Zobrazení zdroje stránky Collierchase1438

6 times compared with COP.The preparation of titanium dioxide (TiO2) supported on a glass plate by heat attachment method is presented. With the use of response surface methodology based on a central composite design we investigated the influence of the experiment parameters of the TiO2 deposition (temperature of calcination (T), time of calcination (ts) and the concentration of TiO2 ((TiO2))) on photocatalytic activity of the semiconductor for the degradation of a model pollutant methylene blue. [https://www.selleckchem.com/products/sgi-110.html Guadecitabine] The analysis of variance results showed that the selected quadratic model with interaction (R2 = 0.9802) was statistically significant. The experimental results showed that the degradation quantity of methylene blue increased when the ts value increased and T decreased. We have evaluated the photocatalytic activity of this supported catalyst (TiO2-GP) with a laboratory reactor under natural condition; the maximum removal (96.03%) was obtained at ts = 331 min, T = 559 °C and (TiO2) = 2.38 g/l. The method of desirability function was used to obtain the best combination of factor settings for achieving the maximum of degradation quantity ((TiO2) = 2.6 (g/l), T = 600 (°C) and ts = 240 (min)). The additional tests on the catalyst plates confirmed that the deposits keep their catalytic activity for several cycles of use.Due to the entrance of pollutants in different branches of the river network, it is essential to study contaminant transport at the river confluences. In the present study, it was attempted to investigate the conservative pollution transport at channel confluence by operating a series of experiments in the laboratory flume. In the designed laboratory model, two branches, with different widths of 45, 25 cm, were intersected and a channel confluence was created. Five entrance discharges and three initial contaminant concentrations, introduced using a linear feeder, were chosen as experimental variables. Conservative tracer of sodium chloride solution was used, and the electrical conductivities were measured at eight locations of the main channel and upstream branches with 2 seconds interval. Junction zone was assumed as a control volume, and by applying mass equilibrium to it, a new mathematical model was extracted. It was observed that there is concentration fluctuation in the falling limbs of the experimental breakthrough curves of the junction zone; however, it was diminished by downstream motion. Moreover, the observed pollution graphs had double peak points which changed to a single point with an increase of distance from the confluence position. Operation of the presented model was investigated by variation of its parameters. It was found that the contaminant residence time parameters of the confluence zone have the most significant influence in the simulation of the analytical model. Additionally, it was observed that the values of Gaussian distribution of the upstream branches could displace the position of pulses of resultant breakthrough curves or can overlap them. Moreover, the model performance was examined using statistical goodness of fit parameters like Nash-Sutcliffe, R2, and mean absolute error (MAE). Their values were calculated as 0.88, 0.91, 66.88 (ppm), respectively.Sludge dewatering is an important step for wastewater treatment. Composite degradable flocculant (CDF) was prepared by cationic polyacrylamide (PAM) grafting onto modified starch with a novel initiator, and characterized by Fourier transform infrared spectroscopy. The microstructure of flocculated sludge was characterized by scanning electron microscopy. The study investigated the properties of CDF compared to PAM, which showed that the prepared CDF exhibited a highly effective flocculation on sludge dewatering, a higher transmittance and chemical oxygen demand removal rate, and a lower value of effluent ammonia nitrogen and total phosphorus. The fermentation process was also analyzed by testing the performance of dewatered sludge (temperature, pH, ammonia nitrogen, E4/E6 (humic acid absorbance at 465 nm (E4) and 665 nm (E6))). The dehydrated sludge with CDF could be easily compressed into cakes by belt-filter for easy transportation and storage. With the continuous addition of CDF and PAM, the corresponding index of capillary suction time (CST) increased. Moreover, the total value of CST with CDF was low, showing a good dewaterability. In addition, the sludge index of pumping time and moisture content with CDF were low in contrast with PAM. Fermentation experiments demonstrated that sludge with CDF had a comparatively high temperature and low value of E4/E6. Such novel CDF shows enormous potential in wastewater treatment and sludge fermentation.In the process of oilfield wastewater treatment, the polymer-modified materials with special wettability have been recognized by many scholars for their high filtration efficiency and good adsorption effect. In this paper, we used micro-computed tomography scanning and infrared scanning technology to further explore the internal structure and surface chemistry of polyurethane modified materials and then established an experimental platform for the filtration performance of polyurethane modified materials. The change of suspended solids concentration and oil content in the sewage was tested under different filtration rate, filter layer thickness, and water quality. The results showed that the porosity of the filter material and the oil-absorbing material was 65.85% and 56.03% respectively, and the difference in the number of oxygen-containing functional groups on the surface of these two materials indicated different adsorption force for sewage impurities. And the polyurethane modified materials had good filtration performance. Through these experiments, we demonstrated that the quality of water filtrated by the polyurethane modified materials met the requirements of the 'National Comprehensive Wastewater Discharge Standards', and the filtration efficiency for suspended particles and oils in oily sewage was higher than 80%. These materials have important practical significance for the harmless treatment of oily sewage.