Zobrazení zdroje stránky Desaibowles1016

5 mg/mL of nanoemulsions). [https://www.selleckchem.com/products/asciminib-abl001.html selleck chemicals] Ethanol (400 mM) was introduced to pretreated cells and nontreated cells for 48- or 72-h periods, followed by cell viability assay was carried out. Fluorescence microscopy tests revealed the introduction of the nanoemulsions into THLE-2 cells. The findings show that nanoformulations have promising in vitro hepatoprotective effects on the THLE-2 cell line against ethanol exposure.Triethanolamine (TEA), triisopropanolamine (TIPA), diethanol isopropanolamine (DEIPA) are necessary cement additives, and knowing their contents is needed for quality control and also to understand final properties of the cement. Whether it is the production of grinding aids, technical research and development or application research all involve the detection of grinding aids. This work developed a simple analytical technique for the simultaneous analysis of these alkanolamines in liquid cement grinding aids using high-performance liquid chromatography (HPLC) combined with evaporative light scattering detection (ELSD). HPLC was conducted by an XBridge C18 column (with dimensions 4.6 × 250 mm and 5 µm particles) using methanol and 0.1% trichloroacetic acid as mobile elution phases. The ELSD sprayer and drift tube temperatures were 60 ºC and 90 ºC, respectively. HPLC-ELSD developed in this work demonstrated 1) high sensitivity with limits of detection for the three analytes are 0.15, 0.54, 1.04 µg/mL; 2) good linearity with correlation coefficients equal to 0.997-0.999 over the tested concentration range; 3) excellent repeatability with intra- and interday coefficient of variation (CV) below 2.71% and 4, satisfactory accuracy with recovery in the 95.5%-100.8% range. This novel method is a powerful, time- and costeffective tool for alkanolamine analyses and quality control.In this study, amidoxime-functionalized silica decorated with copper (AFS-Cu) was fabricated and tested for its catalytic application. Fourier transform infrared spectroscopy, scanning electron microscopy, energy dispersive X-ray spectroscopy, and X-ray diffraction were employed to characterize its structure and morphology. The application of AFS-Cu as a catalyst for the catalytic reduction of methylene blue (MB) in aqueous media using NaBH4 as reductant was evaluated. The ability to reuse as well as the effect of catalyst dose and pH of solution on the catalytic activity was investigated. The reduction of MB followed pseudo-first-order kinetics and the rate constant (k) was 0.6224 min-1. AFS-Cu was found to be a highly effective catalyst for MB reduction reaction and can be easily recovered and reused several times with no appreciable loss of catalytic activity.Cadmium dithiocarbamate and cadmium ethyl xanthate complexes were synthesized and characterized by microanalysis, Fourier transform infrared (FT-IR) spectroscopy and thermogravimetric analyses. The complexes were employed as molecular precursors for the fabrication of CdS nanoparticles in hexadecylamine (HDA) and oleylamine (OLA) at a temperature of 250 °C. Spherical and oval shaped particles with sizes ranging from 9.93 ± 1.89 to 16.74 ± 2.78 nm were obtained in OLA while spherical, oval and rod shaped particles with sizes ranging from 9.40 ± 1.65 to 29.90 ± 5.32 nm were obtained in HDA. Optical properties of the nanoparticles showed blue shifts as compared to the bulk CdS, with the OLA capped nanoparticles slightly more blue shifted than the corresponding HDA capped nanoparticles. Results of crystallinity patterns revealed hexagonal phase of CdS.In the present work, essential oil and fatty acids and extracts obtained from aerial parts of Phlomis linearis Boiss. &amp; Bal. were investigated for chemical composition and biological activities. The phytochemical analyses were conducted with gas chromatography-mass spectrometry/flame ionisation detector (GC-MS/FID) and liquid chromatography-mass spectromtetry (LC-MS/MS) techniques. The extracts and essential oil were studied for α-amylase and acetylcholinesterase activities with two different spectrophotometric methods. Antimicrobial activities of the extracts were investigated by microdilution. The extracts were evaluated in vitro for cytotoxic effects against cancer and normal cell lines by MTT assay. The essential oil (EO) contained α-pinene (12.5%) and β-caryophyllene (10.7%) as main compounds. Palmitic (26.5%) and nonadecanoic acids (26.6%) were determined as fatty acids. Phytochemical analysis of the extracts found phenolic acids, phlinosides, verbascoside, and flavonoids. The extracts and essential oil demonstrated poor α-amylase inhibitory activity. The best acetylcholinesterase inhibitory activity was obtained for diethly ether extract of P. linearis (67.2 ± 3.4%) at 10 mg /mL concentration. Ethyl acetate extract found to be effective against Staphlococcus aureus at a minimum inhibitory concentration (MIC) of 156.26 µg/mL. Diethyl ether extract of P. linearis was active on A549 cell lines with an IC50 = 316 ± 4.16 µg/mL when compared with cisplatin IC50 = 24.43 ± 0.14 µg/mL. To the best of our knowledge, the present work is the first comprehensive report on anti-acetylcholinesterase, anti-α-amylase, and antimicrobial activities, as well as cytotoxic effects of P. linearis.In this work, we study the elimination of three bivalent metal ions (Cd2+, Cu2+, and Pb2+) by adsorption onto natural illitic clay (AM) collected from Marrakech region in Morocco. The characterization of the adsorbent was carried out by X-ray fluorescence, Fourier transform infrared spectroscopy and X-ray diffraction. The influence of physicochemical parameters on the clay adsorption capacity for ions Cd2+, Cu2+, and Pb2+, namely the adsorbent dose, the contact time, the initial pH imposed on the aqueous solution, the initial concentration of the metal solution and the temperature, was studied. The adsorption process is evaluated by different kinetic models such as the pseudo-first-order, pseudo-second-order, and Elovich. The adsorption mechanism was determined by the use of adsorption isotherms such as Langmuir, Freundlich, and Temkin models. Experiments have shown that heavy metals adsorption kinetics onto clay follows the same order, the pseudo-second order. The isotherms of adsorption of metal cations by AM clay are satisfactorily described by the Langmuir model and the maximum adsorption capacities obtained from the natural clay, using the Langmuir isotherm model equation, are 5.