Mooswheeler0033

ing coagulopathy.Malachite green (MG) has been widely used for controlling external fungi and parasites in the aquaculture. However, MG has been proven to be very hazardous, and the detection of MG in aquaculture environment is crucial for determining whether MG has been used within the allowed limit and for protecting the environment. Herein, a kind of copper based metal-organic frameworks (MOFs) was prepared using copper nitrate and 1,3,5-benzenetricarboxylic acid (H3BTC) as raw materials. The prepared Cu-BTC materials provide larger active area and higher accumulation capacity for MG, and meanwhile lower the charge-transfer resistance. As a result, the oxidation signal and detection sensitivity of MG are significantly improved by Cu-BTC frameworks. The linear range is 2-500 nM, and the detection limit is 0.67 nM, which is much lower than the reported values. Moreover, other usually-used aquaculture drugs have no interferences, including erythromycin, chloramphenicol, oxytetracycline, furazolidone and nitrofurazone. This method was applied in the water samples, and the results were consistent with those using high-performance liquid chromatography.Airway smooth muscle (ASM) contraction is a major pathophysiological characteristic of asthma. Although β2-adrenoceptor (β2-AR) agonists are currently used as bronchodilators, they cause rapid effect and long-term agonist-induced desensitization. Selleck AG-270 Thus, it is necessary to search for more effective and safer relaxant agents for ASM cells. In this work, bitter taste receptors (TAS2Rs) were demonstrated to be expressed in primary mouse ASM cells endogenously, and they were considered as new drug targets for asthma treatment. Traditional Chinese medicines (TCMs) contained a wide range of TAS2R agonists and some of them had the efficacy of relieving cough and asthma with less toxic side effects. Then the electronic cell-substrate impedance sensor (ECIS) was used for the first time to establish a method to detect the contraction/relaxation effects of ASM cells. Therefore, we introduced a biomimetic in vitro respiratory system using ASM cells on ECIS chips to screen for potential TCMs against asthma. Quinine, nobiletin, and picfeltarraenin IA screened in this study could effectively inhibit the ASM contraction in a concentration-dependent manner, showing potential value as novel anti-asthma drugs. Furthermore, the effective screening of anti-asthma drugs was realized based on 3D ASM cell arrays and gel imaging system. Consistent results were found and the reliability of the biomimetic in vitro respiratory system for the screening of TCMs against asthma was further verified. The biomimetic system designed in this study has the advantages of operation simplicity, high throughput, non-invasive, real-time, and high sensitivity, and therefore provides a promising drug screening platform for asthma disease.It is crucial to determine and control the metronidazole (MET) ingredient in food and pharmaceuticals for human health and food safety. Even though many sensors have been previously reported to detect MET, there is still a need for a highly selective and sensitive, easy, fast, cost-effective sensor in this area. Herein, we report a fluorescent calix[4]arene derivative (PIMC) for highly selective and sensitive and facile and rapid MET detection based on fluorescence (FL) quenching. The highest FL quenching occurs when PIMC is exposed to MET solution at 400 nm (λex = 340). Owing to the quenching efficacy of MET linearly up to 5.5 × 104 nM was obtained a detection limit of 2.44 nM. Besides, interferences of other pharmaceuticals and ions on probe performance were investigated. The FL probe was successful in MET detection without the assistance of any separation techniques in a pharmaceutical sample (tablet) with an acceptable recovery of 101.3%. The applicability of the current probe as a paper-based sensor to MET detection has been successfully tested. As a result, the proposed probe presents a fast and suitable strategy to sensitive and selective detect MET and proves a good potential for practical applications, especially pharmaceutical preparations.Oncology research uses different imaging techniques to provide information about the spatial distribution of the chemotherapy drugs used for the targeted tissues. Among them, laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) is increasingly being used to track the spatial distribution of metal-based chemotherapeutics in different tissue samples. In this investigation, instrumental parameters were optimized for the bioimaging of Pt in HT29 tumour spheroids treated with cisplatin (CDDP) or Texas Red cisplatin (TR-CDDP) using LA-ICP-MS. A high spatial resolution, using pixel dimensions of 2.0 μm × 2.5 μm, and a high sensitivity, with the limits of detection (LOD) better than 0.78 mg kg-1 Pt, was achieved. Matrix-matched gelatine standards and/or isotope dilution (ID) analyses were used to quantify the amount of Pt. Differences between the results of the Pt concentrations determined by the two quantification were less than 4%. The results of the LA analysis revealed that the Pt in the CDDP-treated tumour spheroids was localized primarily in the outer rim of the spheroids and to a lesser extent in the intermediary layer and the necrotic core. Due to the steric effects, significantly lower Pt concentrations were accumulated in the spheroids treated with TR-CDDP (2.2 times lower than in CDDP-treated spheroids, normalized to the spheroid volume), while the Pt was mostly distributed in the areas of the outer rim. Finally, imaging with confocal fluorescence microscopy, which is commonly used in oncology research, was compared with that by LA-ICP-MS. The results of the two complementary techniques demonstrated good agreement in terms of the spatial distribution of the TR-CDDP, while the intensity of the fluorescence matched well with the concentrations of Pt determined with LA-ICP-MS.The solid contact ion-selective electrodes (SC-ISEs) have been extensively studied in the field of ion sensing as they offer the possibility of miniaturization, are relatively inexpensive in comparison to other analytical techniques and allow straightforward and routine analyses of ions in a number of clinical, environmental and industrial process samples. In recent years, significant interest has grown in the development of SC-ISEs with well-defined interfacialpotentials at the membrane, solid contact, and substrate electrode interfaces. This has resulted in interesting SC-ISEs exhibiting high electrode-to-electrode potential reproducibility, for those made in a single batch of electrodes, some approaching or exceeding those observed in liquid-contact ISEs. The advancement in the potential reproducibility of SC-ISEs has been partially achieved by scrutinizing insufficiently reproducible fabrication methods of SC-ISEs, or by introducing novel control measures or modifiers to components of the ISEs. This paper provides an overview of the methods as well as the challenges in establishing and maintaining reproducible potentials during the fabrication and use of novel SC-ISEs.