Zobrazení zdroje stránky Belllowry1610

The tribological properties of Ni3Si alloy were studied at high temperatures. The effect of the addition of Ti was also analyzed. The surface composition was analyzed by Raman spectroscopy. [https://www.selleckchem.com/products/vbit-4.html learn more] The results showed that the friction coefficient decreased with the increasing temperature, and the wear rate changed slightly from 25 to 400 °C. However, the wear resistance of the alloys decreased sharply at 600 °C, and this was due to the decrease of the high-temperature strength and the severe oxidation of the alloys. Although the oxidation resistance of Ni3Si alloy decreased with Ti addition, the tribological property was improved by the addition of Ti. The Ni3Si alloy with 5% Ti addition had the best wear resistance at high temperatures as compared to pure Ni3Si alloy and with 10% Ti addition, and the wear rates of the alloys were in the order of magnitude of 10-5 mm3/Nm. With the increase of temperature, the wear mechanism of pure Ni3Si alloy transformed from abrasive wear to oxidation wear. As the Ti content increased, the wear mechanisms of the alloys changed from abrasive wear to fatigue wear at low temperature, and oxidation wear and fatigue wear at high temperature.Sea foam harbors a diverse range of fungal spores with biological and ecological relevance in marine environments. Fungi are known as the producers of secondary metabolites that are used in health and agricultural sectors, however the potentials of sea foam-derived fungi have remained unexplored. In this study, organic extracts of six foam-derived fungal isolates belonging to the genera Penicillium, Cladosporium, Emericellopsis and Plectosphaerella were investigated for their antimicrobial activity against plant and human pathogens and anticancer activity. In parallel, an untargeted metabolomics study using UPLC-QToF-MS/MS-based molecular networking (MN) was performed to unlock their chemical inventory. Penicillium strains were identified as the most prolific producers of compounds with an average of 165 parent ions per strain. In total, 49 known mycotoxins and functional metabolites were annotated to specific and ubiquitous parent ions, revealing considerable chemical diversity. This allowed the identification of putative new derivatives, such as a new analog of the antimicrobial tetrapeptide, fungisporin. Regarding bioactivity, the Penicillium sp. isolate 31.68F1B showed a strong and broad-spectrum activity against seven plant and human pathogens, with the phytopathogen Magnaporthe oryzae and the human pathogen Candida albicans being the most susceptible (IC50 values 2.2 and 6.3 µg/mL, respectively). This is the first study mining the metabolome of the sea foam-derived fungi by MS/MS-based molecular networking, and assessing their biological activities against phytopathogens.Computer-aided design/computer-aided manufacturing (CAD/CAM) technology was developed to ensure the sufficient strength of tooth restorations, to improve esthetic restorations with a natural appearance and to make the techniques easier, faster and more accurate. In the view of the limited research on the surface treatments of the CAD/CAM materials and the need to evaluate the ideal surface characteristics of a material to achieve the best adhesion to tooth tissues, this study aimed to investigate the surface roughness and morphology of four different CAD/CAM materials using four different surface treatments. The CAD/CAM materials used in this study were three composites (Shofu Block HC, Lava Ultimate and Brilliant Crios) and a hybrid ceramic (Enamic). The surface of the specimens of each material received one of the following treatments no surface treatment, sandblasting with 29 μm Al2O3 particles, 9% hydrofluoric acid etching and silane application, and the tribochemical method using CoJet System. Surface roughness was evaluated using optical profilometry, and surface morphology was observed by means of scanning electron microscopy. All surface treatments resulted in higher surface roughness values compared to the control group. Different treatments affected the surface properties of the materials, presumably due to discrepancies in their composition and structure.Impaired physical performance is common in patients on hemodialysis (HD) and is associated with poor prognosis. A patient relevant marker of adequacy of dialysis is lacking. Previous studies evaluated uremic toxicity by assessing the impact of different uremic toxins separately. However, such an approach is most likely not reflective of true uremic toxicity. Therefore, this cross-sectional study aimed to examine if the uremic syndrome, estimated as one composite of different uremic toxins (facilitated by ridge regression method) to reflect the kinetic behavior during dialysis, is associated with physical performance in patients on HD. Levels of p-cresyl glucuronide and sulfate, indole-acetic acid, indoxyl sulfate, uric acid, hippuric acid, and 3-carboxy-4-methyl-5-propyl-2-furanpropionic acid were assessed and associated by ridge regression to muscle strength, functional exercise capacity, and measures of balance and coordination. 75 HD patients were included (mean age 68 years, 57% male). The composite of different uremic toxins (i.e., uremic load) explained 22% of the variance in handgrip strength. Although there was an association between full body muscle strength and the composite uremic load independent of nutritional status, age and gender, the predictive power of composite uremic load for muscle weakness is limited. Single uremic toxins as well as composite uremic load were not associated with exercise capacity, coordination, and balance, indicating that the degree of uremia does not predict physical performance in patients on HD.Manganese porphyrins (MnPs), MnTE-2-PyP5+, MnTnHex-2-PyP5+ and MnTnBuOE-2-PyP5+, are superoxide dismutase (SOD) mimetics and form a redox cycle between O2 and reductants, including ascorbic acid, ultimately producing hydrogen peroxide (H2O2). We previously found that MnPs oxidize hydrogen sulfide (H2S) to polysulfides (PS; H2Sn, n = 2-6) in buffer. Here, we examine the effects of MnPs for 24 h on H2S metabolism and PS production in HEK293, A549, HT29 and bone marrow derived stem cells (BMDSC) using H2S (AzMC, MeRho-AZ) and PS (SSP4) fluorophores. All MnPs decreased intracellular H2S production and increased intracellular PS. H2S metabolism and PS production were unaffected by cellular O2 (5% versus 21% O2), H2O2 or ascorbic acid. We observed with confocal microscopy that mitochondria are a major site of H2S production in HEK293 cells and that MnPs decrease mitochondrial H2S production and increase PS in what appeared to be nucleoli and cytosolic fibrillary elements. This supports a role for MnPs in the metabolism of H2S to PS, the latter serving as both short- and long-term antioxidants, and suggests that some of the biological effects of MnPs may be attributable to sulfur metabolism.