Zobrazení zdroje stránky Clevelandantonsen0071

29 × 10-4 S·cm-1 at 363 K and 98% relative humidity (RH), respectively.As part of local sustainability efforts, biodiesel was synthesized via transesterification using a deep eutectic solvent (DES) without further washing from on-campus, dining facility waste cooking oil and grease. Before moving forward with repurposing used DES as a solvent in chemistry teaching labs, we determined the suitability of the biodiesel as an alternative fuel blended with diesel to power campus utility vehicles. Biodiesel components were characterized by gas chromatography-mass spectrometry (GC-MS), Fourier transform infrared spectroscopy (FTIR), nuclear magnetic resonance spectroscopy (1H NMR), viscometer, differential scanning calorimetry (DSC), and evolved gas analysis during pyrolysis with a thermogravimetric analyzer coupled with FTIR (TGA-FTIR). The four major components of fatty acid methyl esters (FAMEs) in the biodiesel were methyl oleate, methyl linoleate, methyl palmitate, and methyl stearate. Kinematic viscosity over typical temperature ranges was within optimal values recommended by the American Biodiesel Standard (ASTM D6751), with a 3070 biodiesel/diesel blend experimental viscosity of 3.43 cSt at 40 °C and a calculated viscosity of 10.13 cSt at 0 °C. The pure biodiesel's cold-temperature onset of crystal formation is -10.1 °C versus -16.4 °C for a 3070 biodiesel/diesel blend. Pyrolysis indicates good thermal stability, however, with an increased CO2 evolution in the blended fuel at higher temperatures as compared to that in the pure biodiesel and the pure diesel. Combustion gas analysis indicates virtually complete combustion of the blended fuel to CO2 and H2O with only trace amounts of CO. Overall results indicate that the biodiesel synthesized using DES is a suitable fuel for campus utility vehicles in the local moderate temperature climate and affords increased local sustainability by using used DES repurposed in our chemistry teaching labs.Transient receptor potential canonical channel 6 (TRPC6) has been implicated in many kinds of malignant tumors, but very few potent TRPC6 antagonists are available. In this study, a benzothiazole amide derivative 1a was discovered as a TRPC6 activator in a cell-based high-throughput screening. A series of benzothiazole amide derivatives were designed and synthesized. The docking analyses indicated that the conformations of the compounds bound to TRPC6 determined the agonistic or antagonistic activity of the compounds against TRPC6, and compound 1s with the tetrahydronaphthalene group in R1 position fit well into the binding pocket of the antagonist-bound conformation of TRPC6. Compound 1s showed an inhibitory potency order of TRPC3 (IC50 3.3 ± 0.13 μM) ≈ C6 (IC50 4.2 ± 0.1 μM) &gt; C7 with good anti-gastric cancer activity in a micromolecular range against AGS and MKN-45, respectively. In addition, 1s inhibited the invasion and migration of MKN-45 cells in vitro.Although gold nanorods capped with hexadecyltrimethylammonium bromide (CTAB) have been prepared through the seed-mediated method for their use in diagnostics and therapeutics, the toxicity of AuNRs@CTAB limits their practical applications in the biomedical field. In this work, the synthesis and tuning of gold nanorods at very low concentrations of CTAB (as low as 0.008 M) was successfully achieved by using the seed-mediated method. Furthermore, we managed to optimize the growth conditions by changing the amount of seeds, AgNO3, and/or HCl. At low CTAB concentrations, gold nanorods with tunable size and aspect ratio, high monodispersity, and high purity were obtained and studied by UV-vis spectroscopy, transmission electron microscopy, and Mie-Gans theoretical calculations. This work revealed a method of nanoparticle growth that may be extended to synthesize other nanomaterials such as Ag, Cu, Pd, and Pt at such low CTAB concentrations.Insomnia is an anabatic epidemiology, while the mechanism is extremely complicated; it remains one of the major scientific challenges in life sciences. Because of the advantage of having a similar genetic background and circadian rhythm as those of humans, the Drosophila melanogaster model organism is hugely popular in sleep-related drug screening studies. Seven-day-old virgin D. melanogaster was used to establish the sleep deprivation model by repeated light stimulation at night. Using PySolo activity monitoring system and Drosophila activity as indices, the effective fractions of Zhi-Zi-Hou-Po decoction (ZZHPD) for insomnia were screened; the content of monoamine neurotransmitters dopamine (DA), 5-hydroxyindole-3-acetic acid (5-HIAA), Homovanillic acid (HVA), and 5-hydroxytryptamine (5-HT) in the brain of D. melanogaster were determined by high-performance liquid chromatography-electro-chemical detection. The herb-compound-target-disease target network were further constructed through network pharmacology te molecular docking results clarified that naringenin and apigenin have an intimate relationship with GABAA receptor, histamine H1, orexin receptor type 2, and interleukin-6. The mechanism of relieving insomnia is the result of the interaction of multi-components, multi-targets, and multi-pathways, which provides a certain theoretical basis for the treatment of insomnia and related diseases as well as clinical research.The present work is focused on fabrication of reduced graphene oxide/iron(II/III) oxide/polyaniline (RGO/Fe3O4/PANI) ternary composite by a hydrothermal method, its characterization, and application in the development of a high microwave absorbing shielding material. The RGO/Fe3O4/PANI composite showed dramatic enhancement of dielectric loss and magnetic loss compared to Fe3O4/PANI and RGO/Fe3O4 binary composites. This is ascribed to the embedment of more heterostructure phases. As a result, RGO/Fe3O4/PANI showed remarkably high SET (∼28 dB) through the absorption dominant mechanism. [https://www.selleckchem.com/products/fosbretabulin-disodium-combretastatin-a-4-phosphate-disodium-ca4p-disodium.html Fosbretabulin] Our findings also showed maximum R L of Fe3O4/PANI, RGO/Fe3O4, and RGO/Fe3O4/PANI in the range of 2-8 GHz corresponding to -25 to -35, -40 to -46, and approximately -64 dB, respectively. This is in all probability due to the good impedance matching between permittivity/permeability and dielectric/magnetic losses.Amphoteric statistical equivalent copolymers (P(2VP/NaSS) n ) composed of 2-vinylpyridine (2VP) and anionic sodium p-styrenesulfonate (NaSS) were prepared via reversible addition-fragmentation chain transfer polymerization. The degrees of polymerization (n) were 19 and 95. The monomer reactivity ratio, time conversion profile, and 1H nuclear magnetic resonance diffusion-ordered spectra suggested that the copolymerization of 2VP and NaSS provided statistical or near to random copolymers. P(2VP/NaSS) n exhibited an upper critical solution temperature (UCST) in acidic aqueous solutions on the basis of the charge interactions between the protonated cationic 2VP and anionic NaSS units. With an increase in pH value, the interaction was weakened because of the deprotonation of the 2VP units, thus reducing the UCST. At high [NaCl], the electrostatic interactions among the polymers were weakened because of the screening effect, and again, the UCST was reduced. With an increase in polymer concentration, the intra- and interpolymer interactions increased because of some entanglement, and the UCST consequently increased. Electrostatic interactions among the polymer chains with high molecular weight occurred easier than those among the low-molecular-weight polymer chains, which increased the UCST. The UCST also increased when deuterium oxide was used instead of hydrogen oxide, which was due to the isotopic effect. Hence, the UCST of P(2VP/NaSS) n can be adjusted according to the desired application.Soybean oil deodorizer distillate (SODD) is well recognized as a good source of both biodiesel and high-value bioactive compounds of tocopherols, squalene, and phytosterols. To achieve a one-step synthesis of biodiesel and recovery of bioactive compounds from SODD, four commercial immobilized enzymes (Novozym 435, Lipozyme TLIM, Lipozyme RMIM, and Lipozyme RM) and one self-prepared immobilized lipase MAS1-H108A were compared. The results showed that immobilized lipase MAS1-H108A due to the better methanol tolerance and higher catalytic activity gave the highest biodiesel yield of 97.08% under the optimized conditions molar ratio of 12 (oil/methanol), temperature of 35 °C, and enzyme loading of 35 U/g SODD, even after 10 persistent cycles without significant decrease of activity. Simultaneously, there was no loss of tocopherols and squalene in SODD during the enzymatic reaction. Pure biodiesel (characterized by fourier transform infrared (FT-IR) and nuclear magnetic resonance (NMR)) and a high concentration of bioactive compounds could be successfully separated by molecular distillation at 100 °C. In a word, this work provides an interesting idea to achieve environmentally friendly treatment of SODD by combining an enzymatic process and molecular distillation, and it is suitable for industrial production.In this study, using molybdenum sulfide (MoS2) as laser-sensitive particles and poly(propylene) (PP) as the matrix resin, laser-markable PP/MoS2 composite materials with different MoS2 contents ranging from 0.005 to 0.2% were prepared by melt-blending. A comprehensive analysis of the laser marking performance of PP/MoS2 composites was carried out by controlling the content of laser additives, laser current intensity, and the scanning speed of laser marking. The color difference test shows that the best laser marking performance of the composite can be obtained at the MoS2 content of 0.02 wt %. The surface morphology of the PP/MoS2 composite material was observed after laser marking using a metallographic microscope, an optical microscope, and a scanning electron microscope (SEM). During the laser marking process, the laser energy was absorbed and converted into heat energy to cause high-temperature melting, pyrolysis, and carbonization of PP on the surface of the PP/MoS2 composite material. The black marking from carbonized materials was formed in contrast to the white matrix. Using X-ray diffraction (XRD), Fourier transform infrared (FT-IR) spectroscopy, and Raman spectroscopy, the composite materials before and after laser marking were tested and characterized. The PP/MoS2 composite material was pyrolyzed to form amorphous carbonized materials. The effect of the laser-sensitive MoS2 additive on the mechanical properties of composite materials was investigated. The results show that the PP/MoS2 composite has the best laser marking property when the MoS2 loading content is 0.02 wt %, the laser marking current intensity is 11 A, and the laser marking speed is 800 mm/s, leading to a clear and high-contrast marking pattern.Gelatin methacryloyl (GelMA) hydrogel has adjustable physicochemical properties and a three-dimensional network structure for cell growth and hence a hot issue in the field of tissue engineering. However, its poor mechanical properties limit the application in the scaffold, especially as a bone scaffold. To date, many research studies have been carried out by adding some additives into GelMA to construct GelMA-based composites to improve the mechanical properties. However, there is a controversy as to whether the additives can improve the mechanical properties of GelMA. Herein, meta-analysis was used to evaluate the influence of the additives on the mechanical properties of GelMA-based composites, which can provide reference for the further enhancement of mechanical properties of GelMA. In this study, meta-analysis was adopted to investigate the influence of additives on the mechanical properties of GelMA composites; composites with different concentrations of GelMA, that is, ≥10% (w/v), 5-10% (w/v), and ≤5% (w/v) were found in 23 literatures and heterogeneity could be found among these references.