Albrightkromann7504

The present investigation was focused to compare chitosan based nano-adsorbents (CZnO and CTiO2) for efficient treatment of dairy industry wastewater using Response Surface Methodology (RSM) and Artificial Neural Network (ANN) models. The nano-adsorbents were synthesized using chemical precipitation method and characterized by using scanning electron microscope with elemental detection sensor (SEM-EDS) and atomic force microscope (AFM). Maximum %RBOD (96.71 and 87.56%) and %RCOD (90.48 and 82.10%) for CZnO and CTiO2 nano-adsorbents were obtained at adsorbent dosage of 1.25 mg/L, initial biological oxygen demand (BOD) and chemical oxygen demand (COD) concentration of 100 and 200 mg/L, pH of 7.0 and 2.00, contact time of 100 and 60 min, respectively. The results obtained for both the nano-adsorbents were subject to RSM and ANN models for determination of goodness of fit in terms of sum of square errors (SSE), root mean square error (RMSE), R2 and Adj. R2, respectively. The well trained ANN model was found superior over RSM in prediction of the treatment effect. Hence, the developed CZnO and CTiO2 nano-adsorbents could be effectively used for dairy industry wastewater treatment.Recently, the utilization of wastes, recovery of high value-added products from waste, and their use as raw materials in other industries with the logic of industrial symbiosis has become an important issue. In this study, removal efficiency of Reactive Orange 16 (RO16) dye from aqueous solution was studied using TiO2 catalyst recycled from an industrial waste effluent. The recycling of TiO2 waste from a paints manufacturing industry was carried out by sintering the TiO2-containing waste. The catalyst usability of TiO2-containing powder was then investigated in the removal of RO16 dye by photocatalytic oxidation process. In photocatalytic oxidation studies, TiO2/UV and TiO2/UV/H2O2 processes were investigated, where the effect of annealing temperature, the effect of H2O2 concentration, and the adsorption and photocatalytic effects on RO16 dye removal were studied. The results showed that 100% RO16 removal was obtained for the 10 mg/L initial RO16 concentration using the TiO2 (1 g/L)/UV process. At high initial RO16 concentration (50 mg/L), 100% RO16 removal was achieved by adding 10 mM H2O2.This work constructed a divided diaphragm seawater electrolysis system with two tandem packed towers for the synergistic removal of NOx and SO2. The first tower was mainly used to oxidize NO and SO2 by AC (active chlorine), and the second tower was used to further absorb NOx. The factors affecting on NO removal, including ACC (active chlorine concentration), pH value, initial NO concentration and temperature in the oxidation tower were investigated. Moreover, the effect of different inlet gas concentrations and current values were explored. The results showed that with the increase of ACC, the NO and NOx removal efficiency increased rapidly, but when the ACC was higher than 500 mg/L [Cl2], the removal efficiency did not increase further in the oxidation tower. Low pH values in the oxidation tower were favorable for NO removal. NO removal efficiency reached a maximum at 40 °C. Higher NO and SO2 concentrations were favorable for NO removal. The decline of pH in the anode cell was not conducive to the storage of AC in the continuous electrolysis removal process. NOx and SO2 were almost completely removed after being scrubbed in the oxidation and absorption towers. The relationship between current and removal efficiency of NO and SO2 in the oxidation tower was also analyzed. Finally, the removal mechanism and the application prospects were discussed.The ultraviolet photochemical degradation process is widely applied in wastewater treatment due to its low cost, high efficiency and sustainability. selleck inhibitor In this study, a novel rotating flow reactor was developed for UV-initiated photochemical reactions. The reactor was run in a continuous flow mode, and the tangential installation of the inlet and outlet on the annular reactor improved reaction rates. Numerical modelling, which combined solute transport, radiation transfer and photochemical kinetic degradation processes, was conducted to evaluate improvement compared to current reactor designs. Methylene Blue (MB) decomposition efficiency from the modelling results and the experimental data agreed well with each other. The model results showed that a rotational motion of fluid was well developed inside the designed reactor for a wide range of inflow rates; the generation of ·OH radicals significantly depended on UV irradiation dose, and thus the degradation ratio of MB showed a strong correlation with the UV irradiation distribution. In addition, the comprehensive numerical modelling showed promising potential for the simulation of UV/H2O2 processes in rotating flow reactors.Hydroxyapatite (HAp) was synthesized from biowaste hen eggshells by wet precipitation method in which calcium hydroxide and phosphoric acid were used as precursors. The effectiveness of uranium(VI) adsorption onto HAp was investigated by batch adsorption experiments from aqueous solutions. The obtained HAp powder was characterized by X-ray diffraction, Fourier transform infrared spectroscopy, Raman spectrometry, point of zero charge and Scanning electron microscope. The factors and levels used during the experiments were pH (2-5), adsorbent mass (0.01-0.05 g), and initial U(VI) concentration (100-310 mg L-1). A Box-Behnken design combined with analysis of variance was used to interpret the main effect influencing the adsorption. The results showed that pH was the most significant parameter affecting U(VI). The kinetic data correlates well with the pseudo-second-order model. The adsorption isotherms fitted the Langmuir-1 type model with the qmax = 175.22 mg g-1 at 25 °C. The calculated value of the mean free energy indicates the chemisorption process. Under optimal conditions, the uranium effluent derived from the precipitation of ammonium uranyl carbonate removal performance of 98% was achieved. This study proved that HAp prepared from eggshell was an ecofriendly and low-cost adsorbent and was very effective for the adsorption of U(VI) from aqueous solutions.