Valentinepetterson7247

It was noted that the chains containing the hydrophilic monomer and the polymerizable N-halamine compound were successfully grafted onto the PU substrate. The degree of chlorination was improved with the introduction of a hydrophilic monomer, except the HEMA. All of these hydrophilic monomer-containing N-halamine-modified PU substrates demonstrated a more than 2 log CFU reduction after microbial incubation. In contrast, the surface modified with N-halamine only exhibited significantly less antimicrobial efficacy instead. This is likely due to the synergistic effects caused by the reduced chlorine content, as well as the reduced surface interactions with the microbes.Antimicrobial treatment alternatives for methicillin-resistant Staphylococcus aureus (MRSA) are increasingly limited. MRSA strains are resistant to methicillin due to the formation of β-lactamase enzymes, as well as the acquisition of the mecA gene, which encodes the penicillin-binding protein (PBP2a) that reduces the affinity for β-lactam drugs. Previous studies have shown that the use of ampicillin-loaded nanoparticles can improve antimicrobial activity on resistant S. aureus strains. However, the biological mechanism of this effect has not yet been properly elucidated. Therefore, this short communication focused on characterizing the in silico interactions of the PBP2a membrane receptor protein from S. aureus against the monomeric units of two polymeric materials previously used in the development of different nanoparticles loaded with ampicillin. Such polymers correspond to Eudragit E-100 chloride (EuCl) and the sodium salt of poly(maleic acid-alt-octadecene) (PAM-18Na). For this, molecular coupling studies were carried out in the active site of the PBP2a protein with the monomeric units of both polymers in neutral and ionized form, as well as with ampicillin antibiotic (model β-lactam drug). The results showed that ampicillin, as well as the monomeric units of EuCl and PAM18Na, described a slight binding free energy to the PBPa2 protein. In addition, it was found that the amino acids of the active site of the PBPa2 protein have interactions of different types and intensities, suggesting, in turn, different forms of protein-substrate coupling.Collagen (Col) and gelatin are most extensively used in various fields, particularly in pharmaceuticals and therapeutics. Numerous researchers have proven that they are highly biocompatible to human tissues, exhibit low antigenicity and are easy to degrade. Despite their different sources both Col and gelatin have almost the same effects when it comes to wound healing mechanisms. Considering this, the bioactivity and biological effects of both Col and gelatin have been, and are being, constantly investigated through in vitro and in vivo assays to obtain maximum outcomes in the future. With regard to their proven nutritional values as sources of protein, Col and gelatin products exert various possible biological activities on cells in the extracellular matrix (ECM). Cepharanthine in vivo In addition, a vast number of novel Col and gelatin applications have been discovered. This review compared Col and gelatin in terms of their structures, sources of derivatives, physicochemical properties, results of in vitro and in vivo studies, their roles in wound healing and the current challenges in wound healing. Thus, this review provides the current insights and the latest discoveries on both Col and gelatin in their wound healing mechanisms.Rubber compounding with two or more components has been extensively employed to improve various properties. In particular, natural rubber (NR)/ethylene-propylene-diene monomer rubber (EPDM) blends have found use in tire and automotive parts. Diverse fillers have been applied to NR/EPDM blends to enhance their mechanical properties. In this study, a new class of mineral filler, phlogopite, was incorporated into an NR/EPDM blend to examine the mechanical, curing, elastic, and morphological properties of the resulting material. The combination of aminoethylaminopropyltrimethoxysilane (AEAPS) and stearic acid (SA) compatibilized the NR/EPDM/phlogopite composite, further improving various properties. The enhanced properties were compared with those of NR/EPDM/fillers composed of silica or carbon black (CB). Compared with the NR/EPDM/silica composite, the incompatibilized NR/EPDM/phlogopite composite without AEAPS exhibited poorer properties, but NR/EPDM/phlogopite compatibilized by AEAPS and SA showed improved properties. Most properties of the compatibilized NR/EPDM/phlogopite composite were similar to those of the NR/EPDM/CB composite, except for the lower abrasion resistance. The NR/EPDM/phlogopite/AEAPS rubber composite may potentially be used in various applications by replacing expensive fillers, such as CB.The main objective of this study was to assess the pharmacological efficacy of ointments containing 1% propolis and 1% nanosilver, compared to the conventional treatment of burn wounds. In the evaluation of the results, we used clinical observation of scars, microbiological examinations, pathomorphological examinations, and analysis of free radicals. The analysis of the experiment results concerning the therapeutic effectiveness of the propolis ointment revealed its wide-ranging antibacterial action (against Gram-positive and Gram-negative bacteria). The 1% propolis ointment was found to accelerate neoangiogenesis and epithelialization, have a positive effect on the healing of burn wounds, improve the cosmetic look of scars, and have no side-effects. The analysis of free radicals in burn wounds showed impressive activity of the 1% nanosilver ointment in the reduction of free radicals. No synergism of pharmacological activity of propolis and nanosilver was shown. A comparative evaluation of the acquired research material allows us to provide a favorable opinion on the topical treatment of burn wounds with 1% propolis. The obtained results show that the 1% propolis ointment reduces healing time, offers antimicrobial action, and has a positive effect on the normal process of scar formation.Maintaining oral health helps to prevent periodontal inflammation and pain, which can progress into more detrimental issues if left untreated. Meloxicam (MX) is a commonly used analgesic for periodontal pain, but it can have adverse gastrointestinal effects and poor solubility. Therefore, this study aimed to enhance the solubility of MX by developing a self-nanoemulsifying drug delivery system (SNEDDS). Considering the anti-ulcer activity of peppermint oil (PO), it was added in a mixture with medium-chain triglyceride (MCT) to the MX-loaded SNEDDS formulation (MX-PO-SNEDDS). After optimization, MX-PO-SNEDDS exhibited a POMCT ratio of 1.781, surfactant mixture HLB value of 14, and MXoil mix ratio of 115, a particle size of 47 ± 3 nm, stability index of 85 ± 4%, ex vivo Jss of 4 ± 0.6 μg/cm2min, and ulcer index of 1 ± 0.25 %. Then, orally flash disintegrating lyophilized composites (MX-SNELCs) were prepared using the optimized MX-PO-SNEDDs. Results reveal that MX-SNELCs had a wetting time of 4 ± 1 s and disintegration time of 3 ± 1 s with a high in vitro MX release of 91% by the end of 60 min. The results of pharmacokinetic studies in human volunteers further demonstrated that, compared to a marketed MX tablets, MX-SNELCs provided a higher Cmax, Tmax, and AUC and a relatively greater bioavailability of 152.97 %. The successfully developed MX-SNELCs were found to be a better alternative than the conventional tablet dosage form, thus indicating their potential for further development in a clinically acceptable strategy for managing periodontal pain.We present a combined study by quasielastic neutron scattering (QENS), dielectric and mechanical spectroscopy, calorimetry and wide-angle X-ray diffraction on single-chain nano-particles (SCNPs), using the corresponding linear precursor chains as reference, to elucidate the impact of internal bonds involving bulky cross-links on the properties of polymer melts. Internal cross-links do not appreciably alter local properties and fast dynamics. This is the case of the average inter-molecular distances, the β-relaxation and the extent of the atomic displacements at timescales faster than some picoseconds. Contrarily, the α-relaxation is slowed down with respect to the linear precursor, as detected by DSC, dielectric spectroscopy and QENS. QENS has also resolved broader response functions and stronger deviations from Gaussian behavior in the SCNPs melt, hinting at additional heterogeneities. The rheological properties are also clearly affected by internal cross-links. We discuss these results together with those previously reported on the deuterated counterpart samples and on SCNPs obtained through a different synthesis route to discern the effect of the nature of the cross-links on the modification of the diverse properties of the melts.The shear-induced and cellulose-nanofiber nucleated crystallization of two novel aliphatic-aromatic copolyesters is outlined due to its significance for the in situ generation of biodegradable nanocomposites, which require the crystallization of nanofibrous sheared inclusions at higher temperatures. The shear-induced non-isothermal crystallization of two copolyesters, namely, poly(butylene adipate-co-succinate-co-glutarate-co-terephthalate) (PBASGT) and poly(butylene adipate-co-terephthalate) (PBAT), was studied following a light depolarization technique. To have a deep insight into the process, the effects of the shear rate, shear time, shearing temperature and cooling rate on the initiation, kinetics, growth and termination of crystals were investigated. Films of 60 μm were subjected to various shear rates (100-800 s-1) for different time intervals during cooling. The effects of the shearing time and increasing the shear rate were found to be an elevated crystallization temperature, increased nucleation density, reduced growth size of lamella stacks and decreased crystallization time. Due to the boosted nucleation sites, the nuclei impinged with each other quickly and growth was hindered. The effect of the cooling rate was more significant at lower shear rates. Shearing the samples at lower temperatures, but still above the nominal melting point, further shifted the non-isothermal crystallization to higher temperatures. As a result of cellulose nanofibers' presence, the crystallization of PBAT, analyzed by DSC, was shifted to higher temperatures.The contribution of Spanish scientists to the rheology involved in polymer processing during the last 25 years is investigated. It is shown that the performed research covers, at different levels, all industrial polymeric materials thermoplastics, thermosets, adhesives, biopolymers, composites and nanocomposites, and polymer modified bitumen. Therefore, the rheological behaviour of these materials in processing methods such as extrusion, injection moulding, additive manufacturing, and others is discussed, based on the literature results. A detailed view of the most outstanding achievements, based on the rheological criteria of the authors, is offered.Electrospun polyvinyl alcohol (PVA) nanofiber fabric was modified by Cibacron Blue F3GA (CB) to enhance the affinity of the fabric. Batch experiments were performed to study the nanofiber fabric's bovine hemoglobin (BHb) adsorption capacity at different protein concentrations before and after modification. The maximum BHb adsorption capacity of the modified nanofiber fabric was 686 mg/g, which was much larger than the 58 mg/g of the original fabric. After that, the effect of feed concentration and permeation rate on the dynamic adsorption behaviors for BHb of the nanofiber fabric was investigated. The pH impact on BHb and bovine serum albumin (BSA) adsorption was examined by static adsorption experiments of single protein solutions. The selective separation experiments of the BHb-BSA binary solution were carried out at the optimal pH value, and a high selectivity factor of 5.45 for BHb was achieved. Finally, the reusability of the nanofiber fabric was examined using three adsorption-elution cycle tests. This research demonstrated the potential of the CB-modified PVA nanofiber fabric in protein adsorption and selective separation.