Barkerhedrick4587

We report the development of a new high-flux electrospray ionization-based instrument for soft landing of mass-selected fragment ions onto surfaces. Collision-induced dissociation is performed in a collision cell positioned after the dual electrodynamic ion funnel assembly. The high duty cycle of the instrument enables high-coverage deposition of mass-selected fragment ions onto surfaces at a defined kinetic energy. This capability facilitates the investigation of the reactivity of gaseous fragment ions in the condensed phase. We demonstrate that the observed reactions of deposited fragment ions are dependent on the structure of the ion and the composition of either ionic or neutral species codeposited onto a surface. The newly developed instrument provides access to high-purity ion fragments as building blocks for the preparation of unique ionic layers.Field-deployable diagnostics based on cell-free systems have advanced greatly, but on-site quantification of target analytes remains a challenge. Here we demonstrate that Escherichia coli lysate-based cell-free biosensors coupled to a personal glucose monitor (PGM) can enable on-site analyte quantification, with the potential for straightforward reconfigurability to diverse types of analytes. We show that analyte-responsive regulators of transcription and translation can modulate the production of the reporter enzyme β-galactosidase, which in turn converts lactose into glucose for PGM quantification. Because glycolysis is active in the lysate and would readily deplete converted glucose, we decoupled enzyme production and glucose conversion to increase the end point signal output. However, this lysate metabolism did allow for one-pot removal of glucose present in complex samples (like human serum) without confounding target quantification. Taken together, our results show that integrating lysate-based cell-free biosensors with PGMs enables accessible target detection and quantification at the point of need.Reconfigurable multivalue logic functions, which can perform the versatile arithmetic computation of weighted electronic data information, are demonstrated at room temperature on an all-around-gate silicon ellipsoidal quantum-dot transistor. The large single-hole transport energy of the silicon quantum ellipsoid allows the stable M-shaped Coulomb blockade oscillation characteristics at room temperature, and the all-around-gate structure of the fabricated transistor enables us to perform the precise self-control of the energetic Coulomb blockade conditions by changing the applied bias voltage. Such a self-controllability of the M-shaped Coulomb blockade oscillation characteristics provides a great advantage to choose multiple operation points for the reconfigurable multivalue logic functions. Consequently, the weighted data states (e.g., tri-value and quattro-value) are effectively demonstrated by utilizing only the device physics in the all-around-gate silicon ellipsoidal quantum-dot transistor. These findings are of great benefit for the practical application of the silicon quantum device at an elevated temperature for future nanoelectronic information technology.Thanks to their high conductivity and theoretical capacity, transition metal selenides have demanded significant research attention as prospective anodes for sodium-ion batteries. Nevertheless, their practical applications are hindered by finite cycle life and inferior rate performance because of large volume expansion, polyselenide dissolution, and sluggish dynamics. Herein, the nitrogen-doped carbon (NC)-coated FeSe2 nanoparticles encapsulated in NC nanoboxes (termed FeSe2@NDC NBs) are fabricated through the facile thermal selenization of polydopamine-wrapped Prussian blue precursors. In this composite, the existing nitrogen-doped dual carbon layer improves the intrinsic conductivity and structural integrity, while the unique porous yolk-shell architecture significantly mitigates the volume swelling during the sodium/desodium process. Moreover, the derived Fe-N-C bonds can effectively capture polyselenide, as well as promote Na+ transportation and good reversible conversion reaction. As expected, the FeSe2@NDC NBs deliver remarkable rate performance (374.9 mA h g-1 at 10.0 A g-1) and long-cycling stability (403.3 mA h g-1 over 2000 loops at 5.0 A g-1). When further coupled with a self-made Na3V2(PO4)3@C cathode in sodium-ion full cells, FeSe2@NDC NBs also exhibit considerably high and stable sodium-storage performance.Mitochondrial proteases are interesting but challenging drug targets for multifactorial diseases, such as neurodegeneration and cancer. The mitochondrial inner membrane protease OMA1 is a bona fide drug target for heart failure supported by data from human linkage analysis and animal disease models, but presumably relevant for more indications. OMA1 acts at the intersection of energy metabolism and stress signaling. The protease cleaves the structural protein OPA1, which organizes the cristae, as well as the signaling peptide DELE1, which can stimulate the integrated stress response. OMA1 shows little activity under physiological conditions but hydrolyzes OPA1 in mitochondria destined for mitophagy and during apoptosis. Little is known about OMA1, its structure has not been solved, let alone its context-dependent regulation. Autocatalytic processing and the lack of OMA1 inhibitors are thereby creating the biggest roadblocks. This study introduces a scalable, cellular OMA1 protease assay suitable for high-throughput drug screening. The assay utilizes an engineered luciferase targeted to the inner membrane as artificial OMA1 substrate, whereby the reporter signal inversely correlates to OMA1 activity. Erastin2 concentration Testing different screening protocols and sampling different compound collections validated the reporter and demonstrated that both OMA1 activators as well as OMA1 inhibitors can be identified with the assay. Ten kinase-targeted cancer drugs triggered OMA1 in the assays, which suggests-considering cardiotoxicity as a rather common side-effect of this class of drugs-cross-reactivity with the OMA1 pathway.Development of wearable sensing platforms is essential for the advancement of continuous health monitoring and point-of-care testing. Eccrine sweat pH is an analyte that can be noninvasively measured and used to diagnose and aid in monitoring a wide range of physiological conditions. Surface-enhanced Raman scattering (SERS) offers a rapid, optical technique for fingerprinting of biomarkers present in sweat. In this paper, a mechanically flexible, nanofibrous, SERS-active substrate was fabricated by a combination of electrospinning of thermoplastic polyurethane (TPU) and Au sputter coating. This substrate was then investigated for suitability toward wearable sweat pH sensing after functionalization with two commonly used pH-responsive molecules, 4-mercaptobenzoic acid (4-MBA), and 4-mercaptopyridine (4-MPy). The developed SERS pH sensor was found to have good resolution (0.14 pH units for 4-MBA; 0.51 pH units for 4-MPy), with only 1 μL of sweat required for a measurement, and displayed no statistically significant difference in performance after 35 days (p = 0.361). Additionally, the Au/TPU nanofibrous SERS pH sensors showed fast sweat-absorbing ability as well as good repeatability and reversibility. The proposed methodology offers a facile route for the fabrication of SERS substrates which could also be used to measure a wide range of health biomarkers beyond sweat pH.Non-fullerene acceptors (NFAs) with near-infrared (NIR) absorption show promising advantages in organic solar cells (OSCs). However, only a few NFAs can extend the absorption spectra over 1000 nm, and their photovoltaic performance has been unsatisfactory so far. To address this issue, three new NFAs, namely, 6-IFIC, 6-IF2F, and 6-IF4F, were synthesized by simultaneously introducing π-bridge units and different end groups. The π-bridge unit enlarges the conjugation and planarizes the molecular geometry, leading to intense absorption in the NIR range. The asymmetric configuration provides a large dipole moment, enhances the intermolecular interaction, and tunes the miscibility, consequently being beneficial for achieving a favorable morphology in OSCs. When blended with a donor polymer PTB7-Th, the 6-IF2F-based OSC yields the best power conversion efficiency (PCE) of 11.20%, which is among the highest PCEs based on NFAs with absorption over 1000 nm. More importantly, the absorption of the blend film provides a transparency window in the visible range from 400 and 650 nm. Therefore, the semitransparent OSCs based on these three NFAs can achieve over 28% average visible transmittance.Biofilms are complex living materials that form as bacteria become embedded in a matrix of self-produced protein and polysaccharide fibers. In addition to their traditional association with chronic infections or clogging of pipelines, biofilms currently gain interest as a potential source of functional material. On nutritive hydrogels, micron-sized Escherichia coli cells can build centimeter-large biofilms. During this process, bacterial proliferation, matrix production, and water uptake introduce mechanical stresses in the biofilm that are released through the formation of macroscopic delaminated buckles in the third dimension. To clarify how substrate water content could be used to tune biofilm material properties, we quantified E. coli biofilm growth, delamination dynamics, and rigidity as a function of water content of the nutritive substrates. Time-lapse microscopy and computational image analysis revealed that softer substrates with high water content promote biofilm spreading kinetics, while stiffer substrates with low water content promote biofilm delamination. The delaminated buckles observed on biofilm cross sections appeared more bent on substrates with high water content, while they tended to be more vertical on substrates with low water content. Both wet and dry biomass, accumulated over 4 days of culture, were larger in biofilms cultured on substrates with high water content, despite extra porosity within the matrix layer. Finally, microindentation analysis revealed that substrates with low water content supported the formation of stiffer biofilms. This study shows that E. coli biofilms respond to substrate water content, which might be used for tuning their material properties in view of further applications.

Birth Preparedness and Complication Readiness (BPCR) is a key component of safe motherhood programs to reduce maternal mortality. It promotes active preparation and decision-making for delivery by pregnant women and their families.

The study determined knowledge of danger signs and practice of BPCR among pregnant women.

The study was a cross-sectional survey conducted among 400 pregnant women attending Antenatal clinic at a tertiary health facility in Nigeria. Semi-structured, selfadministered questionnaire was used in collecting data. Statistical Package for Social Sciences version 25 was used for data analysis. Descriptive statistics such as percentages, sample mean, frequency tables were done. Inferential statistics were used to test for associations between categorical variables. P-value < 0.05.

The mean age of the respondents was 29.7±4.2, with most respondents between the age bracket of 21-30 years. About 384 (96.0%) of respondents had post-secondary or tertiary education. About 297 (74.3%) of respondents had good knowledge of warning and danger signs during pregnancy.