Lawrencechung6145

Furthermore, benzothiadiazines are able to bind lipids and cholesterol chains by means of single and double hydrogen-bonds of characteristic lengths between 1.6 and 2.1 Å.Rechargeable lithium-ion batteries have drawn extensive attention owing to increasing demands in applications from portable electronic devices to energy storage systems. In situ polymerization is considered one of the most promising approaches for enabling interfacial issues and improving compatibility between electrolytes and electrodes in batteries. Herein, we observed in situ thermally induced electrolytes based on an oxetane group with LiFSI as an initiator, and investigated structural characteristics, physicochemical properties, contacting interface, and electrochemical performances of as-prepared SPEs with a variety of technologies, such as FTIR, 1H-NMR, FE-SEM, EIS, LSV, and chronoamperometry. The as-prepared SPEs exhibited good thermal stability (stable up to 210 °C), lower activation energy, and high ionic conductivity (>0.1 mS/cm) at 30 °C. Specifically, SPE-2.5 displayed a comparable ionic conductivity (1.3 mS/cm at 80 °C), better interfacial compatibility, and a high Li-ion transference number. The SPE-2.5 electrolyte had comparable coulombic efficiency with a half-cell configuration at 0.1 C for 50 cycles. Obtained results could provide the possibility of high ionic conductivity and good compatibility through in situ polymerization for the development of Li-ion batteries.Commercial grade sulfonated-Polyethersulfone (S-PES) and functionalized multiwall carbon nanotube (f-MWCNT)/polyvinylpyrrolidone (PVP) nanocomposites (NCs) were used to enhance and optimize the antifouling, protein resistance and protein separation properties of the S-PES ultrafiltration membranes. The polarities of sulfonic groups of S-PES, carbonyl carbon of pyrrolidone, hydroxyl and carboxyl groups of f-MWCNT in the membrane composition helped to strongly bind each other through hydrogen bonding, as shown by Fourier-transform infrared spectroscopy (FTIR). These binding forces greatly reduced the leaching of NCs and developed long finger-like projection, as confirmed by elution ratio and cross-sectional studies of the membranes via field emission scanning electron microscope (FESEM). The contact angle was reduced up to 48% more than pristine PES. Atomic force microscopy (AFM) was employed to study the various parameters of surface roughness with 3d diagrams, while grain analysis of membrane surface provided a quantitative estimation about volume, area, perimeter, length, radius and diameter. The NCs/S-PES enhanced the flux rate with an impressive (80-84%) flux recovery ratio and (58-62%) reversible resistance (Rr) value in situ, with 60% and 54.4% lesser dynamic and static protein adsorption. The best performing membrane were reported to remove 31.8%, 66.3%, 83.6% and 99.9% for lysozyme-(14.6 kDa), trypsin-(20 kDa), pepsin-(34.6 kDa) and bovine serum albumin (BSA-66 kDa), respectively.In this paper, tungsten oxide (WO3) is deposited on a silicon substrate applied in electrolyte-insulator-semiconductor structures for pH sensing devices. To boost the sensing performance, yttrium (Y) is doped into WO3 membranes, and annealing is incorporated in the fabrication process. To investigate the effects of Y doping and annealing, multiple material characterizations including X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), atom force microscopy (AFM), scanning electron microscopy (SEM), and transmission electron microscopy (TEM) are performed. Material analysis results indicate that annealing and Y doping can increase crystallinity, suppress defects, and enhance grainization, thereby strengthening membrane sensing capabilities in terms of sensitivity, linearity, and reliability. Because of their stable response, high reliability, and compact size, Y-doped WO3 membranes are promising for future biomedical applications.Augmenting bacterial growth is of great interest to the biotechnological industry. Hence, the effect of poly (caprolactone) fibrous scaffolds to promote the growth of different bacterial strains of biological and industrial interest was evaluated. Furthermore, different types of carbon (glucose, fructose, lactose and galactose) and nitrogen sources (yeast extract, glycine, peptone and urea) were added to the scaffold to determinate their influence in bacterial growth. Bacterial growth was observed by scanning electron microscopy; thermal characteristics were also evaluated; bacterial cell growth was measured by ultraviolet-visible spectrophotometry at 600-nm. Fibers produced have an average diameter between 313 to 766 nm, with 44% superficial porosity of the scaffolds, a glass transition around ~64 °C and a critical temperature of ~338 °C. The fibrous scaffold increased the cell growth of Escherichia coli by 23% at 72 h, while Pseudomonas aeruginosa and Staphylococcus aureus increased by 36% and 95% respectively at 48 h, when compared to the normal growth of their respective bacterial cultures. However, no significant difference in bacterial growth between the scaffolds and the casted films could be observed. Cell growth depended on a combination of several factors type of bacteria, carbon or nitrogen sources, casted films or 3D scaffolds. Microscopy showed traces of a biofilm formation around 3 h in culture of P. aeruginosa. Water bioremediation studies showed that P. aeruginosa on poly (caprolactone)/Glucose fibers was effective in removing 87% of chromium in 8 h.Edible coatings are important for horticulture crops preservation and reducing food waste. Application of edible coatings followed by low-temperature storage prolongs the storability, preserves quality, and decreases the overall postharvest losses. This study evaluated the efficacy of two nanoemulsions formulae containing thyme essential oil and whey proteins as coatings for zucchini, with the purpose of extending their shelf-life. The nanoemulsions were rheologically evaluated and the formula with guar and arabic gum mix stabilizer (S) showed a better capacity to restructure after strain compared to the formulae with Tween 20 (T). The S coating material had a better capacity to integrate nanoparticles compared to T. However, when applied on zucchini, T coating was more effective in reducing weight loss showing 16% weight loss compared to 21% in S, after 42 days. At the end of storage at 10 °C, the T-coated zucchini had better firmness (p < 0.05) compared with S and both coatings were superior to control (p < 0.05). POD (peroxidase) activity was high in peel at the end of storage when also CAT (catalase) showed a sudden increase. On the 42nd day of storage, the highest enzymes activity (CAT, POD, and APX (ascorbate peroxidase)) was present in the S-coated zucchini peel. The most abundant volatile in T coating was α-pinene and 4-carene in S. Sensory analysis showed that T coating delayed the appearance of senescence while S exhibited surface cracks.Mortality and morbidity rates among critically ill septic patients having acute kidney injury (AKI) are very high, considering the total number of deaths after their admission. Inappropriate selection of the type of continuous renal replacement therapy and inadequate therapy become the immediate causes of these issues. Dialysis is a commonly used treatment intended to prolong the life of AKI patients. Dialysis membranes, which are the core of dialysis treatment, must be properly selected to ensure fair treatment to the patients. The accumulation of certain types of molecules must be dealt with using the right membrane. Whether it is low-flux, high-flux, or adsorptive type, the dialysis membrane should be chosen depending on the condition of the patients. The selection of dialysis membranes should also be based on their effect on the treatment outcomes and well-being. All these options are needed to serve the patients of different clinical settings. The use of dialysis membranes is not restricted to conventional haemodialysis, but rather they can be employed in haemoperfusion, haemofiltration, haemodiafiltration, or a combination of any two of them. This review focuses in-depth on different types of dialysis membranes, their characteristics, and approaches in addressing the issues encountered in patients having AKI with sepsis and/or multiorgan failure in intensive care units.As an insidious metabolic bone disease, osteoporosis plagues the world, with high incidence rates. Patients with osteoporosis are prone to falls and becoming disabled, and their cone fractures and hip fractures are very serious, so the diagnosis and treatment of osteoporosis is very urgent. Extracellular vesicles (EVs) are particles secreted from cells to the outside of the cell and they are wrapped in a bilayer of phospholipids. According to the size of the particles, they can be divided into three categories, namely exosomes, microvesicles, and apoptotic bodies. The diameter of exosomes is 30-150 nm, the diameter of microvesicles is 100-1000 nm, and the diameter of apoptotic bodies is about 50-5000 nm. EVs play an important role in various biological process and diseases including osteoporosis. In this review, the role of EVs in osteoporosis is systematically reviewed and some insights for the prevention and treatment of osteoporosis are provided.The Middle East will face tremendous water scarcity by 2050, which can only be mitigated by large-scale reverse osmosis seawater desalination. However, the coastal land in the region is rare and costly, so outsourcing the desalination facility to artificial islands could become a realistic scenario. This study investigated the ecological and economic challenges and possible advantages of that water supply option by analysing conceptual alternatives for offshore membrane-based desalination plants of up to 600 MCM/y capacity. Key environmental impacts and mitigation strategies were identified, and a detailed economic analysis was conducted to compare the new approach to state-of-the-art. The economic analysis included calculating the cost of water production (WPC) and discussing the differences between offshore alternatives and a conventional onshore desalination plant. In addition, the study investigated the impact of a changing energy mix and potential carbon tax levels on the WPC until 2050. The results indicate that offshore desalination plants have ecological advantages compared to onshore desalination plants. Furthermore, the construction cost for the artificial islands has a much lower effect on the WPC than energy cost. In contrast, the impact of potential carbon tax levels on the WPC is significant. The specific construction cost ranges between 287 $/m2 and 1507 $/m2 depending on the artificial island type and distance to the shoreline, resulting in a WPC between 0.51 $/m3 and 0.59 $/m3. This work is the first to discuss the environmental and economic effects of locating large-scale seawater desalination plants on artificial islands.Ion exchange membranes (IEMs), as a part of the reverse electrodialysis (RED) system, play an important role in salinity gradient power (SGP) generation. Structure optimization of IEMs is critical to increase the power production by RED. In this work, metal organic framework (MOF)-derived nanoporous carbons (hollow zeolitic imidazolate framework (ZIF)-derived nanoporous carbons, HZCs) were incorporated in a sulfonated poly (2, 6-dimethyl-1,4-phenylene oxide) (sPPO) membrane to prepare an organic-inorganic nanocomposite cation exchange membrane (CEM). Physicochemical properties, electrochemical properties, and power generation of the synthesized nanocomposite membranes with different HZCs loading were characterized. The results show that the incorporated HZCs could tailor the microstructure of the membrane matrix, providing a superior performance of the nanocomposite membrane. With a HZCs loading of 1.0 wt.%, the nanocomposite membrane possessed the highest permselectivity of 77.61% and the lowest area resistance of 0.