Bredahlmacias6421

Thus, all the parameters characterizing this complicated film were determined without any auxiliary methods.Holographic projection displays suffer from image blur when reconstructed from an incoherent light source like a light emitting diode. In this paper, we propose a method that enhances the reconstruction sharpness by pre-compensating the target image. The image blur caused by the incoherent nature of the light emitting diode is analyzed and the corresponding spatially varying point spread function is obtained. The pre-compensation is then performed using an iterative optimization algorithm. Finally, the hologram of the pre-compensated target image is loaded onto a spatial light modulator to obtain optically reconstructed image with reduced blur. The numerically simulated results and optically reconstructed results are in good agreement, showing feasibility of the proposed method.Potential advantages offered by multichannel luminaires with regards to spectral tuning are frequently overshadowed by its design challenges, a major one being the non-uniformity in illuminance and color distribution. In this paper, we present a formulation using genetic algorithm (GA) to optimize the Light Emitting Diode (LED) placement, yielding 40% superior uniformity in illuminance and color distributions compared to existing analytical formulations, substantially reducing the reliance on optical design for this purpose. It is specifically shown that our approach is employable for circadian tuning applications, even when heavily constrained by industry specifications on panel size and minimum LED separation.In this letter, the authors develop an optimized Seebeck nanoantenna design suitable for IR harvesting applications. The design is optimized via the so-called particle-swarm-optimization algorithm (PSO), an evolutionary algorithm able to drive the morphology of a nano-object towards an optimum. Along with the so-called nanoloading technique, efforts are subsequently addressed to understand the physical mechanisms behind the wave energy to voltage conversion, from both numerical and theoretical perspectives. In particular, the thermal and intrinsic impedance are considered to be the key issues beneath the device's response.A multi-physics null medium that performs as a perfect endoscope for both electromagnetic and acoustic waves is designed by transformation optics, which opens a new way to control electromagnetic and acoustic waves simultaneously. Surface transformation multi-physics, which is a novel graphical method to design multi-physics devices, is proposed based on the directional projecting feature of a multi-physics null medium. Many multi-physics devices, including beam shifters, scattering reduction, imaging devices and beam steering devices, for both electromagnetic and acoustic waves can be simply designed in a surface-corresponding manner. All devices designed by surface transformation multi-physics only need one homogeneous anisotropic medium (null medium) to realize, which can be approximately implemented by a brass plate array without any artificial sub-wavelength structures. Numerical simulations are given to verify the performances of the designed multi-physics devices made of brass plate array.This work presents the first demonstration of atmospheric temperature measurement using the differential absorption lidar (DIAL) technique. While DIAL is routinely used to measure atmospheric gases such as ozone and water vapor, almost no success has been found in using DIAL to measure atmospheric temperature. Attempts to measure temperature using a well-mixed gas like oxygen (O2) have largely failed based on a need for quantitative ancillary measurements of water vapor and atmospheric aerosols. Here, a lidar is described and demonstrated that simultaneously measures O2 absorption, water vapor number density, and aerosol backscatter ratio. This combination of measurements allows for the first measurements of atmospheric temperature with useful accuracy. DIAL temperature measurements are presented to an altitude of 4 km with 225 m and 30 min resolution with accuracy better than 3 K. DIAL temperature data is compared to a co-located Raman lidar system and radiosondes to evaluate the system's performance. Finally, an analysis of current performance characteristics is presented, which highlights pathways for future improvement of this proof-of-concept instrument.Ultrafast pulsed laser of high intensity and high repetition rate is the combined requisite for advancing strong-field physics experiments and calls for the development of thermal-stable ultrafast laser systems. Noncollinear phasing matching (PM) is an effective solution of optimizing the properties of optical parametric chirped pulse amplification (OPCPA) to achieve broadband amplification or to be temperature-insensitive. But as a cost, distinct noncollinear geometries have to be respectively satisfied. In this paper, a noncollinear quasi-phase-matching (QPM) scheme of both temperature- and wavelength-insensitive is presented. find more With the assistance of the design freedom of grating wave vector, the independent noncollinear-angle requirements can be simultaneously realized in a tilted QPM crystal, and the temperature-insensitive broadband amplification is achieved. Full-dimensional spatial-temporal simulations for a typical 1064 nm pumped mid-IR OPCPA at 3.4 µm are presented in detail. Compared with a mono-functional temperature-insensitive or broadband QPM scheme, the presented QPM configuration shows a common characteristic that simultaneously optimizes the thermal stability and the gain spectrum. Broadband parametric amplification of a ∼40 fs (FWHM) pulsed laser is achieved with no signs of gain-narrowing. Both of the beam profiles and the amplified spectra stay constant while the temperature is elevated by ∼100°C. Finally, influence of the QPM grating errors on the gain spectrum is discussed.In ice thickness measurement (ICM) procedures based on Raman scattering, a key issue is the detection of ice-water interface using the slight difference between the Raman spectra of ice and water. To tackle this issue, we developed a new deep residual network (DRN) to cast this detection as an identification problem. Thus, the interface detection is converted to the prediction of the Raman spectra of ice and water. We enabled this process by designing a powerful DRN that was trained by a set of Raman spectral data, obtained in advance. In contrast to the state-of-the-art Gaussian fitting method (GFM), the proposed DRN enables ICM with a simple operation and low costs, as well as high accuracy and speed. Experimental results were collected to demonstrate the feasibility and effectiveness of the proposed DRN.The generalized Kerker effect has recently gained an explosive progress in metamaterials, from the scattering management of particle clusters to the reflection and transmission manipulation of metalattices and metasurfaces. Various optical phenomena observed can be explained by the generalized Kerker effect. Due to the same nature of electromagnetic waves, we believe that the generalized Kerker effect can also be used in the microwave field. Inspired by this, in this letter we design a kind of patch array antenna to suppress the cross-polarization by interferences of multipoles. Using different far-field radiation phase symmetries of electromagnetic multipoles for the patch, the cross-polarization can be almost cancelled while the co-polarization be kept. A pair of 8×8 U-slot patch array antennas, working in a wide band (8.8 GHz-10.4 GHz), have been designed, fabricated and measured to verify our proposal. Simulated and measured results both agree well with the theory, showing more than 20 dB gain suppression of the cross-polarization, which indicates the universality of the generalized Kerker effect in electromagnetic waves.Nowadays, improving the accuracy of computational methods to solve the initial value problem of the Zakharov-Shabat system remains an urgent problem in optics. In particular, increasing the approximation order of the methods is important, especially in problems where it is necessary to analyze the structure of complex waveforms. In this work, we propose two finite-difference algorithms of fourth order of approximation in the time variable. Both schemes have the exponential form and conserve the quadratic invariant of Zakharov-Shabat system. The second scheme allows applying fast algorithms with low computational complexity (fast nonlinear Fourier transform).We report the demonstration of a fiber-based supercontinuum source delivering up to 825 mW of average output power between 2.5 and 5.0 µm generated in all-normal dispersion regime. The pumping source consists of an amplified ultrafast Er3+ZrF4 fiber laser providing high peak power femtosecond pulses at 3.6 µm with an average output power exceeding the watt-level. These pulses are spectrally broadened through self-phase modulation using commercial chalcogenide-based step-index fibers. Al2O3 anti-reflection coatings were sputtered on chalcogenide fiber tips to increase the launching efficiency from 54% to 82%, making this record output power possible, and thus confirming that such coatings can support watt-level pumping with intense femtosecond pulses. To the best of our knowledge, this result represents the highest average output power ever achieved from a As2Se3-based mid-IR supercontinuum source with the potential of a high degree of coherence.Edge-illumination X-ray phase-contrast tomography (EIXPCT) is an emerging technique that enables practical phase-contrast imaging with laboratory-based X-ray sources. A joint reconstruction method was proposed for reconstructing EIXPCT images, enabling novel flexible data-acquisition designs. However, only limited efforts have been devoted to optimizing data-acquisition designs for use with the joint reconstruction method. In this study, several promising designs are introduced, such as the constant aperture position (CAP) strategy and the alternating aperture position (AAP) strategy covering different angular ranges. In computer-simulation studies, these designs are analyzed and compared. Experimental data are employed to test the designs in real-world applications. All candidate designs are also compared for their implementation complexity. The tradeoff between data-acquisition time and image quality is discussed.We study the angular distribution of light diffusely reflected from a turbid medium with large (compared to the light wavelength) inhomogeneities. Using Monte Carlo radiative transfer simulations, we calculate the azimuthally averaged bidirectional reflectance for an optically thick plane-parallel medium and analyze its dependence on the parameters of the scattering phase function. To model single scattering in the medium, we take advantage of the Reynolds-McCormick phase function. For grazing angles of incidence, we find that the angular distribution of reflected light becomes very sensitive to the angular profile of the scattering phase function. The more elongated the phase function, the more pronounced the peak that arises around the specular reflection angle. Comparison of our numerical results with an analytic solution of the radiative transfer equation is performed, and it is shown that the bidirectional reflectance can be decomposed into two contributions, namely, the diffusion contribution and the contribution from light experiencing multiple scattering through small angles.