Potterbowman6177

Solute storage and release in groundwater are key processes in solute transport for groundwater remediation and protection. In karst areas where concentrated recharge conditions exist, pollution incidents can easily occur in springs that are hydraulically connected to densely inhabited karst depressions. The intrinsic heterogeneity common in karst media makes modeling solute transport very difficult with great uncertainty. Meanwhile, it is noteworthy that solute storage and release within subsurface conduits and fissures exhibit strong controlling function on pollutant attenuation during underground floods. Consequently, in this paper, we identified and estimated the solute storage and release processes in karst water systems under concentrated recharge conditions. The methodology uses the advection-dispersion method and field tracer tests to characterize solute transport in different flow paths. Two solute transport pathways were established (i.e., linear pathway (direct transport through karst conduits) and dynamic pathway (flow through fissures)). Advection-dispersion equations were used to fit the breakthrough curves in conduit flow, while the volume of solute storage in fissures were calculated by segmenting the best fitting curves from the total breakthrough curves. The results show that, greater recharge flow or stronger dynamic conditions leads to lower solute storage rate, with the storage rate values less than 10% at high water level conditions. Super-TDU In addition, longer residence time was recorded for solute exchange between conduits and fissures at the low water level condition, thereby contributing to a higher solute storage rate of 26% in the dynamic pathway.Conventional synthetic sorbents for oil spill removal are the most widely applied materials, although they are not the optimal choices from an economic and environmental point of view. The use of inexpensive, abundant, non-toxic, biodegradable, and reusable lignocellulosic materials might be an alternative to conventional sorbents, with obvious positive impact on sustainability and circular economy. The objective of this paper was to review reports on the use of natural-based adsorbing materials for the restoration of water bodies threatened by oil spills. The use of raw and modified natural sorbents as a restoration tool, their sorption capacity, along with the individual results in conditions that have been implemented, were examined in detail. Modification methods for improving the hydrophobicity of natural sorbents were also extensively highlighted. Furthermore, an attempt was made to assess the advantages and limitations of each natural sorbent since one material is unlikely to encompass all potential oil spill scenarios. Finally, an evaluation was conducted in order to outline an integrated approach based on the terms of material-environment-economy.Magnetic hydrogels have been commonly used in biomedical applications. As magnetite nanoparticles (MNPs) exhibit peroxidase enzyme-like activity, magnetic hydrogels have been actively used as signal transducers for biomedical assays. Droplet microfluidics, which uses photoinitiated polymerization, is a preferred method for the synthesis of magnetic hydrogels. However, light absorption by MNPs makes it difficult to obtain fully polymerized and homogeneous magnetic hydrogels through photoinitiated polymerization. Several methods have been reported to address this issue, but few studies have focused on investigating the light absorption properties of photoinitiators. In this study, we developed a simple method for the synthesis of poly(ethylene glycol) (PEG)-based uniform magnetic hydrogels that exploits the high ultraviolet absorption of a photoinitiator. Additionally, we investigated this effect on shape deformation and structural uniformity of the synthesized magnetic hydrogels. Two different photoinitiators, Darocur 1173 and lithium phenyl (2,4,6-trimethylbenzoyl) phosphinate (LAP), with significantly different UV absorption properties were evaluated based on the synthesis of magnetic hydrogels. The magnetic characteristics of the PEG-stabilized MNPs in hydrogels were investigated with a vibrating sample magnetometer. Finally, the colorimetric detection of hydrogen peroxide and glucose was conducted based on the enzyme-like property of MNPs and repeated several times to observe the catalytic activity of the magnetic hydrogels.Molecular recognition is a specific non-covalent and frequently reversible interaction between two or more systems based on synthetically predefined character of the receptor. This phenomenon has been extensively studied over past few decades, being of particular interest to researchers due to its widespread occurrence in biological systems. In fact, a straightforward inspiration by biological systems present in living matter and based on, e.g., hydrogen bonding is easily noticeable in construction of molecular probes. A separate aspect also incorporated into the molecular recognition relies on the direct interaction between host and guest with a covalent bonding. To date, various artificial systems exhibiting molecular recognition and based on both types of interactions have been reported. Owing to their rich optoelectronic properties, chromophores constitute a broad and powerful class of receptors for a diverse range of substrates. This review focuses on BODIPY and porphyrin chromophores as probes for molecular recognition and chiral discrimination of amino acids and their derivatives.Spirolides belong to a group of marine phycotoxins produced by the marine planktonic dinophyte Alexandrium ostenfeldii. Composed of an imine moiety and a spiroketal ring system within a macrocylcle, spirolides are highly diverse with toxin types that vary among different strains. This study aims to characterize the spirolides from clonal A. ostenfeldii strains collected from the Netherlands, Greenland and Norway by mass spectral techniques. The structural characterization of unknown spirolides as inferred from high-resolution mass spectrometry (HR-MS) and collision induced dissociation (CID) spectra revealed the presence of nine novel spirolides that have the pseudo-molecular ions m/z 670 (1), m/z 666 (2), m/z 696 (3), m/z 678 (4), m/z 694 (5), m/z 708 (6), m/z 720 (7), m/z 722 (8) and m/z 738 (9). Of the nine new spirolides proposed in this study, compound 1 was suggested to have a truncated side chain in lieu of the commonly observed butenolide ring in spirolides. Moreover, there is indication that compound 5 might belong to new spirolide subclasses with a trispiroketal ring configuration having a 656 trispiroketal ring system. On the other hand, the other compounds were proposed as C- and G-type SPX, respectively. Compound 7 is proposed as the first G-type SPX with a 10-hydroxylation as usually observed in C-type SPX. This mass spectrometry-based study thus demonstrates that structural variability of spirolides is larger than previously known and does not only include the presence or absence of certain functional groups but also involves the triketal ring system.The mechanisms involved in regulation of quiescence, proliferation, and reprogramming of Neural Stem Progenitor Cells (NSPCs) of the mammalian brain are still poorly defined. Here, we studied the role of the transcriptional co-factor TAZ, regulated by the WNT and Hippo pathways, in the homeostasis of NSPCs. We found that, in the murine neurogenic niches of the striatal subventricular zone and the dentate gyrus granular zone, TAZ is highly expressed in NSPCs and declines with ageing. Moreover, TAZ expression is lost in immature neurons of both neurogenic regions. To characterize mechanistically the role of TAZ in neuronal differentiation, we used the midbrain-derived NSPC line ReNcell VM to replicate in a non-animal model the factors influencing NSPC differentiation to the neuronal lineage. TAZ knock-down and forced expression in NSPCs led to increased and reduced neuronal differentiation, respectively. TEADs-knockdown indicated that these TAZ co-partners are required for the suppression of NSPCs commitment to neuronal differentiation. Genetic manipulation of the TAZ/TEAD system showed its participation in transcriptional repression of SOX2 and the proneuronal genes ASCL1, NEUROG2, and NEUROD1, leading to impediment of neurogenesis. TAZ is usually considered a transcriptional co-activator promoting stem cell proliferation, but our study indicates an additional function as a repressor of neuronal differentiation.European legislation overall agrees that apple juice concentrate is allowed to be used to some extent in cider production. However, no comprehensive research is available to date on the differences in suitability for fermentation between fresh apple juice and that of reconstituted apple juice concentrate. This study aimed to apply freshly pressed juice and juice concentrate made from the same apple cultivar as a substrate for cider fermentation. Differences in yeast performance in terms of fermentation kinetics and consumption of nutrients have been assessed. Fermented ciders were compared according to volatile ester composition and off-flavor formation related to hydrogen sulfide. Based on the results, in the samples fermented with the concentrate, the yeasts consumed less fructose. The formation of long-chain fatty acid esters increased with the use of reconstituted juice concentrate while the differences in off-flavor formation could not be determined. Overall, the use of the concentrate can be considered efficient enough for the purpose of cider fermentation. However, some nutritional supplementation might be required to support the vitality of yeast.Graphene and carbon nanotube (CNT)-based gas/vapor sensors have gained much traction for numerous applications over the last decade due to their excellent sensing performance at ambient conditions. Inkjet printing various forms of graphene (reduced graphene oxide or modified graphene) and CNT (single-wall nanotubes (SWNTs) or multiwall nanotubes (MWNTs)) nanomaterials allows fabrication onto flexible substrates which enable gas sensing applications in flexible electronics. This review focuses on their recent developments and provides an overview of the state-of-the-art in inkjet printing of graphene and CNT based sensors targeting gases, such as NO2, Cl2, CO2, NH3, and organic vapors. Moreover, this review presents the current enhancements and challenges of printing CNT and graphene-based gas/vapor sensors, the role of defects, and advanced printing techniques using these nanomaterials, while highlighting challenges in reliability and reproducibility. The future potential and outlook of this rapidly growing research are analyzed as well.Venomous snakes are important subjects of study in evolution, ecology, and biomedicine. Many venomous snakes have alpha-neurotoxins (α-neurotoxins) in their venom. These toxins bind the alpha-1 nicotinic acetylcholine receptor (nAChR) at the neuromuscular junction, causing paralysis and asphyxia. Several venomous snakes and their predators have evolved resistance to α-neurotoxins. The resistance is conferred by steric hindrance from N-glycosylated asparagines at amino acids 187 or 189, by an arginine at position 187 that has been hypothesized to either electrostatically repulse positively charged neurotoxins or sterically interfere with α-neurotoxin binding, or proline replacements at positions 194 or 197 of the nAChR ligand-binding domain to inhibit α-neurotoxin binding through structural changes in the receptor. Here, we analyzed this domain in 148 vertebrate species, and assessed its amino acid sequences for resistance-associated mutations. Of these sequences, 89 were sequenced de novo. We find widespread convergent evolution of the N-glycosylation form of resistance in several taxa including venomous snakes and their lizard prey, but not in the snake-eating birds studied.