Harmonmollerup4720

Z Iurium Wiki

Verze z 2. 10. 2024, 21:50, kterou vytvořil Harmonmollerup4720 (diskuse | příspěvky) (Založena nová stránka s textem „Cd, Pb, As and Ni, Cd, Cr are all positively correlated, and different heavy metals are in space The distribution also reflects the autocorrelation, mainly…“)
(rozdíl) ← Starší verze | zobrazit aktuální verzi (rozdíl) | Novější verze → (rozdíl)

Cd, Pb, As and Ni, Cd, Cr are all positively correlated, and different heavy metals are in space The distribution also reflects the autocorrelation, mainly concentrated in the northeast of the TS mining area and the middle of the PS mining area.

In this article, monomers (tannic acid (TA) and m- phenylenediamine (MPD)) were used in the fabrication of a novel PES based thin-film composite nanofiltration (TFC-NF) membrane for the treatment of a common effluent treatment plant (CETP) of textile industrial wastewater.

PES support sheets and TFC layers were fabricated via non-solvent induced phase inversion and in-situ interfacial polymerization (IP) process. The ultra-thin active layer was synthesized via the IP process with monomers such as tannic acid (TA) and m- phenylenediamine (MPD). T and M series membranes correspond to (PES/x wt% TA, x = 2, 4, 6) as T1, T2, T3 -TA and (PES/x wt% MPD, x = 2, 4, 6) as M1, M2, M3-MPD respectively. M0 corresponds to PES which is the virgin membrane.

The chemical structure, surface morphology, surface roughness and surface properties were explored using fourier transform infrared (FTIR) spectroscopy, field emission scanning electron microscopy (FESEM), atomic force microscopy (AFM) and contact angle, respectivelgnificantly reduced the alkalinity, total hardness, BOD and COD rejections of 78%, 77.3%, 58.5% and 67.5% respectively, present in the effluent. Water flux recovery ratio (FRR) was improved from 74.6% for M0-Virgin PES membrane to 94.8% for T1-TA membrane. The modified TFC-NF membranes especially T1-TA, had better anti-fouling property and excellent hydrophilicity than the unmodified M0-Virgin PES membrane.

The online version contains supplementary material available at 10.1007/s40201-021-00624-x.

The online version contains supplementary material available at 10.1007/s40201-021-00624-x.

This study was designed to evaluate the possible effects of some chelating agents on phytoremediation efficiency and plant growth parameters of

L. and

L. in soils contaminated with lead.

The plant species were grown in pots and treated with lead nitrate and in combination with 2.5, 2.0 and 2.5mmol/kg of EDTA, SA and CA, respectively.

The results showed that the highest accumulations of Pb (mg/kg) with 0.74 and 0.13 were found in the roots and stems of

exposed to 400mg/kg Pb containing EDTA and SA, respectively. Moreover, the highest accumulation of Pb in the roots and stems of

with 0.87 and 1.5mg/kg were observed in 400mg/kg Pb- contaminated soil containing SA.

Although the results obtained showed that

would have a better phytoextraction potential than

, it should be noted that due to the Pb behavior in the soil and/or leaching of Pb from the soil columns during the irrigation period the low amounts of Pb absorption by the root and aerial parts of the plants compared to the added doses of Pb(NO

)

solution to the soil samples, imply the studied plants haven't the adequate potential for phytoextraction of Pb from contaminated soils.

Although the results obtained showed that T. patula would have a better phytoextraction potential than A. caudatus, it should be noted that due to the Pb behavior in the soil and/or leaching of Pb from the soil columns during the irrigation period the low amounts of Pb absorption by the root and aerial parts of the plants compared to the added doses of Pb(NO3)2 solution to the soil samples, imply the studied plants haven't the adequate potential for phytoextraction of Pb from contaminated soils.The functionalized graphene oxide by silica and chitosan helped to prepared an adsorbent with high adsorption potential for removing cadmium(II). In this study, the adsorbent was synthesized and the batch system of adsorption method was examined to find the potential of the new adsorbent with the various factors of the concentration, pH, time and temperature. The characterization of adsorbent was analyzed by FT-IR, TEM, Zeta potential and XRD analysis. Regards to the analysis it can be understood that the adsorbent was synthesized successfully. The investigational results were validated and analyzed by applying the 5 models of isotherm and 4 models of kinetic. The Langmuir, Freundlich, Temkin, Harkins-Jura and Dubinin-radushkevich models were used which the Langmuir, Freundlich and Temkin fitted well for removing cadmium(II). The Qmax value was achieved 126.58 mg/g by using the Langmuir model for removing Cd(II) respectively. The pseudo-first-order, pseudo-second-order, Elovich and Intra-particle models were used to validate the kinetic models of the process. The pseudo-second-order and Elovich models were the best fitted kinetic model in this investigation. Thermodynamic parameters of the energy of gibes, the enthalpy, and the entropy were calculated. Generally, the adsorption process was distinguished as an exothermic and spontaneous.Cigarette butt is known as hazardous waste with numerous toxic and carcinogenic pollutants which impose serious concern for both the environment and human. Heavy metals are recognized as the most common pollutant in the cigarette butts. The concentration of some heavy metals (cadmium, chromium, nickel, lead and zinc) in leachate obtained from the pilot landfill with commingled waste and freshly smoked cigarettes butts were analyzed. The results showed that the addition of 0.76% (in weight) freshly smoked cigarette butts in landfilled waste increased total heavy metal concentration by 4.8%, while addition of 1.3% (in weight) freshly smoked cigarette butts leads to increased 3.72% of total heavy metals concentrations. An increased 10.52% and 3.43% health risk values were found from the leachate of the landfill pilot, where 1% freshly smoked cigarette butt and a littered cigarette were added, respectively. Overall, it can be concluded that cigarette butt landfilling is not recommended for management of this type of waste and is necessary to be replaced with less hazardous ways such as recycling.The resistance of hospital bacterial isolates against traditional germicides, which used frequently, is one of the important factors contributing to emerging nosocomial infections. Moreover, due to having the side effects of chemical substances, the development of novel low-risk natural compounds seems necessary for control the spread of resistant pathogens in hospital environments. The aim of this study was to compare the effect of carvacrol and glutaraldehyde against two common hospital acquired pathogens, including Pseudomonas aeruginosa and Staphylococcus aureus. In this study 365 samples were collected from different wards of hospitals of Khorramabad, Iran. One hundred and sixty samples were identified as P. aeruginosa and S. aureus by using standard microbiological methods. Then the antibacterial effects of four combinations including carvacrol+ethanol, carvacrol+dimethyl sulfoxide (DMSO), glutaraldehyde 2%, and pure glutaraldehyde (50%) were evaluated and determined using dilution broth and disk diffusion methods. Our results showed that the carvacrol had more antibacterial effects against selected bacteria compared to glutaraldehyde. Moreover, the optimal time and concentration of carvacrol+ethanol against hospital isolates of P. aeruginosa and S. aureus was determined after 1 h at concentration of 64 μl/ml and 8 μl/ml, respectively. In conclusion by comparing the results of carvacrol and glutaraldehyde, seem that carvacrol, as an herbal and natural agent, may be a suitable alternative to glutaraldehyde in hospital equipment's' sterilization.The aim of current study was to evaluate the acrylamide level in chicken, meat and shrimp nugget samples cooked in both traditional and industrial methods using "Quick, Easy, Cheap, Effective, Rugged, and Safe" QuEChERS extraction and gas chromatography-flame-ionization detection (GC-FID). Results revealed the traditional frying method has significant effect on the increase of acrylamide compared to industrial frying method and it was also found that the different cooking temperatures and time have significant effect on increase of acrylamide formation (p  1E-4) for Iranian population.

Ballast water is one of the most important ways for the transfer of aquatic organisms such as

(

) and

. The aim of this study was to investigate

gene of

and the

gene of

bacteria by PCR technique in the ballast water of commercial ships entering Bushehr port along the Persian Gulf.

In this study, 34 samples of ballast water entered Bushehr port were studied by using culture and PCR methods to determine

gene of

and

gene of

. Genomic DNA of bacterial strains was extracted and PCR was performed by using specific primers of

and

.

The specific

gene of

was detected in 4 ballast water samples and the positive samples were analyzed by antisera methods for E. coli O157H7. Results of antisera showed that there were 3 positive samples of O157H7 serotype. The results of the PCR technique showed that the

gene of

was negative for all positive culture samples.

Further studies are highly recommended to monitor other aquatic organisms in ballast water to protect the marine environment.

Further studies are highly recommended to monitor other aquatic organisms in ballast water to protect the marine environment.A biosurfactant producing strain was isolated and the rhamnolipid type biosurfactant was extracted for soil washing of a synthetically and naturally hydrocarbon-contaminated soil. Following the primary screening, Pseudomonas aeruginosa strain R 4 was selected and the effect of the carbon and nitrogen source and the salinity on biosurfactant production was studied. Of the best results were observed for glucose as a carbon source, NH4Cl as a nitrogen source and salinity of 1.4%. The produced biosurfactant was a glycolipid type biosurfactant and reduced the surface tension to 32.5 mN/m with a critical micelle concentration (CMC) of 50 mg/L and production yield of 90 mg/L. Using produced biosurfactant, a pyrene desorption rate of 82% was observed in selected conditions for initial pyrene concentration of 200 mg/L.Algae are known with many detrimental impacts on drinking water quality. Discharge of municipal and agricultural wastewater into the receiving water resources make desirable conditions for algae growth and consequently cause eutrophication phenomena. Water samples were withdrawn monthly from 5 stations in Zabol City within spring and summer seasons. To identify algae species, micronutrients, and physical parameters such as temperature, depth of Secchi disk (SD) and pH on their growth were evaluated. The average phosphate in spring and summer were observed to be 0.034 and 0.028 mg/L, respectively. The results obtained from the present study indicated that the volume and depth of the water reservoirs were less critical on total phosphorus compared with the concentration of algal cells and total nitrogen. The mean pH for water samples taken from Chah Niemeh (CN) in spring and summer were observed to be 8.4 which is suitable for algae growth. Furthermore, the mean temperature (>20 °C) in both seasons were found to be desirable for the growth of algae, especially cyanobacteria in the CN. Moreover, the mean SD in spring and summer samples was 96.16 m and 119.83 m, respectively. As a result, the reservoir had low transparency in terms of algal growth. D-1553 cell line Totally, most of the identified algae were green algae (50%), algal flagella (19%), cyanobacteria (15.4%) and diatoms (15%). Therefore, cyanobacteria are most possible responsible for the taste and odor in the CN water reservoir. Future efforts should be directed toward preventive measurements for protecting water reservoirs from municipal and agricultural wastewaters and algae control.

Autoři článku: Harmonmollerup4720 (Shelton Sherwood)