Carstensantonsen0354

Z Iurium Wiki

Verze z 10. 10. 2024, 22:36, kterou vytvořil Carstensantonsen0354 (diskuse | příspěvky) (Založena nová stránka s textem „The unit weight potential dermal exposure (UWPDE) of hand-held power sprayers was 60% lower than that of manual sprayers, indicating that hand-held power s…“)
(rozdíl) ← Starší verze | zobrazit aktuální verzi (rozdíl) | Novější verze → (rozdíl)

The unit weight potential dermal exposure (UWPDE) of hand-held power sprayers was 60% lower than that of manual sprayers, indicating that hand-held power sprayers were safer than those of manual sprayers. These findings revealed that trinexapac-ethyl posed relatively higher exposure risks to manual sprayer workers than other operator workers in golf course, mainly responsible for body sections of the chest and back and thigh.In the present study, a magnetic adsorbent, rhein-coated magnetic Fe3O4 nanoparticle (RMNP), for Pb2+ and Mg2+ had been developed, and adsorption mechanism was studied via low-field NMR. RMNP was characterized by TEM, FTIR, and XRD. RMNP could adsorb and remove Pb2+ and Mg2+ from water and was successfully applied to remove Pb2+ and Mg2+ from wastewater, with satisfactory recovery rates and high adsorption capacities. The calculated maximum adsorption capacity for Mg2+ and Pb2+ was approximately 69.3 and 64.9 mg g-1 of RMNP, respectively, which was better than some results reported. Low-field NMR results showed that Pb2+ or Mg2+ enhanced the T2 relaxation time of RMNP, which suggested that RMNP selectively coordinated with Pb2+ or Mg2+ and led to the aggregation of RMNP, furthermore removal of Pb2+ or Mg2+ from water. The standard curves for △T2-cation concentration exhibited good line correlation. The linear ranges were from 4.2 × 10-6 to 2.0 × 10-4 mol L-1 for Pb2+ and from 5.0 × 10-6 mol L-1 to 1.0 × 10-4 mol L-1 for Mg2+, respectively. The limits of detection were 1.4 × 10-6 mol L-1 for Pb2+ and 2.1 × 10-6 mol L-1 for Mg2+, respectively. In short, low-field NMR could clearly display the interaction between RMNP and Pb2+ or Mg2+, even be used to detect Pb2+ or Mg2+ in suitable condition. Besides, this method could be expanded to study the interaction between other magnetic adsorbents and analytes.The purpose of the present study was to investigate the efficacy of the experimental formulations of the metribuzin (MET) and tribenuron-methyl (TBM) herbicides embedded in the matrix of degradable poly-3-hydroxybutyrate blended with wood flour in field-grown tomato and beet crops infested by weeds. There is a necessity to develop environmentally friendly and effective means to protect plants because of the shortcomings of the free herbicide forms such as the environmentally unsafe spray application of solutions and suspensions of the widespread metribuzin and tribenuron-methyl herbicides, removal from soil during watering events and rains, and transport to natural aquatic environments, where the herbicides accumulate in the trophic chains of biota. Free TBM is also rapidly inactivated in soil and metabolized to nontoxic products in plants. The efficacy of experimental formulations of metribuzin and tribenuron-methyl embedded in the matrix of degradable poly-3-hydroxybutyrate blended with wood flour was tested in field-grown tomato and beet crops infested with weeds. Application of metribuzin resulted in the highest productivity of tomatoes (2.3 kg/m2) and table beet (3.4 kg/m2), improved biometric parameters of tomato fruits and beet roots, and caused reduction in nitrate nitrogen concentrations in them. The mode of herbicide delivery did not affect sugar contents, but application of both metribuzin and tribenuron-methyl induced a 1.7-fold and 1.4-fold, respectively, increase in vitamin C concentrations in tomato fruits and beet roots relative to the vegetables grown on the subplots treated with free herbicides and the intact plants. Embedded herbicides can be used as preemergence herbicides in the field. Fig. a Graphical abstract.There is an increase in concern about the hazardous effects of radioactivity due to the presence of undesirable radioactive substances in our vicinity. Nuclear accidents such as Chernobyl (1986) and Fukushima (2011) have further raised concerns towards such incidents which have led to contamination of water bodies. Conventional methods of water purification are less efficient in decontamination of radioisotopes. They are usually neither cost-effective nor environmentally friendly. However, nanotechnology can play a vital role in providing practical solutions to this problem. Nano-engineered materials like metal oxides, metallic organic frameworks, and nanoparticle-impregnated membranes have proven to be highly efficient in treating contaminated water. Their unique characteristics such as high adsorption capacity, large specific surface area, high tensile strength, and excellent biocompatibility properties make them useful in the field of water purification. This review explores the present status and future prospects of nanomaterials as the next-generation water purification systems that can play an important role in the removal of heavy metals and radioactive contaminants from aqueous solutions.The objective of this work was to investigate the modification of soil contaminated with phenanthrene (PHE) by electro-kinetic remediation (EKR) process using response surface methodology (RSM). The soil sample was obtained from the subgrades (0-30 cm) of an area close to Shahroud City, Northeast of Iran. The effect of variables such as initial pH, voltage, electrolyte concentration, and reaction time on PHE removal was studied. Based on the results obtained from the central composite design (CCD) experiment, the highest and lowest amount of PHE removal was 97 and 20%, respectively. In this study, the variables A, B, C, AB, AC, and C2 with a p value less then 0.05 were significant model terms and the parameter of the lack of fit was not significant (p value = 0.0745). Findings indicated that the "predicted R-squared" of 0.9670 was in reasonable agreement with the "adj R-squared" of 0.9857 and the plot of residual followed a normal distribution and approximately linear. Also, the kinetic rates of the removal PHE by the EKR process best fitted with a first-order kinetic model (R2 0.926). Results of the investigation of the effective variables showed that in values of pH 3, time of 168 h, voltage of 3 V, and electrolyte concentration of 4 mg/L, the removal efficiency of PHE reached 96.6%. Graphical abstract.Diethyl phthalate (DEP) is a pollutant which can be found on soils as a result of its widespread application in plastic industry. Soil contaminated with DEP requires the application of different chemical methods to attain its remediation. Among these methods, ozonation has proven to be effective against toxic soil pollutants. #link# The presence of metal oxides in soil is a possible source of catalytic effect. In this study, it was analyzed the catalytic effect of goethite (α-FeOOH), hematite (α-Fe2O3), and gibbsite (γ-Al(OH)3) in combination with O3 to achieve DEP decomposition. The DEP elimination efficiency by ozonation on the sand increased according to the following order without catalyst  less then  γ-Al(OH)3  less then  α-Fe2O3  less then  α-FeOOH. Among these three oxides, goethite has the highest OH groups density. The reaction of OH groups and O3 favors the formation of oxidant species, such as O2•- and OH•. The effect of the moisture content, the catalyst concentration, and the type of soil (sand and calcined soil) were also studied. The latter had a significant influence on the total organic carbon (TOC) removal. The mineralization degree was 84% in the O3-soil system, while only 40% was obtained with O3-sand (α-FeOOH) in dry sand after 8 h of treatment. Calcined soil promoted the increase of TOC removal due to the presence of different metal oxides, which were active centers for O3 decomposition. The toxicity tests of the three reaction systems (O3-sand, O3-sand (α-FeOOH), and O3-soil) were evaluated on lettuce seed germination before and after DEP ozonation.Innovative titania nanostructures were synthesized via efficient and prolific liquid phase deposition route and efficiently utilized for catalytic degradation of Eosin Y. link2 The as-synthesized TiO2@ITO nanostructures were subjected to various characterization tactics that confirmed the efficacious fabrication of nanostructures. The minute size of particles around 5-6 nm having anatase crystalline phase and concrete like morphology was greatly revealed by atomic force microscopy, XRD, and SEM, respectively. The resulting nanoconcretes were employed for photocatalytic degradation of Eosin Y dye in aqueous medium. The effects of various experimental parameters such as the reducing agent concentration, sunlight, time, catalytic dose, and microwave power were investigated for the potential photocatalytic degradation. The proposed TiO2@ITO nanostructures showed potential photocatalytic efficiency then previously reported nanomaterial for degradation of toxic Eosin Y dye; it shows approximately 99.8% dye degraded within 50-60 s using only 100 μg of nanocatalyst under optimized conditions. Owing to minute size, topography and electron-hole pair abilities TiO2@ITO nanostructures suggest an exceptional icon at the commercial level for successful degradation of toxic pollutants.Graphical abstract.This study aimed at determining the cadmium phytoextraction potential of three Populus alba L. clones cultivated in the presence of increasing sodium chloride concentrations. Plantlets of a commercial and two autochthonous poplar clones were grown in perlite with nutrient solution enriched in CdSO4 (50 and 100 μM) and NaCl (25 and 50 mM), administered either alone or in combination. The three clones showed significant variation not only in cadmium and salt tolerance, accumulation and content, but also in the effect of the interaction between the two elements on these parameters. The toxic effect of Cd and salt excess on plants was mutually exacerbated by the presence of both. Even though the outcome of the joint treatment was always a decrease in shoot Cd or Na accumulation, the three clones showed variation in the extent of such reduction. Evaluating Tolinapant clinical trial per plant shoot, the fast-growing commercial clone displayed the highest phytoextraction potential for Cd and Na, either alone or in mixture. Our results demonstrated for the first time that the Cd response in presence of salt can vary in the different clones.Persistent organochlorine chemicals (OCs), including chlordane compounds (CHLs), DDTs, PCBs, and chlorinated dioxins and related compounds (DRCs), were examined in the adipose tissue and liver from 33 specimens of habu (Protobothrops flavoviridis), a species of venomous pit viper endemic to the Japanese Southwest Islands. The median concentrations of CHLs, DDTs, and PCBs in adipose tissue of 22 habus collected from an urban area were 4400 ng g-1 lipid weight (lw), 610 ng g-1 lw, and 1600 ng g-1 lw, respectively. Their DDT and PCB concentrations were higher in comparison with the specimens from a rural area. link3 Liver of 10 specimens from the urban area were subjected to DRCs analysis, and PCDDs, PCDFs, and DL-PCBs were detected with median values of 1300, 350, and 150,000 pg g-1 lw, respectively. Among PCDD/F congeners, octa-CDD was detected at the highest concentrations in seven liver samples, but considerable concentrations of penta- and hexa-CDD/Fs were found in two samples. Relatively higher concentrations of PCB, DDTs, and PCDD/Fs were found in habus collected within 1 km of the boundary of military facilities, suggesting that OCs from some unknown sources of these OCs inside and/or around some of the facilities accumulated in habus.

Autoři článku: Carstensantonsen0354 (Sullivan Bigum)