Cramercarson4111

With the microfluidics community embracing 3D resin printing as a rapid fabrication method, controlling surface chemistry has emerged as a new challenge. Fluorination of 3D-printed surfaces is highly desirable in many applications due to chemical inertness, low friction coefficients, antifouling properties, and the potential for selective hydrophobic patterning. Despite sporadic reports, silanization methods have not been optimized for covalent bonding with polymeric resins. As a case study, we tested the silanization of a commercially available (meth)acrylate-based resin (BV-007A) with a fluoroalkyl trichlorosilane. Interestingly, plasma oxidation was unnecessary for silanization of this resin and indeed was ineffective. Solvent-based deposition in a fluorinated oil (FC-40) generated significantly higher contact angles than deposition in ethanol or gas-phase deposition, yielding hydrophobic surfaces with contact angle >110° under optimized conditions. Attenuated total reflectance-Fourier transform infrared spectroscopy indicated that the increase in the contact angle correlated with consumption of a carbonyl moiety, suggesting covalent bonding of silane without plasma oxidation. Consistent with a covalent bond, silanization was resistant to mechanical damage and hydrolysis in methanol and was stable over long-term storage. When tested on a suite of photocrosslinkable resins, this silanization protocol generated highly hydrophobic surfaces (contact angle > 110°) on three resins and moderate hydrophobicity (90-100°) on the remainder. Selective patterning of hydrophobic regions in an open 3D-printed microchannel was possible in combination with simple masking techniques. Thus, this facile fluorination strategy is expected to be applicable for resin-printed materials in a variety of contexts including micropatterning and multiphase microfluidics.The structures and binding topologies of two binary van der Waals complexes 1,1,1,3,3,3-hexafluoro-2-propanol (HFIP)···Ne and ···Ar were investigated. The rotational spectra of these two complexes including several isotopic species containing 20Ne, 22Ne, 40Ar, 13C, and hydroxyl D were measured using a chirped pulse Fourier transform microwave spectrometer and a cavity-based Fourier transform microwave spectrometer. While HFIP was shown to exist in both the gauche and trans configurations based on previous reports, the rare gas atom is predicted to attach to HFIP in several different binding topologies, leading to a total of nine possible structural isomers for each complex. Only one isomer was detected for each species, and it corresponds to the most stable one predicted, based on the comparison of the experimental rotational constants and electric dipole moment components with the theoretical predictions and on the isotopic data. We applied quantum theory of atoms in molecules (QTAIM) and electrostatic potential calculations to examine the different rare gas binding sites and to explore the nature of the interactions in these two complexes and several previously reported alcohol···Ar complexes. The effects of fluorination are also discussed by comparison with the binary complexes of isopropanol···Ne and ···Ar.Cationic nanoparticles are known to interact with biological membranes and often cause serious membrane damage. Bax apoptosis Therefore, it is important to understand the molecular mechanism for such interactions and the factors that impact the degree of membrane damage. Previously, we have demonstrated that spatial distribution of molecular charge at cationic nanoparticle surfaces plays an important role in determining the cellular uptake and membrane damage of these nanoparticles. In this work, using diamond nanoparticles (DNPs) functionalized with five different amine-based surface ligands and small phospholipid unilamellar vesicles (SUVs), we further investigate how chemical features and conformational flexibility of surface ligands impact nanoparticle/membrane interactions. 31P-NMR T2 relaxation measurements quantify the mobility changes in lipid dynamics upon exposing the SUVs to functional DNPs, and coarse-grained molecular dynamics simulations further elucidate molecular details for the different modes of DNP-SUV interactions depending on the surface ligands. Collectively, our results show that the length of the hydrophobic segment and conformational flexibility of surface ligands are two key factors that dictate the degree of membrane damage by the DNP, while the amount of surface charge alone is not predictive of the strength of interaction.A series of Al-doped BiVO4 composites have been synthesized via the hydrothermal method for methylene blue (MB) degradation application. The reasons for the improvement of photocatalytic performance was explained from the perspective of optics. Transient photovoltage (TPV) measurements suggested that the surface states have the priority to capture photogenerated carriers, and the Al2O3 surface passivation layer can prolong the lifetime of charge carrier. The results of surface photovoltage (SPV), transient photovoltage (TPV), and surface photocurrent (SPC) measurements suggested that the coexistence of Al3+ and Al2O3 caused by the appropriate doping would improve the transfer property and prolong the lifetime of photogenerated carriers. Finally, the possible photocatalytic mechanism is expounded to illustrate the photogenerated charge behavior under visible light irradiation. This work provides a better understanding of the synergistic effect of Al-doping and Al2O3 passivation layer on enhancing the photocatalytic performance.A protocol in the preparation of functionalized N-allyl-N-aryl sulfonamides via palladium-catalyzed intramolecular decarboxylative N-allylation reaction is presented. The alkylated 2,5-cyclohexadienyl ketoesters reacted with arylsulfonamides in the presence of titanium tetrachloride and pyridine, which allows the formation of alkylated 2,5-cyclohexadienyl sulfonyl iminoesters which then undergo a palladium-catalyzed intramolecular allylic amidation through decarboxylative aromatization to provide functionalized N-allyl-N-aryl sulfonamides. This allylation protocol proceeds with good regioselectivity. Moreover, we have also shown that N-allyl-N-aryl sulfonamide can be transformed into 4-aryl-1,2,3,4-tetrahydroquinoline and nitrogen-containing β-hydroxysulfide bioactives.