Zobrazení zdroje stránky Corcorankamper6473

The electrocatalytic CO2 reduction reaction (CO2RR) decreases the amount of greenhouse gas in the atmosphere while enabling a closed carbon cycle. Herein, iron oleate was used as a precursor to produce oleic acid-coated triiron tetraoxide nanoparticles (Fe3O4@OA NPs) by pyrolysis, which was then assembled with reduced graphene oxide (rGO) and doped with dicyandiamide as a nitrogen source to obtain nitrogen-doped iron carbide nanoparticles assembled on rGO (N-Fe3C/rGO NPs). The catalyst prepared by nitrogen doping at 800 °C with an Fe3O4@OA NPs to rGO weight ratio of 201 showed good activity and stability for the CO2RR. At -0.3 to -0.4 V, the H2/CO ratio of the product from the catalyzed CO2RR was close to 2; thus, the product can be used for Fischer-Tropsch synthesis. The results of a series of experiments and X-ray photoelectron spectroscopy analysis showed that the synergy between the CN and FeN groups in the catalyst can promote the reduction of CO2 to CO. This work demonstrates a facile method for improving the catalytic reduction of CO2.Biochar derived from the pyrolysis of pine tannin is a green and available by-product of oil manufacturing that presents interesting features after having been activated by KOH at 650 °C. Different weight ratios of KOH to biochar were used and the resulting activated carbons (ACs) presented highly developed specific surface areas of up to 2190 m2 g-1, well-connected porosity and high oxygen content, leading to enhanced electrochemical performance when used as electrochemical capacitor electrodes in a 1 M H2SO4 aqueous electrolyte. Galvanostatic charge/discharge experiments evidenced that the best material achieved a maximum electrode capacitance of up to 232 F g-1 (at 0.5 A g-1) with a capacitance retention of 70% at 10 A g-1 using commercial mass loadings (i.e., approx. 10 mg cm-2). In addition, long cycling stability with a residual capacitance of 92 to 94% after 10,000 cycles at 5 A g-1 was achieved. These results prove that ACs derived from pine tannin biochars have great potential for their commercial use as electrochemical energy storage devices.To optimize the electrochemical performance of Ni-rich cathode materials, the 0.005 mol of Mg2+ and 0.005 mol of Ti4+co-doping LiNi0.83Co0.11Mn0.06O2 composite powders, labeled as NCM-11, are successfully prepared by being calcinated at 750 °C for 15 h following by an appropriate post-treatment, which are confirmed by XRD, EDS and XPS. The results suggest that NCM-11 presents a well-ordered layered structure with a low Li+/Ni2+ mixing degree of 1.46% and Mg2+ and Ti4+ ions are uniformly distributed across the lattice. [https://www.selleckchem.com/products/OSI-906.html check details] The cell assembled with NCM-11 can deliver an initial discharge specific capacity of 194.2 mAh g-1 and retain a discharge specific capacity of 163.0 mAh g-1 after 100cycles at 2.0C at 25 °C. Furthermore, it still maintains a discharge specific capacity of 166.7 mAh g-1 after 100cycles at 2.0C at 60 °C. More importantly, it also exhibits a higher discharge specific capacity of about 150.7 mAh g-1 even at 5.0C. Those superior electrochemical performance can be mainly ascribed to the synergistic effect of Mg2+ and Ti4+co-doping, in which Mg2+ ions can occupy the Li+ layer to act as pillar ions and Ti4+ ions can occupy the transition metal ions layer to enlarge the interplane spacing. Thus, the heterovalent cations co-doping strategy can be considered as a simple and practical method to improve the electrochemical performance of Ni-rich layered cathode materials for lithium-ion batteries.The indoor low-concentration formaldehyde (HCHO) removal in cobalt-based catalysts is still a "hot potato". In this work, metal-organic-frameworks (MOF)-derived and Zinc (Zn)-modulated new cobalt nanoparticles catalyst (CZ-Co@NC-800) was designed and prepared. The CZ-Co@NC-800 performed outstanding elimination activities for ~1 ppm HCHO at 25 °C. In the static test condition, it achieves complete HCHO removal in 3 h at a relative humidity (RH) of ~55%. Moreover, 90.18% HCHO removal ratio is held after five recycle tests. In the dynamic test condition, it remains the characteristic to eliminate around 95.89% of HCHO within 8 h under an RH of ~55% and a gas hourly space velocity (GHSV) of ~150,000 mL·h-1g-1. Such advanced results should be ascribed to large specific surface area bringing about more cobalt active sites; and it is also because residual Zn metal affects the electronic structure of CZ-Co@NC-800 and enhance the surface charge transfer rate, thus the activation and dissociation ability of oxygen is promoted. Besides, a short HCHO reaction path over CZ-Co@NC-800 which was clarified by the In situ DRIFTs is also a reason for excellent catalytic performance. This work represents a crucial addition to expand the family of cobalt-based catalysts for indoor HCHO elimination.Temperature is a key indicator of infection and disease, however, it is difficult to measure at a cellular level. Nanoparticles are applied to measure the cellular temperature, and enhancement of the stability and reliability of the signal and higher biocompatibility are demanded. We have developed fluorescent polymeric nanoparticles loaded with temperature-sensitive units (as rhodamine B) and internal reference units (as coumarin) for imaging and ratiometric sensing of the cellular temperature in the physiological range. The fluorescence signal of the nanoparticles was stable in the bio-environment and the ratiometric sensing strategy could overcome the concentration effect of nanoparticles. The nanoparticles were endocytosed by cells and partially presented in mitochondria. The fluorescence intensity ratio of rhodamine B and coumarin using nanoparticles showed good linear correlations in buffer solutions, cell suspensions, and imaging of living cells. Using the fluorescent polymeric nanoparticles, the change of temperature of cells during influenza virus infection could be individually monitored.Nitric oxide (NO) continuously generated by healthy endothelium prevents platelet activation and maintains vascular homeostasis. However, when artificial surfaces, like of extracorporeal membrane oxygenator comes in contact with blood, protein adsorption and thereby platelet activation takes place, which eventually leads to thrombus formation. To overcome this, we present an antifouling microgel coating mimicking the function of enzyme glutathione peroxidase to endogenously generate NO in the blood plasma from endogenous NO-donors and maintain a physiological NO flux. Microgels are synthesized by copolymerization of highly hydrophilic N-(2-hydroxypropyl)methacrylamide (HPMA) and glycidyl methacrylate (GMA) with diselenide crosslinks. For immobilization of the microgels on hydrophobic poly(4-methylpentene) (TPX) membranes bioengineered amphiphilic anchor peptides with free thiols are used. The anchor peptide attaches to the TPX membranes by hydrophobic interactions while the free thiols are presented for crosslinking with the microgels.