Costellopalmer7888

Additionally, immunohistochemical staining and mRNA transcript levels show that the collagen-chondroitin sulphate formulation has the highest matrix production activity, while the collagen-decorin formulation featured a matrix production profile more characteristic of the undamaged tissue. Together, this demonstrates that scaffold doping with target biomolecules leads to distinct levels of cell-mediated matrix remodeling. Overall, this work resulted in the development of a versatile and robust platform with a combination of mechanical and biochemical features that have a significant potential in promoting the repair process of ACL tissue.Hydroxyapatite (HA) combined with antimicrobial agents for biomedical application can effectively avoid the bacteria infection, while HA have the good performance. In this study, we prepared silver-hydroxyapatite (Ag-HA) nanocomposites using a one-pot method consisting of three sequential steps of wet chemical precipitation, ion exchange, and a silver mirror reaction. The HA nanoparticles used as the precursor for Ag ion doping were first synthesised by wet chemical precipitation. Next, Ag+ absorbed on HA surface through ion exchange reaction. Glucose was then added to initiate the silver mirror reaction, which made the Ag+ ions reduce to Ag0 and Ag nanoparticles in situ formed on HA nanoparticles. Subsequently, Ag-HA nanocomposites with different Ag content were prepared. X-ray diffraction, SEM, EDX mapping and TEM imaging confirmed that spherical Ag nanoparticles ~20-40 nm in diameter were adhered to the surface of HA nano-rods (0.4-0.8 μm in length and 15-40 nm in diameter). The Ag content (1.9-15.2 wt%) in the Ag-HA nanocomposites was adjusted by varying the feeding Ag/Ca molar ratio (2.0-20%). The cell viability evaluation in vitro proved that Ag-HA nanocomposites had low cytotoxicity to L929 normal cells. Meanwhile, the antibacterial examinations in vitro demonstrated that Ag-HA nanocomposites had obvious antibacterial effects on Gram-positive bacteria, Gram-negative bacteria, and fungus. The antibacterial results were dose-dependent on the accumulation of silver content. The Ag-HA nanocomposites loaded PMMA resins also demonstrated a potential antibacterial activity against S. CX-5461 supplier mutans. This paper presents a convenient and bio-friendly approach for preparing Ag-HA nanocomposites with adjustable Ag content, which are a promising material for biomedical applications.Magnetic iron oxide nanoparticles (IONPs) are one of the most extensively studied materials for theranostic applications. IONPs can be used for magnetic resonance imaging (MRI), delivery of therapeutics, and hyperthermia treatment. Silk is a biocompatible material and can be used for biomedical applications. Previously, we produced spheres made of H2.1MS1 bioengineered silk that specifically carried a drug to the Her2-overexpressing cancer cells. To confer biocompatibility and targeting properties to IONPs, we blended these particles with bioengineered spider silks. Three bioengineered silks (MS1Fe1, MS1Fe2, and MS1Fe1Fe2) functionalized with the adhesion peptides F1 and F2, were constructed and investigated to form the composite spheres with IONPs carrying a positive or negative charge. Due to its highest IONP content, MS1Fe1 silk was used to produce spheres from the H2.1MS1MS1Fe silk blend to obtain a carrier with cell-targeting properties. Composite H2.1MS1MS1Fe1/IONP spheres made of silks blended at different ratios were obtained. Although the increased content of MS1Fe1 silk in particles resulted in an increased affinity of the spheres to IONPs, it decreased the binding of the composite particles to cancer cells. The H2.1MS1MS1Fe1 particles prepared at a ratio of 82 and loaded with IONPs exhibited the ability to bind to the targeted cancer cells similar to the control spheres without IONPs. Moreover, when exposed to the alternating magnetic field, these particles generated 2.5 times higher heat. They caused an almost three times higher percentage of apoptosis in cancer cells than the control particles. The blending of silks enabled the generation of cancer-targeting spheres with a high affinity for iron oxide nanoparticles, which can be used for anti-cancer hyperthermia therapy.Demand of bioactive materials that may create a bacteria-free environment while healing and regenerating the defect area is increasing day by day. Zirconia is a very interesting material because of its biocompatibility and high fracture toughness. In this research work, zirconia nanoparticles (NPs) have been synthesized using sol-gel method. Molarity of sols is varied in the range of 25 to 125 mM. The effect of acidic and basic nature of sols is studied by maintaining acidic (2) and basic (9) pH. As-synthesized NPs are made soluble in deionized (DI) water using tangerine drops. Dissolved NPs are spin coated onto glass substrate prior to characterization. Pure tetragonal phase, observed under all conditions using basic medium (pH 9), is accompanied by smaller crystallite size and unit cell volume. Presence of stabilized zirconia phase leads to higher value of density and higher mechanical strength. Nanodendrites with distinct features are observed for the sample prepared with high molarity using basic medium. Whereas, soft agglomerated nanodendrites are observed using acidic medium. Optical properties show transmission of 60-80% in the visible and infrared regions for acidic based samples and ~84% for basic samples. Direct energy band gap is varied from 4.96 eV to 5.1 eV in acidic (pH 2) and 4.91 eV to 4.97 eV in basic (pH 9) media. FTIR spectra show the formation of fundamental tetragonal band at 490 cm-1 for basic samples. Antibacterial response of zirconia is tested against E. coli, Streptococcus and Bacillus bacteria. Human teeth, bare and zirconia coated, are tested for their possible weight loss after dipping in various beverages. Zirconia coated tooth shows negligible degradation in hardness and weight after 24 hr dipping period. Thus, coatings prepared using water soluble zirconia (WSZ) nanoparticles, without the use of toxic solvents/reagents, are promising material to be used as protective coatings in biomedical applications.