Bartlettoh0618

The penetration depth in a distributed Bragg reflector (DBR) co-determines the resonance condition, quality factor, and mode volume of DBR-based microcavities. Recent studies have used an incomplete description of the penetration depth and incorrect equations. We present a complete analysis that involves three different penetration depths. We also present a series of experiments on microcavities to accurately determine the frequency and modal penetration depth of our DBRs and compare these results with theoretical predictions. The obtained results are relevant for anyone who models a DBR as an effective hard mirror if lengths of the order of the wavelength are relevant, as is the case for microcavities.We present different computational approaches for the rapid extraction of the signal parameters of discretely sampled damped sinusoidal signals. We compare time- and frequency-domain-based computational approaches in terms of their accuracy and precision and computational time required in estimating the frequencies of such signals, and observe a general trade-off between precision and speed. Our motivation is precise and rapid analysis of damped sinusoidal signals as these become relevant in view of the recent experimental developments in cavity-enhanced polarimetry and ellipsometry, where the relevant time scales and frequencies are typically within the ∼1 - 10 µs and ∼1 - 100 MHz ranges, respectively. In such experimental efforts, single-shot analysis with high accuracy and precision becomes important when developing experiments that study dynamical effects and/or when developing portable instrumentations. Our results suggest that online, running-fashion, microsecond-resolved analysis of polarimetric/ellipsometric measurements with fractional uncertainties at the 10-6 levels, is possible, and using a proof-of-principle experimental demonstration we show that using a frequency-based analysis approach we can monitor and analyze signals at kHz rates and accurately detect signal changes at microsecond time-scales.We propose and investigate an all-fiber thermo-optic modulator based on a side-polished twin-core fiber (TCF) Michelson interferometer (MI) coated with NaNdF4 nanoparticles. The MI was fabricated by tapering the splicing point between the TCF and a single mode fiber (SMF). A short suspended core fiber (SCF) is spliced to one core of the TCF to introduce a fixed optical phase difference (OPD). The side-polished core is coated with photo-thermal material NaNdF4. this website Owing to the ohmic heating of NaNdF4 nanoparticles under 808 nm pump laser, the effective refractive index of the polished core is changed, resulting in a phase shift of the MI. The MI has a significant modulation phase shift with 2.9 π near the wavelength of 1260 nm and can obtain an optical switching with a rise (fall) time of 152 (50) ms. The proposed device will have a great application potential in optical modulators due to compact structure and strong robustness.A method for modeling the irradiance spatial distribution by light-emitting diodes (LEDs) on near distance targets has been developed. The model can easily handle the complex simulation of non-homogenous emitting LEDs, multichip LEDs, LED arrays, and phosphor coated LEDs. The LED irradiation profile is obtained by image processing one photograph of the emitting LED, taken with a smartphone. The method uses image convolution or image correlation between the LED image and a special kernel. The model provides the irradiation spatial pattern in function of the irradiation distance. And the model is tested both with theory and with experimental measurements.In recent development of quantum technologies, a frequency conversion of quantum signals has been studied widely. We investigate the optic-microwave entanglement that is generated by applying an electro-optomechanical frequency conversion scheme to one mode in an optical two-mode squeezed vacuum state. We quantify entanglement of the converted two-mode Gaussian state, where surviving entanglement of the state is analyzed with respect to the parameters of the electro-optomechanical system. Furthermore, we show that there exists an upper bound for the entanglement that survives after the conversion of highly entangled optical states. Our study provides a theoretical platform for a practical quantum illumination system.We have fabricated a Si racetrack optical modulator based on a III-V/Si hybrid metal-oxide-semiconductor (MOS) capacitor. The III-V/Si hybrid MOS optical phase shifter was integrated to a Si racetrack resonator with a coupling length of 200 µm and a coupling gap of 700 nm. The fabricated Si racetrack resonator demonstrated a small VπL of 0.059 Vcm. For 10-dB optical intensity modulation, the Si racetrack resonator showed a 60% smaller driving voltage than a Mach-Zehnder interferometer modulator with the same phase shifter, leading to a better balance between high energy efficiency and large modulation bandwidth.In this paper, a novel approach to modelling intracavity second harmonic generation (SHG) in periodically poled MgO-doped lithium niobate (PPLN) is presented and verified against experimental results. This approach involves combining the coupled nonlinear wave equations with a rate equation model for a diode-pumped solid-state NdYVO4 laser, taking into account both the depletion of the fundamental wave due to the energy conversion from the fundamental wave to the SHG wave and the reduction of the fundamental wave within a laser cavity due to the loss as a result of the SHG nonlinear process. It was shown that the theoretical simulation matched the experimental results well, while also providing physical insight into the importance of the fundamental wave depletion in the intracavity SHG nonlinear processes. The resulting model is computationally simple and has the potential to generalize to the other nonlinear processes such as three-wave mixing and optical parametric oscillation.In this paper, a characteristic mode rotation (CMR) method has been proposed to design a compact metasurface antenna with a low radar cross section (RCS) in a wideband. In the proposed CMR method, the incident wave dependent complex characteristic currents corresponding to the dominant characteristic modes solved by the characteristic mode method (CMM) are calculated. With the direction of the superposition of the complex characteristic currents orthogonal to that of the incident electric field in the CMR method, the metasurface subarray with wideband polarization conversion characteristic is designed. By arranging the metasurface subarray in a rotation way, a metasurface array with a compact size of 1.28λ0×1.28λ0 is designed for wideband RCS reduction. A miniature circle patch antenna is integrated with the metasurface array to achieve not only good radiation performance but also low observability for the in-band and the out-of-band of the antenna. Simulated and measured results demonstrate that the proposed miniature metasurface antenna designed by the CMR method has a good broadside radiation pattern, a maximal gain of 10.