Ralstonnielsen3642

Various innovations were reported in the field and vibriocins can now be produced on large scales using whole-cell culture. Vibriocins were structurally diverse, large molecular weight, and relatively heat stable. These vibriocins mainly inhibited the cell wall but could have other novel mechanisms. These properties could affect the extraction process as well as applications in aquaculture, hence, should be considered in future research.The influence of temperature, pollutant, and pH on the local corrosion rate of insulators installed in industrial, marine, and rural installation sites is investigated based on experimental and statistical investigations. Cefodizime The tensile load test confirms that corroded insulator specimens collected from industrial sites aged more than 10 years represent a minimum fracture load, 19,892 lbs. It was further observed that more than 91.24% and 64.62% corroded insulator specimens suffered from shell break and pin detachment, respectively. The microstructural and XRF analysis reveal that insulator specimens collected from industrial sites (age > 10 years), represented the highest wt% of O (19.2) and lowest wt% of Zn (0.34) among industrial, marine, and rural installation sites. The 3D stationery mechanical simulation reveals that insulator specimens aged > 10 years experienced maximum stress (600 MPa) in the pin-cement interface. Using full two-level factorial designs, temperature, concentration of pollutants, and pH were found significant factors for corrosion rate. The immersion test results further confirm the above-mentioned factors significant for the dissolution behavior of galvanized coating of insulator pin. Following immersion test results, the industrial region shows the highest corrosion rate (5.58-12 µm/year) among all installation sites.Comparing the economic efficiency of alternative strategies for breeding requires to compare the genetic gain obtained with breeding schemes that represent the same total investment. In this chapter, we present a generic method to assess this economic efficiency for alternative breeding schemes. After presenting the baseline framework and the necessity of comparing breeding schemes with equivalent total investment, we propose one illustrative example on wheat breeding. In this application, we compare the use of conventional breeding and genomic selection. With this example, we explain the requirements and the different steps to implement this method. At last, we discuss several extensions of the baseline model.Genomic prediction can be a powerful tool to achieve greater rates of genetic gain for quantitative traits if thoroughly integrated into a breeding strategy. In rice as in other crops, the interest in genomic prediction is very strong with a number of studies addressing multiple aspects of its use, ranging from the more conceptual to the more practical. In this chapter, we review the literature on rice (Oryza sativa) and summarize important considerations for the integration of genomic prediction in breeding programs. The irrigated breeding program at the International Rice Research Institute is used as a concrete example on which we provide data and R scripts to reproduce the analysis but also to highlight practical challenges regarding the use of predictions. The adage "To someone with a hammer, everything looks like a nail" describes a common psychological pitfall that sometimes plagues the integration and application of new technologies to a discipline. We have designed this chapter to help rice breeders avoid that pitfall and appreciate the benefits and limitations of applying genomic prediction, as it is not always the best approach nor the first step to increasing the rate of genetic gain in every context.For many plant and animal species, commercial products are hybrids between individuals from different genetic groups. For allogamous plant species such as maize, the breeding objective is to produce single-cross hybrid varieties from two inbred lines each selected in complementary groups. Efficient hybrid breeding requires methods that (1) quickly generate homozygous and homogeneous parental lines with high combining abilities, (2) efficiently choose among the large number of available parental lines the most promising ones, and (3) predict the performances of sets of non-phenotyped single-cross hybrids, or hybrids phenotyped in a limited number of environments, based on their relationship with another set of hybrids with known performances. The maize breeding community has been developing model-based prediction of hybrid performances well before the genomic era. This chapter (1) provides a reminder of the maize breeding scheme before the genomic era; (2) describes how genomic data were incorporated in the prediction models involved in different steps of genomic-based single-cross maize hybrid breeding; and (3) reviews factors affecting the accuracy of genomic prediction, approaches for optimizing GP-based single-cross maize hybrid breeding schemes, and ensuring the long-term sustainability of genomic selection.The majority of forage grass species are obligate outbreeders. Their breeding classically consists of an initial selection on spaced plants for highly heritable traits such as disease resistances and heading date, followed by familial selection on swards for forage yield and quality traits. The high level of diversity and heterozygosity, and associated decay of linkage disequilibrium (LD) over very short genomic distances, has hampered the implementation of genomic selection (GS) in these species. However, next generation sequencing technologies in combination with the development of genomic resources have recently facilitated implementation of GS in forage grass species such as perennial ryegrass (Lolium perenne L.), switchgrass (Panicum virgatum L.), and timothy (Phleum pratense L.). Experimental work and simulations have shown that GS can increase significantly the genetic gain per unit of time for traits with different levels of heritability. The main reasons are (1) the possibility to select single plant counterbalance the high selection intensity that can be achieved in GS.This chapter provides an overview of the genomic selection progress in long-lived forest tree species. Factors affecting the prediction accuracy in genomic prediction are assessed with examples from empirical studies. Infrastructure and resources required for the implementation of genomic selection are evaluated. Some general guidelines are provided for the successful application of genomic selection in forest tree breeding programs.To date, genomic prediction has been conducted in about 20 aquaculture species, with a preference for intra-family genomic selection (GS). For every trait under GS, the increase in accuracy obtained by genomic estimated breeding values instead of classical pedigree-based estimation of breeding values is very important in aquaculture species ranging from 15% to 89% for growth traits, and from 0% to 567% for disease resistance. Although the implementation of GS in aquaculture is of little additional investment in breeding programs already implementing sib testing on pedigree, the deployment of GS remains sparse, but could be boosted by adaptation of cost-effective imputation from low-density panels. Moreover, GS could help to anticipate the effect of climate change by improving sustainability-related traits such as production yield (e.g., carcass or fillet yields), feed efficiency or disease resistance, and by improving resistance to environmental variation (tolerance to temperature or salinity variation). This chapter synthesized the literature in applications of GS in finfish, crustaceans and molluscs aquaculture in the present and future breeding programs.In accordance with the infinitesimal model for quantitative traits, a very large number of genes affect nearly all economic traits. In only two cases has the causative polymorphism been determined for genes affecting economic traits in dairy cattle. Most current methods for genomic evaluation are based on the "two-step" method. Genetic evaluations are computed by the individual animal model, and functions of the evaluations of progeny-tested sires are the dependent variable for estimation of marker effects. With the adoption of genomic evaluation in 2008, annual rates of genetic gain in the US increased from ∼50-100% for yield traits and from threefold to fourfold for lowly heritable traits, including female fertility, herd-life and somatic cell concentration. Gradual elimination of the progeny test scheme has led to a reduction in the number of sires with daughter records and less genetic ties between years. As genotyping costs decrease, the number of cows genotyped will continue to increase, and these records will become the basic data used to compute genomic evaluations, most likely via application of "single-step" methodologies. Less emphasis in selection goals will be placed on milk production traits, and more on health, reproduction, and efficiency traits and "environmentally friendly" production. Genetic variance for economic traits is maintained by increase in frequency of rare alleles, new mutations, and changes in selection goals and management.Decoding the genome confers the capability to predict characteristics of the organism (phenotype) from DNA (genotype). We describe the present status and future prospects of genomic prediction of complex traits in humans. Some highly heritable complex phenotypes such as height and other quantitative traits can already be predicted with reasonable accuracy from DNA alone. For many diseases, including important common conditions such as coronary artery disease, breast cancer, type I and II diabetes, individuals with outlier polygenic scores (e.g., top few percent) have been shown to have 5 or even 10 times higher risk than average. Several psychiatric conditions such as schizophrenia and autism also fall into this category. We discuss related topics such as the genetic architecture of complex traits, sibling validation of polygenic scores, and applications to adult health, in vitro fertilization (embryo selection), and genetic engineering.Recently, it has been proposed to switch molecular markers to near-infrared (NIR) spectra for inferring relationships between individuals and further performing phenomic selection (PS), analogous to genomic selection (GS). The PS concept is similar to genomic-like omics-based (GLOB) selection, in which molecular markers are replaced by endophenotypes, such as metabolites or transcript levels, except that the phenomic information obtained for instance by near-infrared spectroscopy (NIRS ) has usually a much lower cost than other omics. Though NIRS has been routinely used in breeding for several decades, especially to deal with end-product quality traits, its use to predict other traits of interest and further make selections is new. Since the seminal paper on PS , several publications have advocated the use of spectral acquisition (including NIRS and hyperspectral imaging) in plant breeding towards PS , potentially providing a scope of what is possible. In the present chapter, we first come back to the concept of PS as originally proposed and provide a classification of selected papers related to the use of phenomics in breeding. We further provide a review of the selected literature concerning the type of technology used, the preprocessing of the spectra, and the statistical modeling to make predictions. We discuss the factors that likely affect the efficiency of PS and compare it to GS in terms of predictive ability. Finally, we propose several prospects for future work and application of PS in the context of plant breeding.