Hjorthhoffman1195

Freeze-drying was the best drying method preserving the quality of both sprouts and needles, e.g., vitamin C content. The antioxidative activity of the sprout extracts were lower than that of needles. Ethanol-water extraction resulted in a higher content of active compounds in the extract than water extraction. Sensory evaluation of food products revealed that on average, 76% of consumers considered sprout-containing products very good or good, and a creamy product was preferred over a water-based sorbet.Automated identification of advanced chronic kidney disease (CKD ≥ III) and of no known kidney disease (NKD) can support both clinicians and researchers. We hypothesized that identification of CKD and NKD can be improved, by combining information from different electronic health record (EHR) resources, comprising laboratory values, discharge summaries and ICD-10 billing codes, compared to using each component alone. We included EHRs from 785 elderly multimorbid patients, hospitalized between 2010 and 2015, that were divided into a training and a test (n = 156) dataset. We used both the area under the receiver operating characteristic (AUROC) and under the precision-recall curve (AUCPR) with a 95% confidence interval for evaluation of different classification models. In the test dataset, the combination of EHR components as a simple classifier identified CKD ≥ III (AUROC 0.96[0.93-0.98]) and NKD (AUROC 0.94[0.91-0.97]) better than laboratory values (AUROC CKD 0.85[0.79-0.90], NKD 0.91[0.87-0.94]), discharge summaries (AUROC CKD 0.87[0.82-0.92], NKD 0.84[0.79-0.89]) or ICD-10 billing codes (AUROC CKD 0.85[0.80-0.91], NKD 0.77[0.72-0.83]) alone. this website Logistic regression and machine learning models improved recognition of CKD ≥ III compared to the simple classifier if only laboratory values were used (AUROC 0.96[0.92-0.99] vs. 0.86[0.81-0.91], p less then 0.05) and improved recognition of NKD if information from previous hospital stays was used (AUROC 0.99[0.98-1.00] vs. 0.95[0.92-0.97]], p less then 0.05). Depending on the availability of data, correct automated identification of CKD ≥ III and NKD from EHRs can be improved by generating classification models based on the combination of different EHR components.Although pharmacy employees' involvement in patient education has great potential, the extent to which they actually provide cognitive services seems inadequate. Given the overburdening of the healthcare system and limited access to medical services due to the severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) pandemic outbreak, this study aimed to evaluate the preparedness of Polish pharmacy employees for patient education on the new threat. The study was conducted using the mystery shopper method. Two interviewers phoned 90 randomly chosen community pharmacies throughout Poland and presented some inquiries on the SARS-CoV-2. Pharmacists devoted more time to patients than pharmacy technicians (222 vs. 154), and the information they provided was significantly more comprehensive (p = 0.006). The majority of respondents provided an evidence-based recommendation on prevention, symptoms, and management of SARS-CoV-2; however, the scope of advice significantly varied. Community pharmacy staff often expressed their concern about the lack of time to address patients' questions adequately. No statistically significant differences were found in recommendations provided by chain and non-chain pharmacy staff. Obtained results seem to confirm the possibility of involving pharmacists in public health activities during a pandemic. Nevertheless, providing proper working conditions and adequate just-in-time learning solutions is crucial.In this study, we demonstrate the use of silicone/few-layered hexagonal boron nitride (FL-hBN) composites for heat dissipation applications. FL-hBN is synthesized via a green, facile, low-cost and scalable liquid exfoliation method using a jet cavitation process. The crystal structures, surface morphologies and specific surface areas of pristine h-BN and FL-hBN were characterized by XRD, SEM, TEM and AFM (atomic force microscopy). The results confirmed that FL-hBN with a thickness of ~4 nm was successfully obtained from the exfoliation process. In addition, we introduced both pristine h-BN and FL-hBN into silicone with different ratios to study their thermal properties. The results of the laser flash analysis indicate that the silicon/FL-hBN composite exhibited a higher thermal conductivity than that of the silicone/h-BN composite. With the optimal loading content of 30 wt.% FL-hBN content, the thermal conductivity of the composite could be enhanced to 230%, which is higher than that of silicone/h-BN (189%). These results indicate that jet cavitation is an effective and swift way to obtain few-layered hexagonal boron nitride that could effectively enhance the thermal conductivity of silicone composites.The delivery of bioactive agents using active wound dressings for the management of pain and infections offers improved performances in the treatment of wound complications. In this work, solid lipid microparticles (SLMPs) loaded with lidocaine hydrochloride (LID) were processed and the formulation was evaluated regarding its ability to deliver the drug at the wound site and through the skin barrier. The SLMPs of glyceryl monostearate (GMS) were prepared with different LID contents (0, 1, 2, 4, and 10 wt.%) using the solvent-free and one-step PGSS (Particles from Gas-Saturated Solutions) technique. PGSS exploits the use of supercritical CO2 (scCO2) as a plasticizer for lipids and as pressurizing agent for the atomization of particles. The SLMPs were characterized in terms of shape, size, and morphology (SEM), physicochemical properties (ATR-IR, XRD), and drug content and release behavior. An in vitro test for the evaluation of the influence of the wound environment on the LID release rate from SLMPs was studied using different bioengineered human skin substitutes obtained by 3D-bioprinting. Finally, the antimicrobial activity of the SLMPs was evaluated against three relevant bacteria in wound infections (Escherichia coli, Staphylococcus aureus, and Pseudomonas aeruginosa). SLMPs processed with 10 wt.% of LID showed a remarkable performance to provide effective doses for pain relief and preventive infection effects.