nitrosospira are key nitrifying microorganisms in many natural and engineered ecosystems. learn more Since many AOB remain uncultured, fluorescence in situ hybridization (FISH) with rRNA-targeted oligonucleotide probes has been one of the most widely used approaches to study the community composition, abundance, and other features of AOB directly in environmental samples. However, the established and widely used AOB-specific 16S rRNA-targeted FISH probes were designed up to two decades ago, based on much smaller rRNA gene sequence datasets than available today. Several of these probes cover their target AOB lineages incompletely and suffer from a weak target specificity, which causes cross-hybridization of probes that should detect different AOB lineages. Here, a set of new highly specific 16S rRNA-targeted oligonucleotide probes was developed and experimentally evaluated that complements the existing probes and enables the specific detection and differentiation of the known, major phylogenetic clusters of betaproteobacterial AOB. The new probes were successfully applied to visualize and quantify AOB in activated sludge and biofilm samples from seven pilot- and full-scale wastewater treatment systems. Based on its improved target group coverage and specificity, the refined probe set will facilitate future in situ analyses of AOB.As an important raw material and intermediate of widely used antibiotics cefazolin and cefazedone, 2-mecapto-5-methyl-1,3,4-thiadizaole (MMTD) in antibiotic wastewater is hardly decyclized during wastewater treatment, posing great risk to the environment. This work proposed a green "coupling-oxidation" process to enhance ring-opening of MMTD during antibiotic wastewater treatment. In particular, the significant role of humic substances (HS) as pre-coupling reagent was emphasized. Real HS and different model HS, especially quinones, not only efficiently pre-coupled MMTD (>95%) but also promoted the MMTD removal by MnO2 (from 72.4% to 92.4%). Mass spectrometric analysis indicated that MMTD pre-coupled to HS would be oxidized with ring opening to environmental-friendly sulfonated HS, while direct oxidation of MMTD produced MMTD dimers or sulfonated MMTD that would not undergo ring opening. Theoretical calculations indicated that pre-coupling to HS enabled the ring-opening oxidation by increasing the nucleophilicity and decreasing ring-opening barrier of thiadiazole.