Skaftemerritt0585

Anaerobic ammonia oxidation (anammox) is a well-developed biotechnology for treating high-strength ammonium wastewaters. Recently, partial denitrification has been considered as an alternative to supply anammox with the required nitrite. In this study, a process of sulfide-driven partial denitrification and anammox (SPDA) was developed and operated continuously in an upflow anaerobic sludge blanket (UASB) reactor for 392 days. This reactor was fed with synthetic wastewater containing 100 mgN/L nitrate, 80 mgN/L ammonium and 20-80 mgS/L sulfide. After 160 days of operation, the reactor reached stable performance, and the nitrogen removal efficiency and rate were maintained at 80% and 0.29 kgN/(m³•d), respectively. The estimated nitrogen removal via anammox and sulfide-driven denitrification were 87.2% and 12.8%. PEG400 in vivo Additional batch experiments were conducted to investigate the effects of sulfide on anammox and the mechanisms of nitrogen removal in the SPDA system. The following results were obtained (1) sulfide had an inhibitory effect on the specific anammox activity with IC50 of 9.7 mgS-H2S/L. (2) The rapid oxidation of sulfide by sulfur-oxidizing bacteria (SOB) could relieve the toxic effects of sulfide on the anammox in the SPDA system. (3) Sulfide bio-oxidation was a two-step reaction with biologically produced elemental sulfur (BPS0) as the intermediate, and the second step using BPS0 as the electron donor, can efficiently produce nitrite via partial denitrification (NO3- → NO2-) as a supply for anammox. Finally, a high-throughput sequencing analysis identified Thiobacillus and Sulfurimonas as the dominant genera of SOB in the SPDA system, and Candidatus Kuenenia as the dominant anammox bacteria. Overall, this research gives the foundation for the practical application of sulfide-driven partial denitrification and anammox process in the future.Oxidation ditches (ODs) are often used for wastewater treatment. However, limitations of ODs like high energy expenditure and increased sludge sedimentation hinder its wide application. In this study, the computational fluid dynamics (CFD) model integrated with Activated Sludge Model No. 2 (ASM2) was proposed and applied in a full-scale OD. The integrated model provided heterogeneous information on the characteristics of hydrodynamics and biokinetics of OD, especially with respect to the simulation of total phosphorus removal by CFD-ASM2 integration model for the first time. The simulated values of flow velocities, suspended solids (SS), dissolved oxygen, chemical oxygen demand, total nitrogen, ammonium nitrogen, and total phosphorus concentrations were well validated with the measured results, with the standard deviation errors of less than 5.56%, 0.28%, 0.74%, 7.39%, 3.17%, 5.27%, and 7.40%, respectively. Based on the integrated model, four different operational strategies were simulated. The proposed operational strategy of operating 7 surface aerators and 10 submerged impellers not only met the standard discharge requirements (GB 18918-2002) but also consumed less energy by 22.3%, compared with the original strategy of operating 9 surface aerators and 13 submerged impellers. Meanwhile, this proposed operational strategy also reduced the SS concentrations in the second and fourth channels, which was beneficial to elimination of sludge sedimentation. Moreover, the proposed operational strategy was successfully applied and validated in full-scale OD. The foregoing results collectively suggest that the CFD-AMS2 integration model is numerically capable to optimize the operational strategy of ODs.Anammox biotechnology has been widely applied for its attractive advantages, but its application has been seriously limited due to the instinctive drawback of nitrate production. In this work, a novel Sequential Anammox and Denitrification (SAD) system was developed for the advanced nitrogen removal by using solid carbon source (SCS) and coupling anammox with denitrification. The long-term operation results demonstrated that the SAD system could remove the total nitrogen (TN) efficiently, with the effluent TN concentration of 1.4 ± 0.5 mg N/L, the TN removal efficiency (NRE) of 99.3 ± 0.2%, and the TN removal rate (NRR) of 1.7 ± 0.1 kg/(m3·d). The determination results showed that SCS had a good property for sustained release of COD, with a dissolved organic yield (by COD) of 1.1 g-COD/g-rice. When the addition rate was set at 6 g-rice/7-days, the COD release rate of 0.9 kg-COD/(m3·d) from SCS matched the nitrate production rate of 1.2 × 10-1 kg-N/(m3·d) from anammox with consumption ratio of 7.5. The analysis on the microbial community revealed that Candidatus_Brocadia and Denitratisoma were the dominant functional bacteria for anammox and denitrification, which contributed to about 92.7% and 6.6% of the total nitrogen removal, respectively. This work is helpful for the innovation and application of anammox-based technology.Though germicidal UV radiation is widely applied for disinfection of water and food, it may also be used to prevent bacterial growth and colonization on surfaces within engineered systems. Emerging UV source technologies, such as ultraviolet-C (UVC) LEDs, present new opportunities for deterring biofilms within certain devices, including medical equipment, food equipment, and potentially in plumbing fixtures for prevention of opportunistic respiratory pathogen infections. Rational design for incorporation of UVC sources into devices with complex internal geometries is currently hampered by the lack of an engineering framework for predicting reductions in biofilm growth rates in response to continuous low-intensity irradiation. Herein we have developed an experimental apparatus and method for growing biofilms under concurrent UV irradiation and quantifying the resulting suppression of surface growth. Under accelerated growth conditions over 48 h, E. coli surface biovolume was reduced by 95% compared to control biofilms (grown in the dark) by a UV intensity of 50.5 µW/cm2 (254 nm). The required intensity for biofilm prevention was higher than expected, given the UV dose response of the bacteria employed and the cumulative doses delivered to the test surfaces. The results indicate that biofilms can establish even under irradiation conditions that would result in complete inactivation of planktonic cells, likely due to the shielding effects of colloidal material and microbial exudates. A pseudo-mechanistic model was also developed which correlated UV intensity to the resultant reduction in specific surface biovolume.