Zobrazení zdroje stránky Hermannhejlesen4514

Mixed media-2 removed Zn significantly with a removal efficiency higher than 99% due to the sorption capacity of iron filings and both mixed media-2 and 3 showed efficient removal of Ni (~ 94%) in effluent. Layered media was found to be most efficient in Cd removal (~ 99%). All mixture of materials showed more than 99% removal of total phosphorus and Pb. The sorption efficiency of the different mixtures showed that a combination of traditional (sand) and alternative materials (calcite, zeolite, and iron filings) can be used as an effective medium for the treatment of nutrient and heavy metal contaminants commonly found in stormwater.For hydrogen-based energy systems development, purified hydrogen (H2) is a basic requirement and it can be achieved by using the H2-selective membranes. For having H2-selective membranes, it is a decent approach to embed the H2-sensitive materials in the polymeric membranes. Palladium (Pd) is one of the widely used materials for hydrogen-selective membranes due to its strong affinity towards H2 absorption. In the present work, we have used Pd nanoparticles in UV-functionalized track-etched polycarbonate (PC) membranes for better selectivity and permeability of H2 gas. In the UV-irradiation process of membranes, the photo-fries mechanism leads to the C-O bond breaking from the carbonate group of PC molecules and as a result, there is a high number of bond breaking. #link# This phenomenon provides the more active sites for the attachment of Pd nanoparticles in comparison with the pristine PC membrane. The gas permeability of these membranes suggests that the selectivity of H2 over nitrogen (N2) and carbon dioxide (CO2) is increased by the addition of uniformly distributed Pd nanoparticles in the functionalized membranes.Different specimens of Mullus surmuletus from the Catania Gulf (Sicily) were sampled and analysed for the quantification of 16 priority polycyclic aromatic hydrocarbons (PAHs) in order to evaluate the distribution of these pollutants and the potential human health risks associated to the consumption of fish. The determined PAHs concentration values ranged from 0.25 to 6.10 ng/g wet weight and the most abundant PAHs detected were lower molecular weight (LMW) compounds with 2 to 3 rings. Relying on the PAHs concentration values, on the consumption data and on the total toxic equivalent (TEQ), the incremental lifetime cancer risk (ILCR) was assessed and its calculated value (2.97 × 10-7) is far below the "maximum acceptable risk level" (ARL), suggesting a low potential carcinogenic risk on consuming M. surmuletus for local population. Even though the study shows a quite low contamination level in M. surmuletus, intensive monitoring programmes are still highly needed in order to provide a better picture of the PAHs distribution in Catania Gulf and of the human health risk linked to fish consumption.Nanostructured mesoporous materials of MCM-41 type were synthesized using a natural, non-toxic, and cheap source of silica from rice husk. Then, this pure silica was modified with several Fe loadings by a wet impregnation method. The chemical and physic properties of MCM-41 solids obtained were similar to those of MCM-41 synthesized from commercial silica by conventional method. Thus, [https://www.selleckchem.com/products/qnz-evp4593.html Selleck QNZ] exhibited good structural regularity preserving the mesoporosity after the metal incorporation. The performance of the Fe/MCM-RHA composites as photo-Fenton heterogeneous catalysts was evaluated for photocatalytic degradation of different endocrine-disrupting chemicals (EDCs), such as herbicides (atrazine), and compounds derived from the plastic industry (bisphenol A) and the pharmaceutical industry (acetaminophen). The major photo-catalytic efficiency obtained (Fe/MCM-RHA(2.5)) is consistent with the highest presence of iron species, which are finely dispersed and stabilized on the silica structure, the isolated Fe3+ ions being the accessible and active sites for the reaction. Finally, a cheaper solid arising from the valorization of residual biomass and with excellent photocatalytic performance for the degradation of EDCs (above 99%, 75%, and 60% for BPA, ATZ, and ACE respectively, in a reaction time of 240 min) was obtained.In this study, the heterotrophic nitrification-aerobic denitrification activity of Pseudomonas aeruginosa (P-1) strain was investigated, and the N transformation pathway was revealed. The highest removal rates of NH4+, NO3-, and NO2- (9.29, 6.12, and 3.72 mg L-1 h-1, respectively) by this strain were higher than those by most reported bacteria and were achieved when the carbon source was glucose, C/N ratio was 15, pH was 8, temperature was 30 °C, and shaking speed was 200 rpm. The removal order and characteristics of three N sources were investigated in Pseudomonas aeruginosa for the first time. The results revealed that P-1 preferentially nitrified NH4+ and only began to denitrify NO2- and NO3- when NH4+ was almost entirely depleted. Isotopic labeling of N sources revealed that P-1 uses both partial and complete nitrification/denitrification pathways that can operate either simultaneously or independently, depending on the availability of different types of N compounds, with N2 as the final gaseous product and virtually no NO2- accumulation. Moreover, the P-1 strain could convert various nitrogen compounds under high salinity (40 g L-1) and high concentrations of Cu2+, Zn2+, Cr6+, Pb2+, and Cd2+ (50 mg L-1). Therefore, P-1 could be used as an alternative of inorganic N-removal bacteria in practical applications.Sanitary landfill is still considered as one of the most significant and least expensive methods of waste disposal. It is essential to consider environmental impacts while selecting a suitable landfill site. Thus, the site selection for sanitary landfill is a complex and time-consuming task needing an assessment of multiple criteria. In the present study, a decision support system (DSS) was prepared for selecting a landfill site in a growing urban region. This study involved two steps of analysis. The first step of analysis involved the application of spatial data to prepare the thematic maps and derive their weight. The second step employed a fuzzy multicriteria decision-making (FMCDM) technique for prioritizing the identified landfill sites. Thus, initially, the analytic hierarchy process (AHP) was used for weighting the selected criteria, while the fuzzy technique for order of preference by similarity to ideal solution (FTOPSIS) was applied for addressing the uncertainty associated with decision-making and prioritizing the most suitable site.