Vincentgarner8203

Vitamin B12 derivatives (Cbls = cobalamins) exhibit photolytic properties upon excitation with light. These properties can be modulated by several factors including the nature of the axial ligands. Upon excitation, homolytic cleavage of the organometallic bond to the upper axial ligand takes place in photolabile Cbls. The photosensitive nature of Cbls has made them potential candidates for light-activated drug delivery. The addition of a fluorophore to the nucleotide loop of thiolato Cbls has been shown to shift the region of photohomolysis to within the optical window of tissue (600-900 nm). With this possibility, there is a need to analyze photolytic properties of unique Cbls which contain a Co-S bond. Herein, the photodissociation of one such Cbl, namely, N-acetylcysteinylcobalamin (NACCbl), is analyzed based on density functional theory (DFT) and time-dependent DFT (TD-DFT) calculations. The S0 and S1 potential energy surfaces (PESs), as a function of axial bond lengths, were computed to determine the mechanism of photodissociation. Like other Cbls, the S1 PES contains metal-to-ligand charge transfer (MLCT) and ligand field (LF) regions, but there are some unique differences. Interestingly, the S1 PES of NACCbl contains three distinct minima regions opening several possibilities for the mechanism of radical pair (RP) formation. The mild photoresponsiveness, observed experimentally, can be attributed to the small gap in energy between the S1 and S0 PESs. Compared to other Cbls, the gap shown for NACCbl is neither exactly in line with the alkyl Cbls nor the nonalkyl Cbls.Owing to the small energy differences between its polymorphs, MoTe2 can access a full spectrum of electronic states from the 2H semiconducting state to the 1T' semimetallic state and from the Td Weyl semimetallic state to the superconducting state in the 1T' and Td phase at low temperature. Thus, it is a model system for phase transformation studies as well as quantum phenomena such as the quantum spin Hall effect and topological superconductivity. Careful studies of MoTe2 and its potential applications require large-area MoTe2 thin films with high crystallinity and thickness control. Here, we present cm2-scale synthesis of 2H-MoTe2 thin films with layer control and large grains that span several microns. Layer control is achieved by controlling the initial thickness of the precursor MoO x thin films, which are deposited on sapphire substrates by atomic layer deposition and subsequently tellurized. Despite the van der Waals epitaxy, the precursor-substrate interface is found to critically determine the uniformity in thickness and grain size of the resulting MoTe2 films MoTe2 grown on sapphire show uniform films while MoTe2 grown on amorphous SiO2 substrates form islands. This synthesis strategy decouples the layer control from the variabilities of growth conditions for robust growth results and is applicable to growing other transition-metal dichalcogenides with layer control.The quaternary structure is an important feature regulating protein function. Native mass spectrometry contributes to untangling quaternary structures by preserving the integrity of protein complexes in the gas phase. NVP-TAE684 ALK inhibitor Tandem mass spectrometry by collision-induced dissociation (CID) can then be used to release subunits from these intact complexes, thereby providing structural information on the stoichiometry and topology. Cumulatively, such studies have revealed the preferred release of peripheral subunits during CID. In contrast, here we describe and focus on dissociation pathways that release nonperipheral subunits from hetero-complexes in CID at high collision energies. We find that nonperipheral subunits are ejected with a high propensity, as a consequence of sequential dissociation events, upon initial removal of peripheral subunits. Alternatively, nonperipheral subunits can be released directly from a charge-reduced or an elongated intact complex. As demonstrated here for a range of protein assemblies, releasing nonperipheral subunits under controlled conditions may provide unique structural information on the stoichiometry and topology of protein complexes.Double deprotonation of the salt [Ph2B(PMe3)2][OTf] (1) provides access to a bis(ylide)diphenylborate ligand that is readily transferred in situ to iron(II). Depending on the reaction stoichiometry, both the "ate" complex [Ph2B(Me2PCH2)2Fe(μ-Cl)2Li(THF)2] (2) and the homoleptic complex [Ph2B(Me2PCH2)2]2Fe(3) can be prepared from FeCl2(THF)1.5. Further reaction of 3 with FeCl2(THF)1.5 produces the chloride-bridged dimer [Ph2B(Me2PCH2)2Fe(μ-Cl)2Fe(CH2PMe2)2BPh2](4). Attempts to reduce or alkylate 4 provide 3 as the only isolable product, likely a consequence of the low steric hindrance of the bis(ylide)diphenylborate ligand. On the other hand, reaction of 4 with the strong field ligand CN t Bu provides the six-coordinate, diamagnetic complex [Ph2B(Me2PCH2)2Fe(CN t Bu)4][Cl](5). Electronic structure calculations for the bis(ylide)diphenylborate ligand and homoleptic complex 3 suggest that the C(ylide) atoms are strong σ-donors with little π-bonding character. These initial results suggest the potential for this bis(ylide)diphenylborate ligand in coordination chemistry.Multiblock copolymers (MBCs) are fascinating in the field of biology-polymer chemistry interfaces. Synthesizing libraries of MBCs with tailor-made functionality is challenging as it involves multiple steps. Herein, a simple synthesis, analogous to polyurethane/Michael addition reactions, has been introduced to obtain a library of derivatizable MBCs. Nucleophilic substitution polymerization (SNP) of poly(ε-caprolactone) and poly(ethylene glycol) blocks containing activated halide termini by primary mono/di/coamines or clickable amines provides functional MBCs. The structure of amines directs the properties of the MBCs. The self-assembly of small molecular weight primary diamine-based MBCs shows controlled release of hydrophobic model guest molecules and therapeutics. The primary diamine (no dangling chain) helps to form MBC micelles having a relatively tight core with a low diffusion property. Antimicrobial property in the MBCs has been introduced by separating the cationic centers from the lipophilic groups using a coamine as a nucleophilic agent and a small molecular weight dihalide as a chain extender.