Santiagozhang2565

This review article highlights the current state of knowledge regarding the enzymatic reactions used in converting biobased wastes (lignocellulosic biomass, sugar, phenolic acid, triglyceride, fatty acid, and glycerol) and greenhouse gases (CO2 and CH4) into value-added products and discusses the current progress made in their metabolic engineering. The commercial aspects and life cycle assessment of products from enzymatic and metabolic engineering are also discussed. Continued development in the field of metabolic engineering would offer diversified solutions which are sustainable and renewable for manufacturing valuable chemicals.Polarization dynamics in ferroelectric materials are explored via automated experiment in piezoresponse force microscopy/spectroscopy (PFM/S). A Bayesian optimization (BO) framework for imaging is developed, and its performance for a variety of acquisition and pathfinding functions is explored using previously acquired data. The optimized algorithm is then deployed on an operational scanning probe microscope (SPM) for finding areas of large electromechanical response in a thin film of PbTiO3, with results showing that, with just 20% of the area sampled, most high-response clusters were captured. This approach can allow performing more complex spectroscopies in SPM that were previously not possible due to time constraints and sample stability. Improvements to the framework to enable the incorporation of more prior information and improve efficiency further are modeled and discussed.Photocatalytic artificial fixation of N2 to NH3 occurs over NaYF4Yb,Tm (NYF) upconversion nanoparticles (NPs) decorated carbon nitride nanotubes with nitrogen vacancies (NYF/NV-CNNTs) in water under near-infrared (NIR) light irradiation. NYF NPs with a particle size of ca. Thapsigargin 20 nm were uniformly distributed on the surface of NV-CNNTs. The NYF/NV-CNNTs with 15 wt % NYF exhibited the highest NH3 production yield of 1.72 mmol L-1 gcat-1, corresponding to an apparent quantum efficiency of 0.50% under NIR light illumination, and about three times higher the activity of the bare CNNTs under UV-filtered solar light. 15N isotope-labeling NMR results confirm that the N source of ammonia originates from the photochemical N2 reduction. The spectroelectrochemical measurements reveal that NVs can greatly facilitate the photogenerated electron transfer without energy loss, while the presence of NYF NPs shifts both the deep trap state and the edge of conduction band toward a lower potential. Moreover, NYF NPs endow the photocatalyst with a NIR light absorption via the fluorescence resonance energy transfer process, and NVs have the ability to enhance the active sites for a stronger adsorption of N2 and decrease the surface quenching effect of NYF NPs, which thus can promote the energy migration within the heterojunctions. This work opens the way toward full solar spectrum photocatalysis for sustainable ammonia synthesis under aqueous system.We fabricate on-chip solid-state nanofluidic-2D nanopore systems that can limit the range of motion for DNA in the sensing region of a nanopore. We do so by creating devices containing one or more silicon nitride pores and silicon nitride pillars supporting a 2D pore that orient DNA within a nanopore device to a restricted geometry, yet allow the free motion of ions to maintain a high signal-to-noise ratio. We discuss two concepts with two and three independent electrical connections and corresponding nanopore chip device architectures to achieve this goal in practice. Here, we describe device fabrication and transmission electron microscope (TEM) images, and provide simulated translocations based on the finite element analysis in 3D to demonstrate its merit. In both methods, there is a main 2D nanopore which we refer to as a "sensing" nanopore (monolayer MoS2 in this paper). A secondary layer is either an array of guiding pores sharing the same electrode pair as the sensing pore (Method 1) or a single, independently contacted, guiding pore (Method 2). These pores are constructed parallel to the "sensing" pore and serve as "guiding" elements to stretch and feed DNA into the atomically thin sensing pore. We discuss the practical implementation of these concepts with nanofluidic and Si-based technology, including detailed fabrication steps and challenges involved for DNA applications in solution.The coronavirus pandemic is caused by the SARS-CoV-2. Vaccination appears to offer the way out of this pandemic. Vaccines against this virus make use of the SARS-CoV-2's spike protein, an essential protein on the surface of the virus that it uses to attach itself to the host cells. In viral vector vaccines (AstraZeneca, Sputnik, Johnson & Johnson) the gene for the spike protein is introduced into an adenovirus. Following vaccination, the modified adenovirus will infect cells of the host, which will subsequently start to produce the spike protein, causing an immune response. RNA vaccines (Pfizer, Moderna) only introduce messenger RNA for the spike protein into host cells, which the messenger RNA uses to produce spike protein. Viral vector vaccines and RNA vaccines are not only faster to develop and safer to produce than traditional vaccines, they are also easier to modify to new viruses and virus variants. The latter may be of great importance for future pandemics.

To report anatomical and functional outcomes of non-primary retinectomy for rhegmatogenous retinal detachment (RRD) with grade C proliferative vitreoretinopathy (PVR-C), to assess the structural and functional macular changes in successful eyes.Methods retrospective single-centre cohort study one hundred-one consecutive retinectomies of 101 eyes affected by RRD with PVR-C between January 2014-February 2020 were included.Results mean preoperative BCVA was 1.48 ± 0.71 logMAR (20/604 Snellen equivalent). Anatomical success rate was 78.2% after one retinectomy and 83.1% after two retinectomies. Final BCVA ≥ 20/200 was achieved in 29% of cases, 8% gained ≥ 20/80. Final mean postoperative BCVA of successes with oil in situ was 1.68 ± 0.59 (20/957 Snellen equivalent) compared with 1.07 ± 0.63 logMAR (20/235 Snellen equivalent) of successes after oil removal (p=0.00005).Post-operative macular OCT was obtained from 60/84 successes (71%). Normal macular profile was found in 3%, while majority demonstrated exudative maculopathy (51.