Boysenmcneil9154

At the highest dose (600 mg/L) of the nanoparticles, the reactions of the bacteria to the different TiO2 types used in the experiment varied.A novel liquid phosphorous-containing flame retardant anhydride (LPFA) with low viscosity was synthesized from 9,10-dihydro-9-oxa-10-phosphaphenanthrene-10-oxide (DOPO) and methyl tetrahydrophthalic anhydride (MeTHPA) and further cured with bisphenol-A epoxy resin E-51 for the preparation of the flame retardant epoxy resins. Both Fourier transform infrared spectroscopy (FT-IR), mass spectrometry (MS) and nuclear magnetic resonance (NMR) measurements revealed the successful incorporation of DOPO on the molecular chains of MeTHPA through chemical reaction. The oxygen index analysis showed that the LPFA-cured epoxy resin exhibited excellent flame retardant performance, and the corresponding limiting oxygen index (LOI) value could reach 31.2%. The UL-94V-0 rating was achieved for the flame retardant epoxy resin with the phosphorus content of 2.7%. With the addition of LPFA, the impact strength of the cured epoxy resins remained almost unchanged, but the flexural strength gradually increased. Meanwhile, all the epoxy resins showed good thermal stability. The glass transition temperature (Tg) and thermal decomposition temperature (Td) of epoxy resin cured by LPFA decreased slightly compared with that of MeTHPA-cured epoxy resin. Based on such excellent flame retardancy, low viscosity at room temperature and ease of use, LPFA showed potential as an appropriate curing agent in the field of electrical insulation materials.Neonatal calf diarrhoea (NCD) is a major health challenge with a negative impact on farm profitability, calf welfare and antimicrobial use. Neonatal calves are particularly sensitive to enteric infections. Thus, a key point for prevention is minimising infectious pressure and maximising specific immune responses. An amount of 120 dams not previously vaccinated against NCD were randomly allocated to one of three study groups negative control versus two vaccinated groups (A and B). In the control group, the average level of antibodies was significantly low for both BoCV and ETEC (15.6 and 13.9% in the colostrum samples, respectively), demonstrating the importance of dam vaccination. Indeed, the level of specific immunity was significantly increased for BoCV and ETEC with dam vaccination using both one-shot vaccines versus the control group. Moreover, the statistical analysis revealed a significantly higher level of antibodies for BoCV and ETEC in colostrum samples in vaccine A versus vaccine B and the control group. In accordance, the calf serum demonstrated a significantly higher level and greater homogeneity of antibodies against BoCV and ETEC in the Vaccine A group versus other experimental groups (p less then 0.05). In conclusion, this study demonstrated a different specific immune response for the pathogens depending on the vaccine used to control NCD in cows.The world's first steel structures were built towards the end of the 19th century. Some of them are still in use today, whereas others are maintained as precious technical heritage. In both cases, there may be a need to assess their technical condition and carry out repairs and reinforcements, which requires an understanding of the properties of the steel used. The few studies that have been undertaken of such steel structures indicate that the properties depend on the history of use. This paper presents the results of metallographic tests of a steel tank in a water tower built in 1884 in Lower Silesia. The chemical composition was consistent with that of the puddled steel used in the 19th century. The carbon content showed significant segregation and ranged from 0.011% to 0.072% mass. As a consequence, a typical microstructure for low-carbon steels (ferritic) was observed, changing locally to ferritic-pearlitic. The tested steel contained a very high content of phosphorus and silicon. The microstructure with numerous slags favoured the formation of surface delamination caused by the corrosion processes. The degree of corrosion of the steel of the tank was also assessed, as well as the type of corrosion inside the tank. Corrosion was favoured by the oxygen concentration cell. The results of the research will be used to assess the potential for continuing tank use and the reinforcements that have been planned. The results presented will add to the somewhat limited research results available for steel dating back to the 19th century, which is still present in many building structures. Such a database is especially needed by those designing technical measures aimed at maintaining these historical structures in good technical condition.Radio frequency fingerprinting (RFF) methods are becoming more and more popular in the context of identifying genuine transmitters and distinguishing them from malicious or non-authorized transmitters, such as spoofers and jammers. RFF approaches have been studied to a moderate-to-great extent in the context of non-GNSS transmitters, such as WiFi, IoT, or cellular transmitters, but they have not yet been addressed much in the context of GNSS transmitters. In addition, the few RFF-related works in GNSS context are based on post-correlation or navigation data and no author has yet addressed the RFF problem in GNSS with pre-correlation data. Moreover, RFF methods in any of the three domains (pre-correlation, post-correlation, or navigation) are still hard to be found in the context of GNSS. The goal of this paper was two-fold first, to provide a comprehensive survey of the RFF methods applicable in the GNSS context; and secondly, to propose a novel RFF methodology for spoofing detection, with a focus on GNSS pre-correlation data, but also applicable in a wider context. In order to support our proposed methodology, we qualitatively investigated the capability of different methods to be used in the context of pre-correlation sampled GNSS data, and we present a simulation-based example, under ideal noise conditions, of how the feature down selection can be done. SR18662 research buy We are also pointing out which of the transmitter features are likely to play the biggest roles in the RFF in GNSS, and which features are likely to fail in helping RFF-based spoofing detection.