Rubinsolomon7519

This goal of this minireview is to introduce the reader to the area of research concerned with exhaled breath analysis for the purpose of detecting abnormal levels of physiologically-relevant chemical markers reflective of respiratory diseases. Two main two groups of sensing methods are reviewed mass spectrometry and (bio)sensors. The discussion focuses on biosensor applications for EB and EBC analyses, which are presented in detail. The review finishes with conclusions and future perspectives, including recommendations for future near-term and long-term development of EBC biomarker sensing.Food safety is currently a significant issue for human life and health. Various fluorescent nanomaterials have been applied in the point-of-care test (POCT) for food safety as labeling materials. However, previous fluorescent nanomaterials can cause aggregation-caused quenching (ACQ), thus reducing the detection sensitivity. Conversely, aggregation-induced emission luminogens (AIEgens) are promising candidates for POCT in the food safety field because they can enhance detection sensitivity and throughput. Mycotoxins, such as aflatoxin B1 (AFB1) and cyclopiazonic acid (CPA), are a primary threat to human life and health and a significant food safety issue, and their on-site detection from farm to table is needed. Herein, an ultrasensitive point-of-care test was developed based on TPE-Br, a blue-emissive tetraphenylethylene derivative AIEgen. Under optimal conditions, this AIEgen-based lateral-flow biosensor (ALFB) allowed for a rapid response of 8 min toward AFB1 and CPA detection, with considerable sensitivities of 0.003 and 0.01 ng/mL in peanut matrices, respectively. In peanut matrices, the recoveries were 90.3%-110.0% for both mycotoxins, with relative standard deviations (RSDs) below 6%. The ALFB was further validated via UPLC-MS/MS using spiked peanut samples. AIEgens open an avenue for on-site, ultrasensitive, high-throughput detection methods and can be extensively used in point-of-care tests in food safety.Laccases are important multicopper oxidases that are involved in many biotechnological processes; however, they suffer from poor stability as well as high cost for production/purification. Herein, we found that DNA-copper hybrid nanoflowers, prepared via simple self-assembly of DNA and copper ions, exhibit an intrinsic laccase-mimicking activity, which is significantly higher than that of control materials formed in the absence of DNA. Upon testing all four nucleobases, we found that hybrid nanoflowers composed of guanine-rich ssDNA and copper phosphate (GNFs) showed the highest catalytic activity, presumably due to the affirmative coordination between guanine and copper ions. At the same mass concentration, GNFs had similar Km but 3.5-fold higher Vmax compared with those of free laccase, and furthermore, they exhibited significantly-enhanced stability in ranges of pH, temperature, ionic strength, and incubation period of time. read more Based on these advantageous features, GNFs were applied to paper microfluidic devices for colorimetric detection of diverse phenolic compounds such as dopamine, catechol, and hydroquinone. In the presence of phenolic compounds, GNFs catalyzed their oxidation to react with 4-aminoantipyrine for producing a colored adduct, which was conveniently quantified from an image acquired using a conventional smartphone with ImageJ software. Besides, GNFs successfully catalyzed the decolorization of neutral red dye much faster than free laccase. This work will facilitate the development of nanoflower-type nanozymes for a wide range of applications in biosensors and bioremediation.Ultrasounds (US) are one of the most used imaging techniques in medicine for assessing the physiological and pathological state of soft tissue. Apart from therapeutic applications, most of the interaction of the acoustic beams with tissues occur passively and without substantial modification to the physiology of the latter. However, US can also be used to remotely power implantable devices with sensing capabilities. In this study, we propose small-form devices interfaced with functionalized electrochemical electrodes for the detection of pH and lactate levels, powered by ultrasounds and data transmission through a Frequency Shift Keying (FSK) modulation technique. A custom-made piezoelectric transducer is responsible for converting the acoustic waves into electrical voltage at the device with operational levels as low as 0.5 V (power consumption of 10 μW) obtained from implantation distances of 50 mm inside tissue. This conjugated with the high sensitivity of the developed electrochemical sensors allows to detect and transmit local parameter variations below 0.1 pH (4.2 mV) and 1 mM lactate (70 nA). Potential applications include real-time access to intrabody tissue monitoring post-operatively, with the view of assessing proper soft tissue healing or infection detection by bacteria, as well as tissue cancer screening in structures such as the human breast.Signal amplification is one of the most effective ways to develop the high-performance electrochemical sensors. However, it can be more complicated for ratiometric detections. Herein, a ratiometric electrochemical aptasensor for aflatoxin B1 (AFB1) was proposed by taking advantage of a dual-amplification strategy by coupling of DNA walker (DW) with hybridization chain reaction (HCR). The special binding of AFB1 with ferrocene (Fc)-labelled aptamer triggers DW on hairpin DNA (hDNA) tracks to produce abundant double-stranded DNA (dsDNA). HCR-based strand amplification occurs on these dsDNA to absorb more methylene blue (MB). Then current ratio of MB (IMB) and Fc (IFc) is designed as a yardstick to detect AFB1. Our experiments reveal that the interaction between Fc and MB (i.e., steric hindrance, electron mediator) varies. In addition to steric hindrance, the presence of MB also acts as electron mediator, thereby facilitating the electron transfer between Fc and electrode. Such combined effect consequently depresses the efficiency of dual-amplification strategy to improve the detection. The developed ratiometric electrochemical aptasensor allows the accurate detection of AFB1 in the 0.003-3 pg mL-1 range. Our work has shed light on the amplification strategy for ratiometric sensing, and provided a new route in integrating different amplification strategies.