Schultzjansen3038

Finally, a roadmap is suggested along with future research directions to ensure the sustainable production of biochar from sludge and its applications in water treatment.Developing a low-cost and efficient photocatalysts activated peroxymonosulfate (PMS) for organic pollutants degradation are recognized as an importance way for dealing with environmental pollution. In this work, Fe-rectorite catalyst was synthesized by a simple impregnation-calcine method to synergetic photo activate PMS for antibiotics degradation. As expected, the Fe-rectorite/PMS/Light system exhibits superior catalytic performance for tetracycline (TC) removal, which achieving 96.4% removal rate of TC (30 mg/L) under light within 60 min. Fe-retorite has better degradation performance for TC than rectorite under photo-mediation. The enhancement of the degradation performance of TC by Fe-retorite can be attributed to the improvement of the separation efficiency of photogenerated electrons and holes in the rectorite by the loading of Fe2O3, and the accelerated active Fe(Ⅱ)/Fe(Ⅲ) cycle on the surface under photo-mediation. The large specific surface area and abundant hydroxyl groups of rectorite can also provide active sites for PMS activation. The quenching experiment and electron paramagnetic resonance (EPR) test were indicated that the h+, SO4•-, •OH, and O2-• all contributed to TC degradation. And the possible degradation pathway was proposed by LC-MS. This work helps induced a novel direction that design green, efficient, and recyclable heterogeneous catalysts to synergetic photoinduced PMS activation for enhanced degradation of TC.Crude oil contamination greatly influence soil bacterial community. Proliferative microbes in the crude oil-contaminated soil are closely related to the living conditions. Oil wells in the Yellow River Delta Natural Reserve (YRDNR) region is an ideal site for investigating the bacterial community of crude oil-contaminated saline soil. In the present study, 18 soil samples were collected from the depths of 0-20 cm and 20-40 cm around the oil wells in the YRDNR. The bacterial community profile was analyzed through high-throughput sequencing to trace the oil-degrading aerobic and anaerobic bacteria. The results indicated that C15-C28 and C29-C38 were the main fractions of total petroleum hydrocarbon (TPH) in the sampled soil. These TPH fractions had a significant negative effect on bacterial biodiversity (Shannon, Simpson, and Chao1 indices), which led to the proliferation of hydrocarbon-degrading bacteria. A comprehensive analysis between the environmental factors and soil microbial community structure showed t be potential influencing factor. Our results could provide useful information for the bioremediation of crude oil-contaminated saline soil.Microbial fuel cells (MFCs) are an emerging technology for converting organic waste into electricity, thus providing potential solution to energy crises along with eco-friendly wastewater treatment. The electrode properties and biocatalysts are the major factors affecting electricity production in MFC. The electrons generated during microbial metabolism are captured by the anode and transferred towards the cathode via an external circuit, causing the flow of electricity. This flow of electrons is greatly influenced by the electrode properties and thus, much effort has been made towards electrode modification to improve the MFC performance. Different semiconductors, nanostructured metal oxides and their composite materials have been used to modify the anode as they possess high specific surface area, good biocompatibility, chemical stability and conductive properties. The cathode materials have also been modified using metals like platinum and nano-composites for increasing the redox potential, electrical conductivity and surface area. Therefore, this paper reviews the recent developments in the modification of electrodes towards improving the power generation capacity of MFCs.In this study, two biosurfactant producing Pseudomonas aeruginosa sp. were isolated from motor oil contaminated soil for crude oil, alkane and PAH degradation studies. Metagenomics analysis identified as proteobacteria phyla was the dominant. Isolated two bacterial species were well grown in mineral salt medium with 1% of crude oil, alkanes (dotriacontane and tetratetracontane) and PAH (pyrene, benzopyrene and anthracene) as sole carbon sources. Total biodegradation efficiency (BE) of strains PP3 and PP4 in Crude oil degradation evaluated by the analysis of gas chromatography and mass spectrometry was 50% and 86% respectively. BE of PP3, PP4 and mixed consortium in alkane biodegradation were 46%, 47% and 36%, respectively. BE of PP3, PP4 and mixed consortium in PAH biodegradation were 22%, 48% and 35%, respectively. Based on the results revealed that strain pp4 was more efficient bacteria to degrade the crude oil, alkane and PAH than pp3. This was due to the higher production of biosurfactant by PP4 than PP3 and also confirmed in the test of emulsification index (E24). FTIR results showed that the produced biosurfactant could partially solubilize the crude oil hydrocarbons, alkanes and PAH and confirmed as glycolipid (rhamnolipid) in nature. Thus, the obtained results from the GCMS showed that all hydrocarbons were utilized by bacteria as carbon source for biosurfactant production and utilize the high molecular weight hydrocarbons. Based on the present study we can suggest that identified potential biosurfactant producing bacteria are used for biodegradation of high molecular weight hydrocarbon (>C40).Iohexol as an iodinated X-ray contrast agent is widely used, and it is the potential precursor for toxic iodinated disinfection by-products in the disinfection process. In this study, a series of CuFe2O4 catalysts were prepared by sol-gel method with different molar ratios of total metal cations to citric acid ([Men+]T/CA) and employed as heterogeneous catalysts to activate peroxymonosulfate (PMS) for the removal of iohexol. The catalysts were characterized by various technologies, and the effect of [Men+]T/CA molar ratio on the catalysts' properties was explored. The CuFe2O4 synthesized with [Men+]T/CA molar ratio of 11 showed the best catalytic activity to PMS, and 95.0% of 1.0 mg/L iohexol was removed within 15 min by using 50 mg/L CuFe2O4 and 20 mg/L PMS. The quenching experiment and electron spin resonance (ESR) spectra indicated the generation of SO4- and OH in the CuFe2O4/PMS system, and the quantity experiments revealed that the generation concentration of SO4- was ten times higher than that of OH. The generation mechanism of SO4- and ·OH were investigated by ATR-FTIR and X-ray photoelectron spectroscopy (XPS) spectra. The effects of catalyst dosage, PMS and iohexol concentration on the removal of iohexol were studied, and various water matrix factors including solution pH, natural organic matter (NOM) concentration and inorganic ions were also considered. Based on the twelve intermediate products of iohexol detected by UPLC-QTOF/MS, the degradation pathway was proposed. The high catalytic activity and reusability of CuFe2O4 indicated that CuFe2O4 activating PMS is an effective and sustainable way for the treatment of iohexol.With millions of tonnes of plastic pollution generated every year, small-sized plastic particles, including micro- and nanoplastics, end up in freshwater systems. Due to the very small size and very large specific surface area of nanoplastics, they are known to be persistent and toxic in our environment. These particles are also known to react with other water-borne contaminants and cause acute toxicity in organisms. Nanoplastics are prone to biomagnification and can be transported to humans through various pathways. This study aims to contribute towards understanding the behaviour of nanoplastics in our environment, specifically through identification of various sources, detection techniques, toxicity estimation, health risk in humans, environmental fate, recovery and reuse, and future challenges and limitations. N6-methyladenosine chemical structure Detailed review on the toxic effects of nanoplastics on various organisms and their degradation rates in soil and water matrices are provided. The suitability of small- and large-scale separation techniques for the removal of nanoplastics in wastewater treatment plants is also discussed. Current challenges and future perspectives in understanding the fate and transport of nanoplastics in the environment are also discussed. Research gaps, including the development of quantification techniques, estimation of degradation mechanisms, transport in marine ecosystems, and development of sensors to examine nanoplastics in the environment, are explored. Finally, we can limit the release of nanoplastics to the environment through reduction, reuse and recycling (3 Rs) of bulk plastic products.Currently, the COVID-19 pandemic has been increasing the consumption of some drugs, such as chloroquine (CQN) and dipyrone (DIP), which are continuously discharged into water resources through domestic sewage treatment systems. The presence of these drugs in water bodies is worrisome due to their high toxicity, which makes crucial their monitoring and removal, especially by means of advanced technologies. Given this scenario, a new adsorbent material was synthesized through the combination of babassu coconut activated carbon and graphene oxide (GAC-GO). This study was evaluated in batch adsorption processes, aiming at the treatment of water contaminated with CQN and DIP. Characterization analyzes using physicochemical and spectroscopic techniques indicated that the GAC-GO functionalization was successfully performed. The equilibrium time of the adsorption process was 18 and 12 h for CQN and DIP, respectively. Kinetic and isothermal data better fitted to pseudo-second-order and Langmuir models for both drugs. Thermodynamic parameters showed that the process is endothermic and the maximum adsorption capacities of CQN and DIP were 37.65 and 62.43 mg g-1, respectively, both at 318 K. The study of the effect of ionic strength, which simulates a real effluent, demonstrated that the synthesized adsorbent has potential application for the treatment of effluents. Furthermore, satisfactory removal rates were verified for the removal of other contaminants in both simple solutions and synthetic mixtures, evidencing the versatile profile of the adsorbent.Drought is a major environmental threat that affects plant growth and productivity. Strategies to mitigate the detrimental impacts of drought stress on plants are under scrutiny. Nanotechnology is considered an effective tool in resolving a wide range of environmental issues by offering novel and pragmatic solutions. A pot experiment was performed to determine the efficacy of zinc oxide nanoparticles (ZnO NPs) as a foliar application (25 mg L-1 and 100 mg L-1) on the growth performance of cucumber subjected to drought stress. Applied ZnO NPs under normal conditions resulted in significant growth and biomass enhancement while reducing drought-induced decline. Photosynthetic pigments, photosynthesis, and PSII activity enhanced due to ZnO NPs application, attaining maximal values at 100 mg L-1 of ZnO NPs. Drought stress restricted growth and biomass buildup in cucumber seedlings by stimulating oxidative stress, which was manifested to excessive buildup of reactive oxygen species (ROS) and peroxidation, thereby decreasing membrane functioning.