Zobrazení zdroje stránky Westermannlang6631

The Drosophila LMM segment used, V1346-I1941, encompassing conserved skip residues 2-4, is found to possess a traditional helical profile but is interpreted as having less then 30% helical content by multiple methods of deconvolution. This low helicity may be affiliated with the dynamic behavior of the structure in solution or the inclusion of a known non-helical region in the C-terminus. Our results support the hypothesis that WYR binds the LMM and that this interaction brings about structural changes in the coiled-coil. These studies implicate flightin, via the WYR domain, for distinct shifts in LMM secondary structure that could influence the structural properties and stabilization of the thick filament, scaling to modulation of whole muscle function.In this study, a novel technology is reported to prepare a piezoresistive polyurethane-silicone rubber nanocomposite. Polyurethane (PU) foam was loaded with a nitrogen-doped bamboo-shaped carbon nanotube (N-BCNT) by using dip-coating, and then, impregnated with silicone rubber. PU was used as a supporting substrate for N-BCNT, while silicone rubber was applied to fill the pores of the foam to improve recoverability, compressive strength, and durability. The composite displays good electrical conductivity, short response time, and excellent repeatability. The resistance was reduced when the amount of N-BCNT (0.43 wt %) was increased due to the expanded conductive path for electron transport. The piezoresistive composite has been successfully tested in many applications, such as human monitoring and finger touch detection.In this paper, we used an octadecylamine functionalized graphene oxide (ODA@GO) to induce the confined growth of a polyamide nanofilm in the organic and aqueous phase during interfacial polymerization (IP). The ODA@GO, fully dispersed in the organic phase, was applied as a physical barrier to confine the amine diffusion and therefore limiting the IP reaction close to the interface. The morphology and crosslinking degree of the PA nanofilm could be controlled by doping different amounts of ODA@GO (therefore adjusting the diffusion resistance). At standard seawater desalination conditions (32,000 ppm NaCl, ~55 bar), the flux of the resultant thin film nanocomposite (TFN) membrane reached 59.6 L m-2 h-1, which was approximately 17% more than the virgin TFC membrane. Meanwhile, the optimal salt rejection at seawater conditions (i.e., 32,000 ppm NaCl) achieved 99.6%. Concurrently, the boron rejection rate was also elevated by 13.3% compared with the TFC membrane without confined growth.Polyether-pentols (PEPOs) were synthesized from glycidyl ethers and butylene oxide with the application of tripotassium salts of 2,2,6,6-tetrakis(hydroxymethyl)cyclohexanol (HMCH) activated 18C6 for ring-opening polymerization (ROP). The construction of the applied initiator system reflects the ability of crown ether to influence the degree of ion-pair separation with an increased activating effect. [https://www.selleckchem.com/products/ms-275.html Entinostat] As a result formation of bi- or trimodal polymers was observed with molar masses in the range of (Mn = 1200-6000). The observed multi-fraction composition is prescribed to the formation of ionic aggregates with different reactivities during polymerization. The mechanism of the studied processes is discussed. The obtained PEPOs served for a crosslinked PUR synthesis, for which the hydrogen bond index for coupling of hard segments was calculated. Additionally, the range of phase separation was calculated that was higher for PUR-containing aromatic rings as the substituent.Diabetes mellitus is a highly challenging global health care problem. This study aimed to assess the effect of glycated hemoglobin (HbA1c) and duration of diabetes on lung function in type 2 diabetic patients and assess whether duration or high HbA1c is more noxious to damage the lung functions. A total of 202 participants, 101 patients with type 2 diabetes mellitus (T2DM), and 101 age-, gender-, height-, and weight-matched controlled subjects were recruited. The HbA1c was measured through a clover analyzer, and lung function test parameters were recorded by spirometry. The results revealed a significant inverse correlation between HbA1c and Vital Capacity (VC) (r = -0.221, p = 0.026), Forced Vital Capacity (FVC) (r = -0.261, p = 0.008), Forced Expiratory Volume in First Second (FEV1) (r = -0.272, p = 0.006), Forced Expiratory Flow 25% (FEF-25%) (r = -0.196, p = 0.050), Forced Expiratory Flow 50% (FEF-50%) (r = -0.223, p = 0.025), and Forced Expiratory Flow 75% (FEF-75%) (r = -0.169, p = 0.016). Moreover, FEV1 (p = 0.029), FEV1/FVC% (p = 0.006), FEF-50% (p = 0.001), and FEF-75% (p = 0.003) were significantly lower in the diabetic group with duration of disease 5-10 and &gt;10 years compared to the control group. The overall results concluded that high HbA1c or uncontrolled diabetes mellitus has a more damaging effect on lung function impairment compared to the duration of diabetes mellitus. Physicians must regularly monitor the HbA1c level while treating diabetic patients, as good glycemic control is essential to minimize the complications of DM, including lung function impairment in patients with T2DM.Three novel gold(III) complexes (1-3) of general composition [Au(Bipydc)(S2CNR2)]Cl2 (Bipydc = 2,2'-bipyridine-3,3'-dicarboxylic acid and R = methyl for dimethyldithiocarbamate (DMDTC), ethyl for diethyldithiocarbamate (DEDTC), and benzyl for dibenzyldithiocarbamate (DBDTC)) have been synthesized and characterized by elemental analysis, FTIR and NMR spectroscopic techniques. The spectral results confirmed the presence of both the Bipydc and dithiocarbamate ligands in the complexes. The in vitro cytotoxic studies demonstrated that compounds 1-3 were highly cytotoxic to A549, HeLa, MDA-231, and MCF-7 cancer cells with activities much higher (about 25-fold) than cisplatin. In order to know the possible mode of cell death complex 2, [Au(Bipydc)(DEDTC)]Cl2 was further tested for induction of apoptosis towards the MCF-7 cells. The results indicated that complex 2 induces cell death through apoptosis.Electrodes are basic components of C4D (capacitively coupled contactless conductivity detection) sensors, and different electrode structures (the configuration pattern or the electrode geometry) can lead to different measurement results. In this work, the effects of electrode geometry of radial configuration on the measurement performance of C4D sensors are investigated. Two geometrical parameters, the electrode length and the electrode angle, are considered. A FEM (finite element method) model based on the C4D method is developed. With the FEM model, corresponding simulation results of conductivity measurement with different electrode geometry are obtained. Meanwhile, practical experiments of conductivity measurement are also conducted. According to the simulation results and experimental results, the optimal electrode geometry of the C4D sensor with radial configuration is discussed and proposed. The recommended electrode length is 5-10 times of the pipe inner diameter and the recommended electrode angle is 120-160°.