Sheehanlomholt6086
A conservative approach for restoring deep proximal lesions is to apply an increment of composite resin over the preexisting cervical margin to relocate it coronally, the so-called "deep margin elevation" (DME). A literature search for research articles referring to DME published from January 1998 until November 2021 was conducted using MEDLINE (PubMed), Ovid, Scopus, Cochrane Library and Semantic Scholar databases applying preset inclusion and exclusion criteria. Elevation material and adhesive system employed for luting seem to be significant factors concerning the marginal adaptation of the restoration. This technique does not affect bond strength, fatigue behavior, fracture resistance, failure pattern or repairability. DME and subgingival restorations are compatible with periodontal health, given that they are well-polished and refined. The available literature is limited mainly to in vitro studies. Therefore, randomized clinical trials with extended follow-up periods are necessary to clarify all aspects of the technique and ascertain its validity in clinical practice. For the time being, DME should be applied with caution respecting three criteria capability of field isolation, the perfect seal of the cervical margin provided by the matrix, and no invasion of the connective compartment of biological width.Sinus surgery procedures such as sinus lifting with bone grafting or maxillary functional endoscopy surgery (FESS) can present different complications. The aims of this systematic review are to compile the post-operatory complications of sinus elevation with bone grafting and FESS including voice changes, and to elucidate if those changes are either permanent or temporary. The Preferred Reporting Items for Systematic Reviews and Meta-Analyses (PRISMA) were used, and the literature was exhaustively searched without time restrictions for randomized and non-randomized clinical studies, cohort studies (prospective and retrospective), and clinical case reports with ≥4 cases focused on sinus lift procedures with bone grafts and functional endoscopic maxillary sinus surgery. A total of 435 manuscripts were identified. After reading the abstracts, 101 articles were selected to be read in full. Twenty articles that fulfilled the inclusion criteria were included for analysis. Within the limitations of this systematic review, complications are frequent after sinus lifting with bone grafts and after FEES. Voice parameters are scarcely evaluated after sinus lifting with bone grafts and no voice changes are reported. The voice changes that occur after FESS include a decreased fundamental frequency, increased nasality, and nasalance, all of which are transitory.The aim of this study was to investigate abrasion on human dentin after brushing with activated charcoal toothpastes. A self-designed brushing machine was used to brush five groups (Group A Water, Group B Sensodyne Pro Schmelz, Group C Splat Blackwood, Group D Curaprox Black is White, and Group E Prokudent Black Brilliant) with electrically powered toothbrushes for 4 h. The abrasive dentin wear was calculated using profilometry data. Furthermore, thermogravimetric analyses and scanning electron microscopy were used to analyze the composition of the toothpastes. Mean dentin loss by brushing were (71 ± 28) µm (Splat Blackwood), (44 ± 16) µm (Curaprox Black is White), (38 ± 13) µm (Prokudent Black Brilliant), (28 ± 14) µm (Sensodyne Pro Schmelz), and (28 ± 13) µm (Water). Groups A/B/D/E and group C each lie in one subset, which is statistically different from the other subset according to a post hoc Tukey test (p = 0.05). Within the limitations, it can be concluded that the content of activated charcoal in charcoal toothpastes had little influence on the observed abrasive behavior, although one of the charcoal toothpastes showed the highest abrasion on dentin.The main aim of this cross-sectional study was to examine the prevalence of dental fear among Finnish conscripts. Other aims were to study the association between dental fear and cariological status as well as their self-reported, dentition-related well-being. The study material consisted of 13,564 men and 255 women conscripts who underwent oral examinations. Of those, 8713 responded to a computer-based questionnaire. The mean number of decayed teeth (DT) was used in analyses for cariological status. Self-reported dental fear, dentition-related well-being and regular check-ups were analysed. Data were analysed with cross tables, Pearson Chi-Square tests, Fisher's exact test and binary logistic regressive analysis. High dental fear or finding dental visits very scary was associated with DT > 2 both among women (14.6%, when DT = 0; 33.3%, when DT > 2) and men conscripts (2.3% and 10.8%, respectively). In addition, those reporting that dental health had a negative impact on their well-being and had no regular check-ups were more likely to need cariological treatment than the rest. A high education level, both one's own and parental, was a protective factor for restorative treatment need in male conscripts. The findings of this study support the concept of a vicious cycle of dental fear and dental caries. A preventive, interactive way of work by dental teams would most likely be beneficial for dental health, avoiding the development of dental fear, and dentition-related well-being.
The objective of this study was to determine the most effective treatment option for burning mouth syndrome.
Informative treatment alone, B vitamin injections, oral cavity probiotics, and low-level laser therapy were evaluated and compared. The study included new patients diagnosed with burning mouth syndrome, who were randomly allocated into one of four treatment groups. The primary outcome was improvement in patient's quality of life as determined by a self-perceived Oral Health Impact Profile-14 (OHIP-14) quality of life questionnaire before and after therapy. The secondary outcome was determination of mucosal symptom intensity according to visual analog scale (VAS) grading from 0 to 10. Data were submitted to statistical analysis.
A total of 62 patients completed the study. Oral cavity probiotics and LLLT scores for OHIP-14 resulted in a statistically significant difference before and after therapy. Standardized effect sizes between OHIP scores before and after treatment were the greatest for patients who had received oral cavity probiotics.
Oral cavity probiotics and LLLT were the most effective treatment for improvement in quality of life. Further investigation on a larger group of patients is required.
Oral cavity probiotics and LLLT were the most effective treatment for improvement in quality of life. Further investigation on a larger group of patients is required.
Heat is a kinetic process whereby energy flows from between two systems, hot-to-cold objects. In oro-dental implantology, conductive heat transfer/(or thermal stress) is a complex physical phenomenon to analyze and consider in treatment planning. Hence, ample research has attempted to measure heat-production to avoid over-heating during bone-cutting and drilling for titanium (Ti) implant-site preparation and insertion, thereby preventing/minimizing early (as well as delayed) implant-related complications and failure.
Given the low bone-thermal conductivity whereby heat generated by osteotomies is not effectively dissipated and tends to remain within the surrounding tissue (peri-implant), increasing the possibility of thermal-injury, this work attempts to obtain an exact analytical solution of the heat equation under exponential thermal-stress, modeling transient heat transfer and temperature changes in Ti implants (fixtures) upon hot-liquid
intake.
We, via an ex vivo-based model, investigated the imp, whether for immediate or delayed loading strategies.
This work aspires to accurately complement the overall clinical diagnostic and treatment plan for enhanced bone-implant interface, implant stability, and success rates, whether for immediate or delayed loading strategies.This study aimed to evaluate the water sorption, solubility, and translucency of 3D-printed denture base resins (NextDent, FormLabs, and Asiga), compare them to heat-polymerized acrylic denture base resins, and assess their performance under the effects of thermal cycling. A total of 80 acrylic disc specimens were used in the current study, categorized into four groups (n = 10); in one group, the samples were fabricated conventionally with a heat-polymerizing process (control), while the other three groups were fabricated digitally from different 3D-printed reins (NextDent, FormLabs, and Asiga). Specimens were fabricated according to the manufacturers' recommendations and immersed in distilled water for 48 h at 37 °C. Data on water sorption, solubility, and translucency measurements (T1) were obtained. All the specimens were subjected to 5000 thermal cycles, and then the measures were repeated using the same method (T2). Data analysis was attained via ANOVA and the post hoc Tukey test (α = 0.05). MM-102 chemical structure The type of ss of resin types, thermal cycling adversely affected all tested properties.This study aimed at evaluating volumetrically gaps and voids of calcium-silicate based materials of different generations and handling properties (BC-Endosequence BC RRM-Fast Set Condensable Putty, MTA-ProRoot MTA, and BIO-Biodentine) in simulated furcal perforations in an ex vivo setup by microcomputed tomography (Micro-CT) analysis. Thirty-six extracted human mandibular molars with sound furcation areas were selected. Standardized perforations were created in the furcation area of the pulp chamber using #4 diamond burs. The specimens were randomly assigned to three groups (BC, MTA and BIO; n = 12). Samples were then scanned (SkyScan 1172; Bruker-microCT, Kontich, Belgium), and three-dimensional (3D) images reconstructed. The relative volume of gaps (VG%) and voids (VV%) present on each material was calculated. Data were analyzed using one-way analysis of variance (ANOVA) and Tukey's HSD test (p < 0.05). Mean VG% for BC, MTA, and BIO groups were, respectively, 0.513%, 1.128%, 1.460%, with BC presenting statistically (p < 0.05) fewer gaps formation than the other groups. Mean VV% were, respectively, 0.018%, 0.037%, and 0.065%. The was no statistical difference regarding VV%. There were no gap-free and void-free samples. BC group had the lowest VG% among the groups with a significant statistical difference (p < 0.05).Interpersonal communication skills (ICS) are crucial for effective dental practice and interprofessional collaboration. The current study aimed to assess the attitudes of Greek dental undergraduate students towards team working and their cooperation abilities during the COVID-19 pandemic. One-hundred and twenty-seven fourth-semester dental students (N1 = 127) out of 145 (N0) filled in the online survey placed on Google forms. The "Dental Students Cooperation Questionnaire" (DSC) consisted of 49 questions and was available for completion for one week during April 2020. Bivariate (ANOVA) and linear regression analysis of data revealed that mean scores of the questionnaire increased as the parents' educational level also increased. Data analysis showed that dental students had the required ICS and the intention to collaborate with each other. Many participants managed to achieve group goals, were willing to support other members to fulfill the project's goals, and there was no competition among them. They acknowledged the importance of feedback, the reward at the end of a group project and social media as a tool for teamworking communication.
