Zobrazení zdroje stránky Hviidhinson9672

Biomaterial-associated infections are a major cause of biomaterial implant failure. To prevent the initial attachment of bacteria to the implant surface, researchers have investigated various surface modification methods. However, most of these approaches also prevent the attachment, spread, and growth of mammalian cells, resulting in tissue integration failure. Therefore, the success of biomaterial implants requires an optimal balance between tissue integration (cell adhesion to biomaterial implants) and inhibition of bacterial colonization. In this regard, we synthesize bifunctional nanomaterials by functionalizing the pores and outer surfaces of periodic mesoporous organosilica (PMO) with antibacterial tetracycline (Tet) and antibacterial and cell-adhesive bipolymer poly-d-lysine (PDL), respectively. Then, the fabricated TetPMO-PDL nanomaterials are incorporated into alginate-based hydrogels to create injectable and 3D-printable nanocomposite (NC) hydrogels (AlgL-TetPMO-PDL). These bifunctional nanomaterial and 3D-printable NC hydrogel show pH-dependent release of Tet over 7 days. They also enhance the proliferation of eukaryotic cells (fibroblasts). TetPMO-PDL is inactive in reducing Pseudomonas aeruginosa, Staphylococcus aureus, and Enterococcus faecalis biofilms. However, AlgL-TetPMO-PDL shows significant antibiofilm activity against P. aeruginosa. These results suggest that the incorporation of TetPMO-PDL into AlgL may have a synergistic effect on the inhibition of the Gram-negative bacterial (P. aeruginosa) biofilm, while this has no effect on the reduction of the Gram-positive bacterial (S. aureus and E. faecalis) biofilm.We report the first successful combination of three distinct high-throughput techniques to deliver the accelerated design, synthesis, and property screening of a library of novel, bio-instructive, polymeric, comb-graft surfactants. These three-dimensional, surface-active materials were successfully used to control the surface properties of particles by forming a unimolecular deep layer on the surface of the particles via microfluidic processing. This strategy deliberately utilizes the surfactant to both create the stable particles and deliver a desired cell-instructive behavior. Therefore, these specifically designed, highly functional surfactants are critical to promoting a desired cell response. This library contained surfactants constructed from 20 molecularly distinct (meth)acrylic monomers, which had been pre-identified by HT screening to exhibit specific, varied, and desirable bacterial biofilm inhibitory responses. The surfactant's self-assembly properties in water were assessed by developing a novel, fully automated, HT method to determine the critical aggregation concentration. These values were used as the input data to a computational-based evaluation of the key molecular descriptors that dictated aggregation behavior. Thus, this combination of HT techniques facilitated the rapid design, generation, and evaluation of further novel, highly functional, cell-instructive surfaces by application of designed surfactants possessing complex molecular architectures.Interfacial anodic degradation in graphitic materials under fast charging conditions causes severe performance loss and safety hazard in lithium ion batteries. We present a novel method for minimizing the growth of these aging mechanism by application of an external magnetic field. Under magnetic field, paramagnetic lithium ions experience a magnetohydrodynamic force, which rotates the perpendicularly diffusing species and homogenizes the ionic transport. This phenomenon minimizes the overpotential hotspots at the anode/separator interface, consequently reducing SEI growth, lithium plating, and interfacial fracture. In situ electrochemical measurements indicate an improvement in capacity for lithium cobalt oxide/graphite pouch cell (20 mAh) charged from 1-5 C under an applied field of 1.8 kG, with a maximum capacity gain of 22% at 5C. Post-mortem FE-SEM and EDS mapping shows that samples charged with magnetic field have a reduced lithium deposition at 3C and a complete suppression of interfacial fracture at 5C. At 5C, a 24% reduction in the lithium content is observed by performing XPS on the anodic interfacial film. Finally, fast charging performance under variable magnetic field strengths indicate a saturation behavior in capacity at high fields (&gt;2 kG), thereby limiting the field and consequent energy requirements to obtain maximum capacity gain under extreme conditions.Due to their low-temperature deposition, high mobility (&gt;10 cm2/V·s), and electrical conductivity, amorphous ionic oxide semiconductors (AIOSs) have received much attention for their applications in flexible and/or organic electro-optical devices. Here, we report on a study of the flexibility of CdO-In2O3 alloy thin films, deposited on a polyethylene terephthalate (PET) substrate by radio frequency magnetron sputtering at room temperature. Cd1-xInxO1+δ alloys with the composition of x &gt; 0.6 are amorphous, exhibiting a high electron mobility of 40-50 cm2/V·s, a low resistivity of ∼3 × 10-4 Ω·cm, and high transmittance over a wide spectral window of 350 to &gt;1600 nm. The flexibility of both crystalline and amorphous Cd1-xInxO1+δ films on the PET substrate was investigated by measuring their electrical resistivity after both compressive and tensile bending with a range of bending radii and repeated bending cycles. Under both compressive and tensile bending with Rb = 16.5 mm, no significant degradation was observed for both the crystalline and amorphous films up to 300 bending cycles. For a smaller bending radius, the amorphous film shows much less electrical degradation than the crystalline films under compressive bending due to less film delamination at the bending sites. On the other hand, for a small bending radius (90%. [https://www.selleckchem.com/products/e6446.html E6446 datasheet] The OSCs fabricated on an amorphous Cd1-xInxO1+δ-coated flexible PET substrate achieve a promising PCE of 12.06%. Our results strongly suggest the technological potentials of amorphous Cd1-xInxO1+δ as a reliable and effective transparent conducting material for flexible and organic optoelectronic devices.Bacterial biofilms are a major health concern, mainly due to their contribution to increased bacterial resistance to well-known antibiotics. The conventional treatment of biofilms represents a challenge, and frequently, eradication is not achieved with long-lasting administration of antibiotics. In this context, the present work proposes an innovative therapeutic approach that is focused on the encapsulation of N-acetyl-l-cysteine (NAC) into lipid nanoparticles (LNPs) functionalized with d-amino acids to target and disrupt bacterial biofilms. The optimized formulations presented a mean hydrodynamic diameter around 200 nm, a low polydispersity index, and a high loading capacity. These formulations were stable under storage conditions up to 6 months. In vitro biocompatibility studies showed a low cytotoxicity effect in fibroblasts and a low hemolytic activity in human red blood cells. Nevertheless, unloaded LNPs showed a higher hemolytic potential than NAC-loaded LNPs, which suggests a safer profile of the lattpotential therapeutic approach against P. aeruginosa biofilms, alone or in combination with antibiotics.Lead-free perovskite solar cells (PSCs) have attracted interest among scientists searching for eco-friendly energy harvesting devices. Herein, the effects of ozone exposure on poly(3,4-ethylenedioxythiophene) polystyrene sulfonate (PEDOTPSS) in lead-free tin halide PSCs as a facile and low-cost process for improving device performance are analyzed. Two types of tin-based PSCs and one typical lead-based PSC were fabricated. The ozone exposure on PEDOTPSS increases the short-circuit current density (JSC) and the fill factor (FF) of PSCs in all cases with perovskite grain enlargement and hole-mobility enhancement of the devices, respectively. For open-circuit voltage (VOC), the outcome depends on the band gap and the energy levels of the perovskite films. While ozone exposure treatment is favorable for PEA0.15FA0.85SnI3-based tin PSCs, VOC decreases with ozone exposure in the case of GeEDA0.01FA0.98SnI3-based tin PSCs because of a misalignment of the energy levels. Regardless, the efficiency of PEA0.15FA0.85SnI3-based tin PSCs increases from 8.7 to 10.1% when measured inside a glovebox upon ozone exposure of PEDOTPSS. The efficiency of GeEDA0.01FA0.98SnI3-based tin PSCs increases from 6.8 to 8.1%, and the devices retain an efficiency of 5.0% even after 50 days in air.The COVID-19 pandemic began with uncertainty in how to care for patients and protect staff. The American Nephrology Nurses Association (ANNA) immediately recognized the need to provide its members and others in the nephrology community with as much information as possible. Resources were collected and disseminated in many forms (e.g., publications, webinars, virtual conference sessions). As COVID-19 surges began occurring across the country and staffing reached a crisis level, ANNA collaborated with other organizations to find potential solutions. One solution developed by ANNA was the ANNA COVID-19 Surge Support Process and Map - a process to connect the areas in high need with skilled and available staff. This article describes the ANNA COVID-19 Surge Support Process and Map, which has continued to help address COVID-19 staffing challenges.Seminal demonstration of the possibility of stable genetic modification of mammalian cells performed by Wacław and Elisabeth Szybalski opened the doors for gene therapy, the term coined by Wacław Szybalski already in 1962. In the next 60 years, numerous tools for gene delivery have been developed and applied for clinical research, culminating in the registration of several genetic therapies in Europe and the USA. Some of these strategies, aimed to treat severe combined immunodeficiencies, inherited forms of blindness, spinal muscular atrophy, some cancers, and genetic anemias, are the real hope for patients suffering from previously incurable diseases or the ones whose treatment was not effective. On the approaching 60th anniversary of gene therapy, combined with the 100th anniversary of the birth of Professor Wacław Szybalski (September 9th, 1921), who passed away on December 16, 2020, here I present the summary of the most important aspects of clinical applications of genetic therapies.<br /><br /> This study aims to elucidate the health care organization, management and policy barriers and facilitators associated with implementation of an evidence-based health promotion intervention in primary care centers in the Basque Country, Spain.<br /><br /> Seven focus groups were conducted with 49 health professionals from six primary care centers participating in the Prescribing Healthy Life program. Text was analyzed using the Consolidated Framework for Implementation Research (CFIR) focusing on those constructs related to health care organization, management and policy.<br /><br /> The health promotion intervention was found to be compatible with the values of primary care professionals. However, professionals at all centers reported barriers to implementation related to (1) external policy and incentives, (2) compatibility with existing workflow and (3) available resources to carry out the program. Specific barriers in these areas related to lack of financial and political support, consultation time constraints and difficulty managing competing day-to-day demands.