Gustavsenhalberg9062

To grasp the properties of GBs in depth, the molecular dynamics (MD) simulations are performed, and the corresponding results indicate that temperature has very little impact on the GBs' shape. A phase transition process of the substance inside GBs is also revealed. Moreover, a two-dimensional (2D) solid nitrogen is discovered by MD simulations. The simplicity of our protocol paves the way to engineer high-pressure microreaction vessels and fabricate porous graphene membranes.Atomic oxygen (AO) has an important influence on the performance of solid lubricating materials applied in space. The tribological behaviors of both sputtered WS2 films without and with a dense layer were mainly investigated under the ex situ AO irradiation condition. AO irradiation results in the worse tribological property for the WS2 film without a dense layer. On the contrary, it is surprising that the WS2 film with the dense layer exhibits a lower friction coefficient after irradiation, which is different from the reported results that the solid lubricating films always increased the friction and wear because the surfaces of the films were oxidized by AO. Meanwhile, it is found that the generated W oxides contributes to the partial surface of the wear track becoming smooth because of the shear and slip of crystal planes for WS2 crystals on the surface of the dense layer. Eventually, the lubricating mechanisms of the irradiated WS2 films are also revealed via correlating the friction and wear characteristics of the films.The almost ancient and very sensitive silver fulminate (SF), which was involved in the establishment of fundamental chemical concepts, was desensitized for the first time with different nitrogen-rich triazoles and tetrazoles, yielding SF complexes [Ag x (CNO) x (N-Ligand) y ] (x = 1-4; y = 1-3). These were accurately characterized (X-ray diffraction, scanning electron microscopy, IR, elemental analysis, differential thermal analysis, and thermogravimetric analysis) and investigated concerning their energetic character. The highly energetic coordination compounds suddenly show, in contrast to SF, sensitivities in a manageable range and are therefore safer to handle. In particular, compounds [Ag4(CNO)4(BTRI)] [3; BTRI = 4,4'-bis(1,2,4-triazole)] and [Ag4(CNO)4(2,2-dtp)] [8; 2,2-dtp = 1,3-di(tetrazol-1-yl)propane] show values in the range of desired lead styphnate alternatives with similar energetic performances. The crystal structure experiments reveal silver cluster formation in all complexes with distinct argentophilic interactions close to 2.77 Å. Furthermore, it was possible to synthesize 8 in a one-pot reaction, avoiding the isolation of highly sensitive SF.Deterministic positioning and assembly of colloidal nanoparticles (NPs) onto substrates is a core requirement and a promising alternative to top-down lithography to create functional nanostructures and nanodevices with intriguing optical, electrical, and catalytic features. Capillary-assisted particle assembly (CAPA) has emerged as an attractive technique to this end, as it allows controlled and selective assembly of a wide variety of NPs onto predefined topographical templates using capillary forces. One critical issue with CAPA, however, lies in its final printing step, where high printing yields are possible only with the use of an adhesive polymer film. To address this problem, we have developed a template dissolution interfacial patterning (TDIP) technique to assemble and print single colloidal AuNP arrays onto various dielectric and conductive substrates in the absence of any adhesion layer, with printing yields higher than 98%. The TDIP approach grants direct access to the interface between the AuNP and the target surface, enabling the use of colloidal AuNPs as building blocks for practical applications. The versatile applicability of TDIP is demonstrated by the creation of direct electrical junctions for electro- and photoelectrochemistry and nanoparticle-on-mirror geometries for single-particle molecular sensing.Plasmonic-based photodetectors are receiving increased attention because simple structural changes can make the photodetectors spectrally sensitive. buy PX-12 In this study, asymmetric gold nanostructures are used as simple structures for photodetection via the photothermoelectric response. These single metal photodetectors use localized optical absorption from plasmon resonances of gold nanowires at desired wavelengths to generate temperature gradients. Combined with a geometry-dependent Seebeck coefficient, the result is a net electrical signal when the whole geometry is illuminated, with spectral sensitivity and polarization dependence from the plasmon resonances. We show experimental results and simulations of single-wavelength photodetectors at two wavelengths in the near IR range 785 and 1060 nm. Based on simulation results and a model for the geometry-dependent Seebeck response, we demonstrate a photodetector structure that generates polarization-sensitive responses of opposite signs for the two wavelengths. The experimental photothermoelectric results are combined with simulations to infer the geometry dependence of the Seebeck response. These results can be used to increase the responsivity of these photodetectors further.Viruses have been a continuous threat to human beings. The coronavirus disease 2019 (COVID-19), caused by severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2), has led to a pandemic that is still ongoing worldwide. Previous pandemic influenza A virus (pH1N1) might be re-emerging through a drug-resistant mutation. We report a colorimetric viral detection method based on the clustered regularly interspaced short palindromic repeats (CRISPR)/Cas9 endonuclease dead (dCas9) system. In this method, RNA in the viral lysate was directly recognized by the CRISPR/dCas9 system with biotin-protospacer adjacent motif (PAM)-presenting oligonucleotide (PAMmer). Streptavidin-horseradish peroxidase then bound to biotin-PAMmer, inducing a color change through the oxidation of 3,3',5,5'-tetramethylbenzidine. Using the developed method, we successfully identified SARS-CoV-2, pH1N1, and pH1N1/H275Y viruses by the naked eye. Moreover, the detection of viruses in human nasopharyngeal aspirates and sputum was demonstrated. Finally, clinical samples from COVID-19 patients led to a successful diagnosis.